Merge branch 'micrel-lan8814-remove-latencies'

Horatiu Vultur says:

====================
net: phy: micrel: Remove latencies support lan8814

Remove the latencies support both from the PHY driver and from the DT.
The IP already has some default latencies values which can be used to get
decent results. It has the following values(defined in ns):
rx-1000mbit: 429
tx-1000mbit: 201
rx-100mbit:  2346
tx-100mbit:  705

v0->v1:
- fix the split of the patches, there was a compiling error between patch 2 and
  patch 3.

---
But to get better results the following values needs to be set:
rx-1000mbit: 459
tx-1000mbit: 171
rx-100mbit:  1706
tx-100mbit:  1345

We are proposing to use ethtool to set these latencies, the RFC can be found
here[1]
====================

Signed-off-by: David S. Miller <davem@davemloft.net>

2 files changed, 2 insertions, 121 deletions

diff --git a/Documentation/devicetree/bindings/net/micrel.txt b/Documentation/devicetree/bindings/net/micrel.txt
index c5ab62c39133..8d157f0295a5 100644
--- a/Documentation/devicetree/bindings/net/micrel.txt
+++ b/Documentation/devicetree/bindings/net/micrel.txt
@@ -45,20 +45,3 @@ Optional properties:
 
 	In fiber mode, auto-negotiation is disabled and the PHY can only work in
 	100base-fx (full and half duplex) modes.
-
- - lan8814,ignore-ts: If present the PHY will not support timestamping.
-
-	This option acts as check whether Timestamping is supported by
-	hardware or not. LAN8814 phy support hardware tmestamping.
-
- - lan8814,latency_rx_10: Configures Latency value of phy in ingress at 10 Mbps.
-
- - lan8814,latency_tx_10: Configures Latency value of phy in egress at 10 Mbps.
-
- - lan8814,latency_rx_100: Configures Latency value of phy in ingress at 100 Mbps.
-
- - lan8814,latency_tx_100: Configures Latency value of phy in egress at 100 Mbps.
-
- - lan8814,latency_rx_1000: Configures Latency value of phy in ingress at 1000 Mbps.
-
- - lan8814,latency_tx_1000: Configures Latency value of phy in egress at 1000 Mbps.
diff --git a/drivers/net/phy/micrel.c b/drivers/net/phy/micrel.c
index 19b11e896460..fc53b71dc872 100644
--- a/drivers/net/phy/micrel.c
+++ b/drivers/net/phy/micrel.c
@@ -99,15 +99,6 @@
 #define PTP_TIMESTAMP_EN_PDREQ_			BIT(2)
 #define PTP_TIMESTAMP_EN_PDRES_			BIT(3)
 
-#define PTP_RX_LATENCY_1000			0x0224
-#define PTP_TX_LATENCY_1000			0x0225
-
-#define PTP_RX_LATENCY_100			0x0222
-#define PTP_TX_LATENCY_100			0x0223
-
-#define PTP_RX_LATENCY_10			0x0220
-#define PTP_TX_LATENCY_10			0x0221
-
 #define PTP_TX_PARSE_L2_ADDR_EN			0x0284
 #define PTP_RX_PARSE_L2_ADDR_EN			0x0244
 
@@ -268,15 +259,6 @@ struct lan8814_ptp_rx_ts {
 	u16 seq_id;
 };
 
-struct kszphy_latencies {
-	u16 rx_10;
-	u16 tx_10;
-	u16 rx_100;
-	u16 tx_100;
-	u16 rx_1000;
-	u16 tx_1000;
-};
-
 struct kszphy_ptp_priv {
 	struct mii_timestamper mii_ts;
 	struct phy_device *phydev;
@@ -296,7 +278,6 @@ struct kszphy_ptp_priv {
 
 struct kszphy_priv {
 	struct kszphy_ptp_priv ptp_priv;
-	struct kszphy_latencies latencies;
 	const struct kszphy_type *type;
 	int led_mode;
 	bool rmii_ref_clk_sel;
@@ -304,14 +285,6 @@ struct kszphy_priv {
 	u64 stats[ARRAY_SIZE(kszphy_hw_stats)];
 };
 
-static struct kszphy_latencies lan8814_latencies = {
-	.rx_10		= 0x22AA,
-	.tx_10		= 0x2E4A,
-	.rx_100		= 0x092A,
-	.tx_100		= 0x02C1,
-	.rx_1000	= 0x01AD,
-	.tx_1000	= 0x00C9,
-};
 static const struct kszphy_type ksz8021_type = {
 	.led_mode_reg		= MII_KSZPHY_CTRL_2,
 	.has_broadcast_disable	= true,
@@ -2618,55 +2591,6 @@ static int lan8814_ptp_probe_once(struct phy_device *phydev)
 	return 0;
 }
 
-static int lan8814_read_status(struct phy_device *phydev)
-{
-	struct kszphy_priv *priv = phydev->priv;
-	struct kszphy_latencies *latencies = &priv->latencies;
-	int err;
-	int regval;
-
-	err = genphy_read_status(phydev);
-	if (err)
-		return err;
-
-	switch (phydev->speed) {
-	case SPEED_1000:
-		lanphy_write_page_reg(phydev, 5, PTP_RX_LATENCY_1000,
-				      latencies->rx_1000);
-		lanphy_write_page_reg(phydev, 5, PTP_TX_LATENCY_1000,
-				      latencies->tx_1000);
-		break;
-	case SPEED_100:
-		lanphy_write_page_reg(phydev, 5, PTP_RX_LATENCY_100,
-				      latencies->rx_100);
-		lanphy_write_page_reg(phydev, 5, PTP_TX_LATENCY_100,
-				      latencies->tx_100);
-		break;
-	case SPEED_10:
-		lanphy_write_page_reg(phydev, 5, PTP_RX_LATENCY_10,
-				      latencies->rx_10);
-		lanphy_write_page_reg(phydev, 5, PTP_TX_LATENCY_10,
-				      latencies->tx_10);
-		break;
-	default:
-		break;
-	}
-
-	/* Make sure the PHY is not broken. Read idle error count,
-	 * and reset the PHY if it is maxed out.
-	 */
-	regval = phy_read(phydev, MII_STAT1000);
-	if ((regval & 0xFF) == 0xFF) {
-		phy_init_hw(phydev);
-		phydev->link = 0;
-		if (phydev->drv->config_intr && phy_interrupt_is_valid(phydev))
-			phydev->drv->config_intr(phydev);
-		return genphy_config_aneg(phydev);
-	}
-
-	return 0;
-}
-
 static int lan8814_config_init(struct phy_device *phydev)
 {
 	int val;
@@ -2690,30 +2614,8 @@ static int lan8814_config_init(struct phy_device *phydev)
 	return 0;
 }
 
-static void lan8814_parse_latency(struct phy_device *phydev)
-{
-	const struct device_node *np = phydev->mdio.dev.of_node;
-	struct kszphy_priv *priv = phydev->priv;
-	struct kszphy_latencies *latency = &priv->latencies;
-	u32 val;
-
-	if (!of_property_read_u32(np, "lan8814,latency_rx_10", &val))
-		latency->rx_10 = val;
-	if (!of_property_read_u32(np, "lan8814,latency_tx_10", &val))
-		latency->tx_10 = val;
-	if (!of_property_read_u32(np, "lan8814,latency_rx_100", &val))
-		latency->rx_100 = val;
-	if (!of_property_read_u32(np, "lan8814,latency_tx_100", &val))
-		latency->tx_100 = val;
-	if (!of_property_read_u32(np, "lan8814,latency_rx_1000", &val))
-		latency->rx_1000 = val;
-	if (!of_property_read_u32(np, "lan8814,latency_tx_1000", &val))
-		latency->tx_1000 = val;
-}
-
 static int lan8814_probe(struct phy_device *phydev)
 {
-	const struct device_node *np = phydev->mdio.dev.of_node;
 	struct kszphy_priv *priv;
 	u16 addr;
 	int err;
@@ -2724,13 +2626,10 @@ static int lan8814_probe(struct phy_device *phydev)
 
 	priv->led_mode = -1;
 
-	priv->latencies = lan8814_latencies;
-
 	phydev->priv = priv;
 
 	if (!IS_ENABLED(CONFIG_PTP_1588_CLOCK) ||
-	    !IS_ENABLED(CONFIG_NETWORK_PHY_TIMESTAMPING) ||
-	    of_property_read_bool(np, "lan8814,ignore-ts"))
+	    !IS_ENABLED(CONFIG_NETWORK_PHY_TIMESTAMPING))
 		return 0;
 
 	/* Strap-in value for PHY address, below register read gives starting
@@ -2746,7 +2645,6 @@ static int lan8814_probe(struct phy_device *phydev)
 			return err;
 	}
 
-	lan8814_parse_latency(phydev);
 	lan8814_ptp_init(phydev);
 
 	return 0;
@@ -2928,7 +2826,7 @@ static struct phy_driver ksphy_driver[] = {
 	.config_init	= lan8814_config_init,
 	.probe		= lan8814_probe,
 	.soft_reset	= genphy_soft_reset,
-	.read_status	= lan8814_read_status,
+	.read_status	= ksz9031_read_status,
 	.get_sset_count	= kszphy_get_sset_count,
 	.get_strings	= kszphy_get_strings,
 	.get_stats	= kszphy_get_stats,