Merge tag 'spi-fix-v6.10-rc4' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi

Pull spi fixes from Mark Brown:
 "A number of fixes that have built up for SPI, a bunch of driver
  specific ones including an unfortunate revert of an optimisation for
  the i.MX driver which was causing issues with some configurations,
  plus a couple of core fixes for the rarely used octal mode and for a
  bad interaction between multi-CS support and target mode"

* tag 'spi-fix-v6.10-rc4' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi:
  spi: spi-imx: imx51: revert burst length calculation back to bits_per_word
  spi: Fix SPI slave probe failure
  spi: Fix OCTAL mode support
  spi: stm32: qspi: Clamp stm32_qspi_get_mode() output to CCR_BUSWIDTH_4
  spi: stm32: qspi: Fix dual flash mode sanity test in stm32_qspi_setup()
  spi: cs42l43: Drop cs35l56 SPI speed down to 11MHz
  spi: cs42l43: Correct SPI root clock speed

5 files changed, 23 insertions, 30 deletions

diff --git a/drivers/spi/spi-cs42l43.c b/drivers/spi/spi-cs42l43.c
index 9d747ea69926..8b618ef0f711 100644
--- a/drivers/spi/spi-cs42l43.c
+++ b/drivers/spi/spi-cs42l43.c
@@ -26,7 +26,7 @@
 #include <linux/units.h>
 
 #define CS42L43_FIFO_SIZE		16
-#define CS42L43_SPI_ROOT_HZ		(40 * HZ_PER_MHZ)
+#define CS42L43_SPI_ROOT_HZ		49152000
 #define CS42L43_SPI_MAX_LENGTH		65532
 
 enum cs42l43_spi_cmd {
@@ -54,7 +54,7 @@ static const struct software_node ampr = {
 
 static struct spi_board_info ampl_info = {
 	.modalias		= "cs35l56",
-	.max_speed_hz		= 20 * HZ_PER_MHZ,
+	.max_speed_hz		= 11 * HZ_PER_MHZ,
 	.chip_select		= 0,
 	.mode			= SPI_MODE_0,
 	.swnode			= &ampl,
@@ -62,7 +62,7 @@ static struct spi_board_info ampl_info = {
 
 static struct spi_board_info ampr_info = {
 	.modalias		= "cs35l56",
-	.max_speed_hz		= 20 * HZ_PER_MHZ,
+	.max_speed_hz		= 11 * HZ_PER_MHZ,
 	.chip_select		= 1,
 	.mode			= SPI_MODE_0,
 	.swnode			= &ampr,
diff --git a/drivers/spi/spi-imx.c b/drivers/spi/spi-imx.c
index f4006c82f867..33164ebdb583 100644
--- a/drivers/spi/spi-imx.c
+++ b/drivers/spi/spi-imx.c
@@ -660,18 +660,8 @@ static int mx51_ecspi_prepare_transfer(struct spi_imx_data *spi_imx,
 		ctrl |= (spi_imx->target_burst * 8 - 1)
 			<< MX51_ECSPI_CTRL_BL_OFFSET;
 	else {
-		if (spi_imx->usedma) {
-			ctrl |= (spi_imx->bits_per_word - 1)
-				<< MX51_ECSPI_CTRL_BL_OFFSET;
-		} else {
-			if (spi_imx->count >= MX51_ECSPI_CTRL_MAX_BURST)
-				ctrl |= (MX51_ECSPI_CTRL_MAX_BURST * BITS_PER_BYTE - 1)
-						<< MX51_ECSPI_CTRL_BL_OFFSET;
-			else
-				ctrl |= (spi_imx->count / DIV_ROUND_UP(spi_imx->bits_per_word,
-						BITS_PER_BYTE) * spi_imx->bits_per_word - 1)
-						<< MX51_ECSPI_CTRL_BL_OFFSET;
-		}
+		ctrl |= (spi_imx->bits_per_word - 1)
+			<< MX51_ECSPI_CTRL_BL_OFFSET;
 	}
 
 	/* set clock speed */
diff --git a/drivers/spi/spi-stm32-qspi.c b/drivers/spi/spi-stm32-qspi.c
index f1e922fd362a..955c920c4b63 100644
--- a/drivers/spi/spi-stm32-qspi.c
+++ b/drivers/spi/spi-stm32-qspi.c
@@ -349,7 +349,7 @@ static int stm32_qspi_wait_poll_status(struct stm32_qspi *qspi)
 
 static int stm32_qspi_get_mode(u8 buswidth)
 {
-	if (buswidth == 4)
+	if (buswidth >= 4)
 		return CCR_BUSWIDTH_4;
 
 	return buswidth;
@@ -653,9 +653,7 @@ static int stm32_qspi_setup(struct spi_device *spi)
 		return -EINVAL;
 
 	mode = spi->mode & (SPI_TX_OCTAL | SPI_RX_OCTAL);
-	if ((mode == SPI_TX_OCTAL || mode == SPI_RX_OCTAL) ||
-	    ((mode == (SPI_TX_OCTAL | SPI_RX_OCTAL)) &&
-	    gpiod_count(qspi->dev, "cs") == -ENOENT)) {
+	if (mode && gpiod_count(qspi->dev, "cs") == -ENOENT) {
 		dev_err(qspi->dev, "spi-rx-bus-width\\/spi-tx-bus-width\\/cs-gpios\n");
 		dev_err(qspi->dev, "configuration not supported\n");
 
@@ -676,10 +674,10 @@ static int stm32_qspi_setup(struct spi_device *spi)
 	qspi->cr_reg = CR_APMS | 3 << CR_FTHRES_SHIFT | CR_SSHIFT | CR_EN;
 
 	/*
-	 * Dual flash mode is only enable in case SPI_TX_OCTAL and SPI_TX_OCTAL
-	 * are both set in spi->mode and "cs-gpios" properties is found in DT
+	 * Dual flash mode is only enable in case SPI_TX_OCTAL or SPI_RX_OCTAL
+	 * is set in spi->mode and "cs-gpios" properties is found in DT
 	 */
-	if (mode == (SPI_TX_OCTAL | SPI_RX_OCTAL)) {
+	if (mode) {
 		qspi->cr_reg |= CR_DFM;
 		dev_dbg(qspi->dev, "Dual flash mode enable");
 	}
diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c
index 9bc9fd10d538..fc13fa192189 100644
--- a/drivers/spi/spi.c
+++ b/drivers/spi/spi.c
@@ -689,10 +689,12 @@ static int __spi_add_device(struct spi_device *spi)
 	 * Make sure that multiple logical CS doesn't map to the same physical CS.
 	 * For example, spi->chip_select[0] != spi->chip_select[1] and so on.
 	 */
-	for (idx = 0; idx < SPI_CS_CNT_MAX; idx++) {
-		status = spi_dev_check_cs(dev, spi, idx, spi, idx + 1);
-		if (status)
-			return status;
+	if (!spi_controller_is_target(ctlr)) {
+		for (idx = 0; idx < SPI_CS_CNT_MAX; idx++) {
+			status = spi_dev_check_cs(dev, spi, idx, spi, idx + 1);
+			if (status)
+				return status;
+		}
 	}
 
 	/* Set the bus ID string */
@@ -4156,7 +4158,8 @@ static int __spi_validate(struct spi_device *spi, struct spi_message *message)
 				return -EINVAL;
 			if (xfer->tx_nbits != SPI_NBITS_SINGLE &&
 				xfer->tx_nbits != SPI_NBITS_DUAL &&
-				xfer->tx_nbits != SPI_NBITS_QUAD)
+				xfer->tx_nbits != SPI_NBITS_QUAD &&
+				xfer->tx_nbits != SPI_NBITS_OCTAL)
 				return -EINVAL;
 			if ((xfer->tx_nbits == SPI_NBITS_DUAL) &&
 				!(spi->mode & (SPI_TX_DUAL | SPI_TX_QUAD)))
@@ -4171,7 +4174,8 @@ static int __spi_validate(struct spi_device *spi, struct spi_message *message)
 				return -EINVAL;
 			if (xfer->rx_nbits != SPI_NBITS_SINGLE &&
 				xfer->rx_nbits != SPI_NBITS_DUAL &&
-				xfer->rx_nbits != SPI_NBITS_QUAD)
+				xfer->rx_nbits != SPI_NBITS_QUAD &&
+				xfer->rx_nbits != SPI_NBITS_OCTAL)
 				return -EINVAL;
 			if ((xfer->rx_nbits == SPI_NBITS_DUAL) &&
 				!(spi->mode & (SPI_RX_DUAL | SPI_RX_QUAD)))
diff --git a/include/linux/spi/spi.h b/include/linux/spi/spi.h
index e8e1e798924f..98fdef6e28f2 100644
--- a/include/linux/spi/spi.h
+++ b/include/linux/spi/spi.h
@@ -1085,12 +1085,13 @@ struct spi_transfer {
 	unsigned	dummy_data:1;
 	unsigned	cs_off:1;
 	unsigned	cs_change:1;
-	unsigned	tx_nbits:3;
-	unsigned	rx_nbits:3;
+	unsigned	tx_nbits:4;
+	unsigned	rx_nbits:4;
 	unsigned	timestamped:1;
 #define	SPI_NBITS_SINGLE	0x01 /* 1-bit transfer */
 #define	SPI_NBITS_DUAL		0x02 /* 2-bit transfer */
 #define	SPI_NBITS_QUAD		0x04 /* 4-bit transfer */
+#define	SPI_NBITS_OCTAL	0x08 /* 8-bit transfer */
 	u8		bits_per_word;
 	struct spi_delay	delay;
 	struct spi_delay	cs_change_delay;