Linux-2.6.12-rc2v2.6.12-rc2

Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!

1 files changed, 43 insertions, 0 deletions

diff --git a/Documentation/arm/SA1100/ADSBitsy b/Documentation/arm/SA1100/ADSBitsy
new file mode 100644
index 000000000000..ab47c3833908
--- /dev/null
+++ b/Documentation/arm/SA1100/ADSBitsy
@@ -0,0 +1,43 @@
+ADS Bitsy Single Board Computer
+(It is different from Bitsy(iPAQ) of Compaq)
+
+For more details, contact Applied Data Systems or see
+http://www.applieddata.net/products.html
+
+The Linux support for this product has been provided by
+Woojung Huh <whuh@applieddata.net>
+
+Use 'make adsbitsy_config' before any 'make config'.
+This will set up defaults for ADS Bitsy support.
+
+The kernel zImage is linked to be loaded and executed at 0xc0400000.
+
+Linux can  be used with the ADS BootLoader that ships with the
+newer rev boards. See their documentation on how to load Linux.
+
+Supported peripherals:
+- SA1100 LCD frame buffer (8/16bpp...sort of)
+- SA1111 USB Master
+- SA1100 serial port
+- pcmcia, compact flash
+- touchscreen(ucb1200)
+- console on LCD screen
+- serial ports (ttyS[0-2])
+  - ttyS0 is default for serial console
+
+To do:
+- everything else!  :-)
+
+Notes:
+
+- The flash on board is divided into 3 partitions.
+  You should be careful to use flash on board.
+  It's partition is different from GraphicsClient Plus and GraphicsMaster
+
+- 16bpp mode requires a different cable than what ships with the board.
+  Contact ADS or look through the manual to wire your own. Currently,
+  if you compile with 16bit mode support and switch into a lower bpp
+  mode, the timing is off so the image is corrupted.  This will be
+  fixed soon.
+
+Any contribution can be sent to nico@cam.org and will be greatly welcome!