ACPI / ACPICA: Fix low-level GPE manipulation code

ACPICA uses acpi_ev_enable_gpe() for enabling GPEs at the low level,
which is incorrect, because this function only enables the GPE if the
corresponding bit in its enable register's enable_for_run mask is set.
This causes acpi_set_gpe() to work incorrectly if used for enabling
GPEs that were not previously enabled with acpi_enable_gpe().  As a
result, among other things, wakeup-only GPEs are never enabled by
acpi_enable_wakeup_device(), so the devices that use them are unable
to wake up the system.

To fix this issue remove acpi_ev_enable_gpe() and its counterpart
acpi_ev_disable_gpe() and replace acpi_hw_low_disable_gpe() with
acpi_hw_low_set_gpe() that will be used instead to manipulate GPE
enable bits at the low level.  Make the users of acpi_ev_enable_gpe()
and acpi_ev_disable_gpe() call acpi_hw_low_set_gpe() instead and
make sure that GPE enable masks are only updated by acpi_enable_gpe()
and acpi_disable_gpe() when GPE reference counters change from 0
to 1 and from 1 to 0, respectively.

Signed-off-by: Rafael J. Wysocki <rjw@sisk.pl>
Signed-off-by: Len Brown <len.brown@intel.com>

1 files changed, 2 insertions, 1 deletions

diff --git a/drivers/acpi/acpica/achware.h b/drivers/acpi/acpica/achware.h
index c46277d179f0..32391588e163 100644
--- a/drivers/acpi/acpica/achware.h
+++ b/drivers/acpi/acpica/achware.h
@@ -93,7 +93,8 @@ acpi_status acpi_hw_write_port(acpi_io_address address, u32 value, u32 width);
 u32 acpi_hw_gpe_register_bit(struct acpi_gpe_event_info *gpe_event_info,
 			     struct acpi_gpe_register_info *gpe_register_info);
 
-acpi_status acpi_hw_low_disable_gpe(struct acpi_gpe_event_info *gpe_event_info);
+acpi_status
+acpi_hw_low_set_gpe(struct acpi_gpe_event_info *gpe_event_info, u8 action);
 
 acpi_status
 acpi_hw_write_gpe_enable_reg(struct acpi_gpe_event_info *gpe_event_info);