i2c: axxia: support slave mode

This device contains both master and slave controllers which can be
enabled simultaneously. Both controllers share the same SDA/SCL lines
and interrupt source but has separate control and status registers.
Controllers also works in loopback mode - slave device can communicate
with its own master controller internally. The controller can handle up
to two addresses, both of which may be 10 bit. Most of the logic
(sending (N)ACK, handling repeated start or switching between
write/read) is handled automatically which makes working with this
controller quite easy.

For simplicity, this patch adds basic support, limiting to only one
slave address. Support for the 2nd device may be added in the future.

Note that synchronize_irq() is used to ensure any running slave interrupt
is finished to make sure slave i2c_client structure can be safely used
by i2c_slave_event.

Signed-off-by: Krzysztof Adamski <krzysztof.adamski@nokia.com>
Reviewed-by: Alexander Sverdlin <alexander.sverdlin@nokia.com>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>

1 files changed, 1 insertions, 0 deletions

diff --git a/drivers/i2c/busses/Kconfig b/drivers/i2c/busses/Kconfig
index ee7f415a625a..d3023e5379ea 100644
--- a/drivers/i2c/busses/Kconfig
+++ b/drivers/i2c/busses/Kconfig
@@ -429,6 +429,7 @@ config I2C_AXXIA
 	tristate "Axxia I2C controller"
 	depends on ARCH_AXXIA || COMPILE_TEST
 	default ARCH_AXXIA
+	select I2C_SLAVE
 	help
 	  Say yes if you want to support the I2C bus on Axxia platforms.