diff options
author | Linus Torvalds <torvalds@linux-foundation.org> | 2008-12-28 21:49:40 +0100 |
---|---|---|
committer | Linus Torvalds <torvalds@linux-foundation.org> | 2008-12-28 21:49:40 +0100 |
commit | 0191b625ca5a46206d2fb862bb08f36f2fcb3b31 (patch) | |
tree | 454d1842b1833d976da62abcbd5c47521ebe9bd7 /drivers/net/atp.c | |
parent | Merge git://git.kernel.org/pub/scm/linux/kernel/git/sfrench/cifs-2.6 (diff) | |
parent | net: Allow dependancies of FDDI & Tokenring to be modular. (diff) | |
download | linux-0191b625ca5a46206d2fb862bb08f36f2fcb3b31.tar.xz linux-0191b625ca5a46206d2fb862bb08f36f2fcb3b31.zip |
Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6
* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6: (1429 commits)
net: Allow dependancies of FDDI & Tokenring to be modular.
igb: Fix build warning when DCA is disabled.
net: Fix warning fallout from recent NAPI interface changes.
gro: Fix potential use after free
sfc: If AN is enabled, always read speed/duplex from the AN advertising bits
sfc: When disabling the NIC, close the device rather than unregistering it
sfc: SFT9001: Add cable diagnostics
sfc: Add support for multiple PHY self-tests
sfc: Merge top-level functions for self-tests
sfc: Clean up PHY mode management in loopback self-test
sfc: Fix unreliable link detection in some loopback modes
sfc: Generate unique names for per-NIC workqueues
802.3ad: use standard ethhdr instead of ad_header
802.3ad: generalize out mac address initializer
802.3ad: initialize ports LACPDU from const initializer
802.3ad: remove typedef around ad_system
802.3ad: turn ports is_individual into a bool
802.3ad: turn ports is_enabled into a bool
802.3ad: make ntt bool
ixgbe: Fix set_ringparam in ixgbe to use the same memory pools.
...
Fixed trivial IPv4/6 address printing conflicts in fs/cifs/connect.c due
to the conversion to %pI (in this networking merge) and the addition of
doing IPv6 addresses (from the earlier merge of CIFS).
Diffstat (limited to 'drivers/net/atp.c')
-rw-r--r-- | drivers/net/atp.c | 29 |
1 files changed, 15 insertions, 14 deletions
diff --git a/drivers/net/atp.c b/drivers/net/atp.c index c10cd8058e23..ea493ce23982 100644 --- a/drivers/net/atp.c +++ b/drivers/net/atp.c @@ -248,7 +248,6 @@ static int __init atp_probe1(long ioaddr) struct net_local *lp; int saved_ctrl_reg, status, i; int res; - DECLARE_MAC_BUF(mac); outb(0xff, ioaddr + PAR_DATA); /* Save the original value of the Control register, in case we guessed @@ -324,8 +323,8 @@ static int __init atp_probe1(long ioaddr) #endif printk(KERN_NOTICE "%s: Pocket adapter found at %#3lx, IRQ %d, " - "SAPROM %s.\n", - dev->name, dev->base_addr, dev->irq, print_mac(mac, dev->dev_addr)); + "SAPROM %pM.\n", + dev->name, dev->base_addr, dev->irq, dev->dev_addr); /* Reset the ethernet hardware and activate the printer pass-through. */ write_reg_high(ioaddr, CMR1, CMR1h_RESET | CMR1h_MUX); @@ -421,7 +420,7 @@ static unsigned short __init eeprom_op(long ioaddr, u32 cmd) registers that "should" only need to be set once at boot, so that there is non-reboot way to recover if something goes wrong. - This is an attachable device: if there is no dev->priv entry then it wasn't + This is an attachable device: if there is no private entry then it wasn't probed for at boot-time, and we need to probe for it again. */ static int net_open(struct net_device *dev) @@ -803,21 +802,22 @@ static void net_rx(struct net_device *dev) static void read_block(long ioaddr, int length, unsigned char *p, int data_mode) { - if (data_mode <= 3) { /* Mode 0 or 1 */ outb(Ctrl_LNibRead, ioaddr + PAR_CONTROL); outb(length == 8 ? RdAddr | HNib | MAR : RdAddr | MAR, ioaddr + PAR_DATA); if (data_mode <= 1) { /* Mode 0 or 1 */ - do *p++ = read_byte_mode0(ioaddr); while (--length > 0); - } else /* Mode 2 or 3 */ - do *p++ = read_byte_mode2(ioaddr); while (--length > 0); - } else if (data_mode <= 5) - do *p++ = read_byte_mode4(ioaddr); while (--length > 0); - else - do *p++ = read_byte_mode6(ioaddr); while (--length > 0); + do { *p++ = read_byte_mode0(ioaddr); } while (--length > 0); + } else { /* Mode 2 or 3 */ + do { *p++ = read_byte_mode2(ioaddr); } while (--length > 0); + } + } else if (data_mode <= 5) { + do { *p++ = read_byte_mode4(ioaddr); } while (--length > 0); + } else { + do { *p++ = read_byte_mode6(ioaddr); } while (--length > 0); + } - outb(EOC+HNib+MAR, ioaddr + PAR_DATA); + outb(EOC+HNib+MAR, ioaddr + PAR_DATA); outb(Ctrl_SelData, ioaddr + PAR_CONTROL); } @@ -913,7 +913,8 @@ static void __exit atp_cleanup_module(void) { struct net_device *next_dev; while (root_atp_dev) { - next_dev = ((struct net_local *)root_atp_dev->priv)->next_module; + struct net_local *atp_local = netdev_priv(root_atp_dev); + next_dev = atp_local->next_module; unregister_netdev(root_atp_dev); /* No need to release_region(), since we never snarf it. */ free_netdev(root_atp_dev); |