Merge tag 'pci-v6.3-changes' of git://git.kernel.org/pub/scm/linux/kernel/git/pci/pci

Pull PCI updates from Bjorn Helgaas:
 "Enumeration:

   - Rework portdrv shutdown so it disables interrupts but doesn't
     disable bus mastering, which leads to hangs on Loongson LS7A

   - Add mechanism to prevent Max_Read_Request_Size (MRRS) increases,
     again to avoid hardware issues on Loongson LS7A (and likely other
     devices based on DesignWare IP)

   - Ignore devices with a firmware (DT or ACPI) node that says the
     device is disabled

  Resource management:

   - Distribute spare resources to unconfigured hotplug bridges at
     boot-time (not just when hot-adding such a bridge), which makes
     hot-adding devices to docks work better. Tried this in v6.1 but had
     to revert for regressions, so try again

   - Fix root bus issue that dropped resources that happened to end
     at 0, e.g., [bus 00]

  PCI device hotplug:

   - Remove device locking when marking device as disconnected so this
     doesn't have to wait for concurrent driver bind/unbind to complete

   - Quirk more Qualcomm bridges that don't fully implement the PCIe
     Slot Status 'Command Completed' bit

  Power management:

   - Account for _S0W of the target bridge in acpi_pci_bridge_d3() so we
     don't miss hot-add notifications for USB4 docks, Thunderbolt, etc

  Reset:

   - Observe delay after reset, e.g., resuming from system sleep,
     regardless of whether a bridge can suspend to D3cold at runtime

   - Wait for secondary bus to become ready after a bridge reset

  Virtualization:

   - Avoid FLR on some AMD FCH AHCI adapters where it doesn't work

   - Allow independent IOMMU groups for some Wangxun NICs that prevent
     peer-to-peer transactions but don't advertise an ACS Capability

  Error handling:

   - Configure End-to-End-CRC (ECRC) only if Linux owns the AER
     Capability

   - Remove redundant Device Control Error Reporting Enable in the AER
     service driver since this is already done for all devices during
     enumeration

  ASPM:

   - Add pci_enable_link_state() interface to allow drivers to enable
     ASPM link state

  Endpoint framework:

   - Move dra7xx and tegra194 linkup processing from hard IRQ to
     threaded IRQ handler

   - Add a separate lock for endpoint controller list of endpoint
     function drivers to prevent deadlock in callbacks

   - Pass events from endpoint controller to endpoint function drivers
     via callbacks instead of notifiers

  Synopsys DesignWare eDMA controller driver (acked by Vinod):

   - Fix CPU vs PCI address issues

   - Fix source vs destination address issues

   - Fix issues with interleaved transfer semantics

   - Fix channel count initialization issue (issue still exists in
     several other drivers)

   - Clean up and improve debugfs usage so it will work on platforms
     with several eDMA devices

  Baikal T-1 PCIe controller driver:

   - Set a 64-bit DMA mask

  Freescale i.MX6 PCIe controller driver:

   - Add i.MX8MM, i.MX8MQ, i.MX8MP endpoint mode DT binding and driver
     support

  Intel VMD host bridge driver:

   - Add quirk to configure PCIe ASPM and LTR. This is normally done by
     BIOS, and will be for future products

  Marvell MVEBU PCIe controller driver:

   - Mark this driver as broken in Kconfig since bugs prevent its daily
     usage

  MediaTek MT7621 PCIe controller driver:

   - Delay PHY port initialization to improve boot reliability for ZBT
     WE1326, ZBT WF3526-P, and some Netgear models

  Qualcomm PCIe controller driver:

   - Add MSM8998 DT compatible string

   - Unify MSM8996 and MSM8998 clock orderings

   - Add SM8350 DT binding and driver support

   - Add IPQ8074 Gen3 DT binding and driver support

   - Correct qcom,perst-regs in DT binding

   - Add qcom_pcie_host_deinit() so the PHY is powered off and
     regulators and clocks are disabled on late host-init errors

  Socionext UniPhier Pro5 controller driver:

   - Clean up uniphier-ep reg, clocks, resets, and their names in DT
     binding

  Synopsys DesignWare PCIe controller driver:

   - Restrict coherent DMA mask to 32 bits for MSI, but allow controller
     drivers to set 64-bit streaming DMA mask

   - Add eDMA engine support in both Root Port and Endpoint controllers

  Miscellaneous:

   - Remove MODULE_LICENSE from boolean drivers so they don't look like
     modules so modprobe can complain about them"

* tag 'pci-v6.3-changes' of git://git.kernel.org/pub/scm/linux/kernel/git/pci/pci: (86 commits)
  PCI: dwc: Add Root Port and Endpoint controller eDMA engine support
  PCI: bt1: Set 64-bit DMA mask
  PCI: dwc: Restrict only coherent DMA mask for MSI address allocation
  dmaengine: dw-edma: Prepare dw_edma_probe() for builtin callers
  dmaengine: dw-edma: Depend on DW_EDMA instead of selecting it
  dmaengine: dw-edma: Add mem-mapped LL-entries support
  PCI: Remove MODULE_LICENSE so boolean drivers don't look like modules
  PCI: hv: Drop duplicate PCI_MSI dependency
  PCI/P2PDMA: Annotate RCU dereference
  PCI/sysfs: Constify struct kobj_type pci_slot_ktype
  PCI: hotplug: Allow marking devices as disconnected during bind/unbind
  PCI: pciehp: Add Qualcomm quirk for Command Completed erratum
  PCI: qcom: Add IPQ8074 Gen3 port support
  dt-bindings: PCI: qcom: Add IPQ8074 Gen3 port
  dt-bindings: PCI: qcom: Sort compatibles alphabetically
  PCI: qcom: Fix host-init error handling
  PCI: qcom: Add SM8350 support
  dt-bindings: PCI: qcom: Add SM8350
  dt-bindings: PCI: qcom-ep: Correct qcom,perst-regs
  dt-bindings: PCI: qcom: Unify MSM8996 and MSM8998 clock order
  ...

1 files changed, 54 insertions, 0 deletions

diff --git a/drivers/pci/pcie/aspm.c b/drivers/pci/pcie/aspm.c
index 4b4184563a92..66d7514ca111 100644
--- a/drivers/pci/pcie/aspm.c
+++ b/drivers/pci/pcie/aspm.c
@@ -1138,6 +1138,60 @@ int pci_disable_link_state(struct pci_dev *pdev, int state)
 }
 EXPORT_SYMBOL(pci_disable_link_state);
 
+/**
+ * pci_enable_link_state - Clear and set the default device link state so that
+ * the link may be allowed to enter the specified states. Note that if the
+ * BIOS didn't grant ASPM control to the OS, this does nothing because we can't
+ * touch the LNKCTL register. Also note that this does not enable states
+ * disabled by pci_disable_link_state(). Return 0 or a negative errno.
+ *
+ * @pdev: PCI device
+ * @state: Mask of ASPM link states to enable
+ */
+int pci_enable_link_state(struct pci_dev *pdev, int state)
+{
+	struct pcie_link_state *link = pcie_aspm_get_link(pdev);
+
+	if (!link)
+		return -EINVAL;
+	/*
+	 * A driver requested that ASPM be enabled on this device, but
+	 * if we don't have permission to manage ASPM (e.g., on ACPI
+	 * systems we have to observe the FADT ACPI_FADT_NO_ASPM bit and
+	 * the _OSC method), we can't honor that request.
+	 */
+	if (aspm_disabled) {
+		pci_warn(pdev, "can't override BIOS ASPM; OS doesn't have ASPM control\n");
+		return -EPERM;
+	}
+
+	down_read(&pci_bus_sem);
+	mutex_lock(&aspm_lock);
+	link->aspm_default = 0;
+	if (state & PCIE_LINK_STATE_L0S)
+		link->aspm_default |= ASPM_STATE_L0S;
+	if (state & PCIE_LINK_STATE_L1)
+		/* L1 PM substates require L1 */
+		link->aspm_default |= ASPM_STATE_L1 | ASPM_STATE_L1SS;
+	if (state & PCIE_LINK_STATE_L1_1)
+		link->aspm_default |= ASPM_STATE_L1_1;
+	if (state & PCIE_LINK_STATE_L1_2)
+		link->aspm_default |= ASPM_STATE_L1_2;
+	if (state & PCIE_LINK_STATE_L1_1_PCIPM)
+		link->aspm_default |= ASPM_STATE_L1_1_PCIPM;
+	if (state & PCIE_LINK_STATE_L1_2_PCIPM)
+		link->aspm_default |= ASPM_STATE_L1_2_PCIPM;
+	pcie_config_aspm_link(link, policy_to_aspm_state(link));
+
+	link->clkpm_default = (state & PCIE_LINK_STATE_CLKPM) ? 1 : 0;
+	pcie_set_clkpm(link, policy_to_clkpm_state(link));
+	mutex_unlock(&aspm_lock);
+	up_read(&pci_bus_sem);
+
+	return 0;
+}
+EXPORT_SYMBOL(pci_enable_link_state);
+
 static int pcie_aspm_set_policy(const char *val,
 				const struct kernel_param *kp)
 {