thermal: ti-soc-thermal: clk_round_rate() can return a zero upon error

Treat both negative and zero return values from clk_round_rate() as
errors.  This is needed since subsequent patches will convert
clk_round_rate()'s return value to be an unsigned type, rather than a
signed type, since some clock sources can generate rates higher than
(2^31)-1 Hz.

Eventually, when calling clk_round_rate(), only a return value of zero
will be considered a error.  All other values will be considered valid
rates.  The comparison against values less than 0 is kept to preserve
the correct behavior in the meantime.

This patch also gets rid of a comparison between unsigned and signed
values; a side-benefit.

Signed-off-by: Paul Walmsley <pwalmsley@nvidia.com>
Cc: Eduardo Valentin <eduardo.valentin@ti.com>
Cc: Zhang Rui <rui.zhang@intel.com>
Signed-off-by: Eduardo Valentin <edubezval@gmail.com>

1 files changed, 1 insertions, 1 deletions

diff --git a/drivers/thermal/ti-soc-thermal/ti-bandgap.c b/drivers/thermal/ti-soc-thermal/ti-bandgap.c
index 3ab12ee359b7..a1271b55103a 100644
--- a/drivers/thermal/ti-soc-thermal/ti-bandgap.c
+++ b/drivers/thermal/ti-soc-thermal/ti-bandgap.c
@@ -1248,7 +1248,7 @@ int ti_bandgap_probe(struct platform_device *pdev)
 	clk_rate = clk_round_rate(bgp->div_clk,
 				  bgp->conf->sensors[0].ts_data->max_freq);
 	if (clk_rate < bgp->conf->sensors[0].ts_data->min_freq ||
-	    clk_rate == 0xffffffff) {
+	    clk_rate <= 0) {
 		ret = -ENODEV;
 		dev_err(&pdev->dev, "wrong clock rate (%d)\n", clk_rate);
 		goto put_clks;