Merge remote branch 'intel/drm-intel-next' of ../drm-next into drm-core-next

* 'intel/drm-intel-next' of ../drm-next: (755 commits)
  drm/i915: Only wait on a pending flip if we intend to write to the buffer
  drm/i915/dp: Sanity check eDP existence
  drm/i915: Rebind the buffer if its alignment constraints changes with tiling
  drm/i915: Disable GPU semaphores by default
  drm/i915: Do not overflow the MMADDR write FIFO
  Revert "drm/i915: fix corruptions on i8xx due to relaxed fencing"
  drm/i915: Don't save/restore hardware status page address register
  drm/i915: don't store the reg value for HWS_PGA
  drm/i915: fix memory corruption with GM965 and >4GB RAM
  Linux 2.6.38-rc7
  Revert "TPM: Long default timeout fix"
  drm/i915: Re-enable GPU semaphores for SandyBridge mobile
  drm/i915: Replace vblank PM QoS with "Interrupt-Based AGPBUSY#"
  Revert "drm/i915: Use PM QoS to prevent C-State starvation of gen3 GPU"
  drm/i915: Allow relocation deltas outside of target bo
  drm/i915: Silence an innocuous compiler warning for an unused variable
  fs/block_dev.c: fix new kernel-doc warning
  ACPI: Fix build for CONFIG_NET unset
  mm: <asm-generic/pgtable.h> must include <linux/mm_types.h>
  x86: Use u32 instead of long to set reset vector back to 0
  ...

Conflicts:
	drivers/gpu/drm/i915/i915_gem.c

1 files changed, 6 insertions, 9 deletions

diff --git a/drivers/tty/serial/bfin_5xx.c b/drivers/tty/serial/bfin_5xx.c
index e381b895b04d..9b1ff2b6bb37 100644
--- a/drivers/tty/serial/bfin_5xx.c
+++ b/drivers/tty/serial/bfin_5xx.c
@@ -370,10 +370,8 @@ static irqreturn_t bfin_serial_rx_int(int irq, void *dev_id)
 {
 	struct bfin_serial_port *uart = dev_id;
 
-	spin_lock(&uart->port.lock);
 	while (UART_GET_LSR(uart) & DR)
 		bfin_serial_rx_chars(uart);
-	spin_unlock(&uart->port.lock);
 
 	return IRQ_HANDLED;
 }
@@ -490,9 +488,8 @@ void bfin_serial_rx_dma_timeout(struct bfin_serial_port *uart)
 {
 	int x_pos, pos;
 
-	dma_disable_irq(uart->tx_dma_channel);
-	dma_disable_irq(uart->rx_dma_channel);
-	spin_lock_bh(&uart->port.lock);
+	dma_disable_irq_nosync(uart->rx_dma_channel);
+	spin_lock_bh(&uart->rx_lock);
 
 	/* 2D DMA RX buffer ring is used. Because curr_y_count and
 	 * curr_x_count can't be read as an atomic operation,
@@ -523,8 +520,7 @@ void bfin_serial_rx_dma_timeout(struct bfin_serial_port *uart)
 		uart->rx_dma_buf.tail = uart->rx_dma_buf.head;
 	}
 
-	spin_unlock_bh(&uart->port.lock);
-	dma_enable_irq(uart->tx_dma_channel);
+	spin_unlock_bh(&uart->rx_lock);
 	dma_enable_irq(uart->rx_dma_channel);
 
 	mod_timer(&(uart->rx_dma_timer), jiffies + DMA_RX_FLUSH_JIFFIES);
@@ -571,7 +567,7 @@ static irqreturn_t bfin_serial_dma_rx_int(int irq, void *dev_id)
 	unsigned short irqstat;
 	int x_pos, pos;
 
-	spin_lock(&uart->port.lock);
+	spin_lock(&uart->rx_lock);
 	irqstat = get_dma_curr_irqstat(uart->rx_dma_channel);
 	clear_dma_irqstat(uart->rx_dma_channel);
 
@@ -589,7 +585,7 @@ static irqreturn_t bfin_serial_dma_rx_int(int irq, void *dev_id)
 		uart->rx_dma_buf.tail = uart->rx_dma_buf.head;
 	}
 
-	spin_unlock(&uart->port.lock);
+	spin_unlock(&uart->rx_lock);
 
 	return IRQ_HANDLED;
 }
@@ -1332,6 +1328,7 @@ static int bfin_serial_probe(struct platform_device *pdev)
 		}
 
 #ifdef CONFIG_SERIAL_BFIN_DMA
+		spin_lock_init(&uart->rx_lock);
 		uart->tx_done	    = 1;
 		uart->tx_count	    = 0;