Merge tag 'pinctrl-fixes-v3.10-2' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl

Pull pinctrl fixes from Linus Walleij:

 - Three fixes to make the boot path for device tree work properly on
   the Nomadik pin controller.

 - Compile warning fix for the vt8500 driver.

 - Fix error path in pinctrl-single.

 - Free mappings in error path of the Lantiq controller.

 - Documentation fixes.

* tag 'pinctrl-fixes-v3.10-2' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl:
  pinctrl/lantiq: Free mapping configs for both pin and groups
  pinctrl: single: fix error return code in pcs_parse_one_pinctrl_entry()
  pinctrl: generic: Fix typos and clarify comments
  pinctrl: vt8500: Fix incorrect data in WM8750 pinctrl table
  pinctrl: abx500: Rejiggle platform data and DT initialisation
  pinctrl: abx500: Specify failed sub-driver by ID instead of driver_data

1 files changed, 6 insertions, 6 deletions

diff --git a/include/linux/pinctrl/pinconf-generic.h b/include/linux/pinctrl/pinconf-generic.h
index 72474e18f1e0..6aa238096622 100644
--- a/include/linux/pinctrl/pinconf-generic.h
+++ b/include/linux/pinctrl/pinconf-generic.h
@@ -37,17 +37,17 @@
  *	if it is 0, pull-down is disabled.
  * @PIN_CONFIG_DRIVE_PUSH_PULL: the pin will be driven actively high and
  *	low, this is the most typical case and is typically achieved with two
- *	active transistors on the output. Sending this config will enabale
+ *	active transistors on the output. Setting this config will enable
  *	push-pull mode, the argument is ignored.
  * @PIN_CONFIG_DRIVE_OPEN_DRAIN: the pin will be driven with open drain (open
  *	collector) which means it is usually wired with other output ports
- *	which are then pulled up with an external resistor. Sending this
- *	config will enabale open drain mode, the argument is ignored.
+ *	which are then pulled up with an external resistor. Setting this
+ *	config will enable open drain mode, the argument is ignored.
  * @PIN_CONFIG_DRIVE_OPEN_SOURCE: the pin will be driven with open source
- *	(open emitter). Sending this config will enabale open drain mode, the
+ *	(open emitter). Setting this config will enable open drain mode, the
  *	argument is ignored.
- * @PIN_CONFIG_DRIVE_STRENGTH: the pin will output the current passed as
- * 	argument. The argument is in mA.
+ * @PIN_CONFIG_DRIVE_STRENGTH: the pin will sink or source at most the current
+ *	passed as argument. The argument is in mA.
  * @PIN_CONFIG_INPUT_SCHMITT_ENABLE: control schmitt-trigger mode on the pin.
  *      If the argument != 0, schmitt-trigger mode is enabled. If it's 0,
  *      schmitt-trigger mode is disabled.