diff options
| -rw-r--r-- | Documentation/kernel-parameters.txt | 5 | ||||
| -rw-r--r-- | arch/x86/kernel/head.c | 53 | ||||
| -rw-r--r-- | arch/x86/kernel/head_64.S | 4 | ||||
| -rw-r--r-- | arch/x86/platform/efi/efi.c | 2 | ||||
| -rw-r--r-- | drivers/acpi/Kconfig | 3 |
5 files changed, 44 insertions, 23 deletions
diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt index 1da946548772..e567af39ee34 100644 --- a/Documentation/kernel-parameters.txt +++ b/Documentation/kernel-parameters.txt @@ -564,6 +564,8 @@ bytes respectively. Such letter suffixes can also be entirely omitted. UART at the specified I/O port or MMIO address, switching to the matching ttyS device later. The options are the same as for ttyS, above. + hvc<n> Use the hypervisor console device <n>. This is for + both Xen and PowerPC hypervisors. If the device connected to the port is not a TTY but a braille device, prepend "brl," before the device type, for instance @@ -757,6 +759,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted. earlyprintk= [X86,SH,BLACKFIN] earlyprintk=vga + earlyprintk=xen earlyprintk=serial[,ttySn[,baudrate]] earlyprintk=ttySn[,baudrate] earlyprintk=dbgp[debugController#] @@ -774,6 +777,8 @@ bytes respectively. Such letter suffixes can also be entirely omitted. The VGA output is eventually overwritten by the real console. + The xen output can only be used by Xen PV guests. + ekgdboc= [X86,KGDB] Allow early kernel console debugging ekgdboc=kbd diff --git a/arch/x86/kernel/head.c b/arch/x86/kernel/head.c index 48d9d4ea1020..992f442ca155 100644 --- a/arch/x86/kernel/head.c +++ b/arch/x86/kernel/head.c @@ -5,8 +5,6 @@ #include <asm/setup.h> #include <asm/bios_ebda.h> -#define BIOS_LOWMEM_KILOBYTES 0x413 - /* * The BIOS places the EBDA/XBDA at the top of conventional * memory, and usually decreases the reported amount of @@ -16,17 +14,30 @@ * chipset: reserve a page before VGA to prevent PCI prefetch * into it (errata #56). Usually the page is reserved anyways, * unless you have no PS/2 mouse plugged in. + * + * This functions is deliberately very conservative. Losing + * memory in the bottom megabyte is rarely a problem, as long + * as we have enough memory to install the trampoline. Using + * memory that is in use by the BIOS or by some DMA device + * the BIOS didn't shut down *is* a big problem. */ + +#define BIOS_LOWMEM_KILOBYTES 0x413 +#define LOWMEM_CAP 0x9f000U /* Absolute maximum */ +#define INSANE_CUTOFF 0x20000U /* Less than this = insane */ + void __init reserve_ebda_region(void) { unsigned int lowmem, ebda_addr; - /* To determine the position of the EBDA and the */ - /* end of conventional memory, we need to look at */ - /* the BIOS data area. In a paravirtual environment */ - /* that area is absent. We'll just have to assume */ - /* that the paravirt case can handle memory setup */ - /* correctly, without our help. */ + /* + * To determine the position of the EBDA and the + * end of conventional memory, we need to look at + * the BIOS data area. In a paravirtual environment + * that area is absent. We'll just have to assume + * that the paravirt case can handle memory setup + * correctly, without our help. + */ if (paravirt_enabled()) return; @@ -37,19 +48,23 @@ void __init reserve_ebda_region(void) /* start of EBDA area */ ebda_addr = get_bios_ebda(); - /* Fixup: bios puts an EBDA in the top 64K segment */ - /* of conventional memory, but does not adjust lowmem. */ - if ((lowmem - ebda_addr) <= 0x10000) - lowmem = ebda_addr; + /* + * Note: some old Dells seem to need 4k EBDA without + * reporting so, so just consider the memory above 0x9f000 + * to be off limits (bugzilla 2990). + */ + + /* If the EBDA address is below 128K, assume it is bogus */ + if (ebda_addr < INSANE_CUTOFF) + ebda_addr = LOWMEM_CAP; - /* Fixup: bios does not report an EBDA at all. */ - /* Some old Dells seem to need 4k anyhow (bugzilla 2990) */ - if ((ebda_addr == 0) && (lowmem >= 0x9f000)) - lowmem = 0x9f000; + /* If lowmem is less than 128K, assume it is bogus */ + if (lowmem < INSANE_CUTOFF) + lowmem = LOWMEM_CAP; - /* Paranoia: should never happen, but... */ - if ((lowmem == 0) || (lowmem >= 0x100000)) - lowmem = 0x9f000; + /* Use the lower of the lowmem and EBDA markers as the cutoff */ + lowmem = min(lowmem, ebda_addr); + lowmem = min(lowmem, LOWMEM_CAP); /* Absolute cap */ /* reserve all memory between lowmem and the 1MB mark */ memblock_reserve(lowmem, 0x100000 - lowmem); diff --git a/arch/x86/kernel/head_64.S b/arch/x86/kernel/head_64.S index b7de3b25adb5..6859e9626442 100644 --- a/arch/x86/kernel/head_64.S +++ b/arch/x86/kernel/head_64.S @@ -48,7 +48,7 @@ L3_START_KERNEL = pud_index(__START_KERNEL_map) .globl startup_64 startup_64: /* - * At this point the CPU runs in 64bit mode CS.L = 1 CS.D = 1, + * At this point the CPU runs in 64bit mode CS.L = 1 CS.D = 0, * and someone has loaded an identity mapped page table * for us. These identity mapped page tables map all of the * kernel pages and possibly all of memory. @@ -159,7 +159,7 @@ startup_64: jmp 1f ENTRY(secondary_startup_64) /* - * At this point the CPU runs in 64bit mode CS.L = 1 CS.D = 1, + * At this point the CPU runs in 64bit mode CS.L = 1 CS.D = 0, * and someone has loaded a mapped page table. * * %rsi holds a physical pointer to real_mode_data. diff --git a/arch/x86/platform/efi/efi.c b/arch/x86/platform/efi/efi.c index 2f81db40d7ca..5ae99f9160d9 100644 --- a/arch/x86/platform/efi/efi.c +++ b/arch/x86/platform/efi/efi.c @@ -85,7 +85,7 @@ int efi_enabled(int facility) } EXPORT_SYMBOL(efi_enabled); -static bool disable_runtime = false; +static bool __initdata disable_runtime = false; static int __init setup_noefi(char *arg) { disable_runtime = true; diff --git a/drivers/acpi/Kconfig b/drivers/acpi/Kconfig index 320006019e68..92ed9692c47e 100644 --- a/drivers/acpi/Kconfig +++ b/drivers/acpi/Kconfig @@ -266,7 +266,8 @@ config ACPI_CUSTOM_DSDT default ACPI_CUSTOM_DSDT_FILE != "" config ACPI_INITRD_TABLE_OVERRIDE - bool "ACPI tables can be passed via uncompressed cpio in initrd" + bool "ACPI tables override via initrd" + depends on BLK_DEV_INITRD && X86 default n help This option provides functionality to override arbitrary ACPI tables |