diff options
| -rw-r--r-- | drivers/bluetooth/btmtksdio.c | 144 |
1 files changed, 144 insertions, 0 deletions
diff --git a/drivers/bluetooth/btmtksdio.c b/drivers/bluetooth/btmtksdio.c index 877c0a831775..813338288453 100644 --- a/drivers/bluetooth/btmtksdio.c +++ b/drivers/bluetooth/btmtksdio.c @@ -17,6 +17,7 @@ #include <linux/iopoll.h> #include <linux/kernel.h> #include <linux/module.h> +#include <linux/pm_runtime.h> #include <linux/skbuff.h> #include <linux/mmc/host.h> @@ -33,6 +34,10 @@ #define FIRMWARE_MT7663 "mediatek/mt7663pr2h.bin" #define FIRMWARE_MT7668 "mediatek/mt7668pr2h.bin" +#define MTKBTSDIO_AUTOSUSPEND_DELAY 8000 + +static bool enable_autosuspend; + struct btmtksdio_data { const char *fwname; }; @@ -150,6 +155,7 @@ struct btmtk_hci_wmt_params { struct btmtksdio_dev { struct hci_dev *hdev; struct sdio_func *func; + struct device *dev; struct work_struct tx_work; unsigned long tx_state; @@ -301,6 +307,8 @@ static void btmtksdio_tx_work(struct work_struct *work) struct sk_buff *skb; int err; + pm_runtime_get_sync(bdev->dev); + sdio_claim_host(bdev->func); while ((skb = skb_dequeue(&bdev->txq))) { @@ -313,6 +321,9 @@ static void btmtksdio_tx_work(struct work_struct *work) } sdio_release_host(bdev->func); + + pm_runtime_mark_last_busy(bdev->dev); + pm_runtime_put_autosuspend(bdev->dev); } static int btmtksdio_recv_event(struct hci_dev *hdev, struct sk_buff *skb) @@ -471,6 +482,18 @@ static void btmtksdio_interrupt(struct sdio_func *func) u32 int_status; u16 rx_size; + /* It is required that the host gets ownership from the device before + * accessing any register, however, if SDIO host is not being released, + * a potential deadlock probably happens in a circular wait between SDIO + * IRQ work and PM runtime work. So, we have to explicitly release SDIO + * host here and claim again after the PM runtime work is all done. + */ + sdio_release_host(bdev->func); + + pm_runtime_get_sync(bdev->dev); + + sdio_claim_host(bdev->func); + /* Disable interrupt */ sdio_writel(func, C_INT_EN_CLR, MTK_REG_CHLPCR, 0); @@ -507,6 +530,9 @@ static void btmtksdio_interrupt(struct sdio_func *func) /* Enable interrupt */ sdio_writel(func, C_INT_EN_SET, MTK_REG_CHLPCR, 0); + + pm_runtime_mark_last_busy(bdev->dev); + pm_runtime_put_autosuspend(bdev->dev); } static int btmtksdio_open(struct hci_dev *hdev) @@ -815,6 +841,23 @@ ignore_func_on: delta = ktime_sub(rettime, calltime); duration = (unsigned long long)ktime_to_ns(delta) >> 10; + pm_runtime_set_autosuspend_delay(bdev->dev, + MTKBTSDIO_AUTOSUSPEND_DELAY); + pm_runtime_use_autosuspend(bdev->dev); + + err = pm_runtime_set_active(bdev->dev); + if (err < 0) + return err; + + /* Default forbid runtime auto suspend, that can be allowed by + * enable_autosuspend flag or the PM runtime entry under sysfs. + */ + pm_runtime_forbid(bdev->dev); + pm_runtime_enable(bdev->dev); + + if (enable_autosuspend) + pm_runtime_allow(bdev->dev); + bt_dev_info(hdev, "Device setup in %llu usecs", duration); return 0; @@ -822,10 +865,16 @@ ignore_func_on: static int btmtksdio_shutdown(struct hci_dev *hdev) { + struct btmtksdio_dev *bdev = hci_get_drvdata(hdev); struct btmtk_hci_wmt_params wmt_params; u8 param = 0x0; int err; + /* Get back the state to be consistent with the state + * in btmtksdio_setup. + */ + pm_runtime_get_sync(bdev->dev); + /* Disable the device */ wmt_params.op = MTK_WMT_FUNC_CTRL; wmt_params.flag = 0; @@ -839,6 +888,9 @@ static int btmtksdio_shutdown(struct hci_dev *hdev) return err; } + pm_runtime_put_noidle(bdev->dev); + pm_runtime_disable(bdev->dev); + return 0; } @@ -885,6 +937,7 @@ static int btmtksdio_probe(struct sdio_func *func, if (!bdev->data) return -ENODEV; + bdev->dev = &func->dev; bdev->func = func; INIT_WORK(&bdev->tx_work, btmtksdio_tx_work); @@ -922,6 +975,25 @@ static int btmtksdio_probe(struct sdio_func *func, sdio_set_drvdata(func, bdev); + /* pm_runtime_enable would be done after the firmware is being + * downloaded because the core layer probably already enables + * runtime PM for this func such as the case host->caps & + * MMC_CAP_POWER_OFF_CARD. + */ + if (pm_runtime_enabled(bdev->dev)) + pm_runtime_disable(bdev->dev); + + /* As explaination in drivers/mmc/core/sdio_bus.c tells us: + * Unbound SDIO functions are always suspended. + * During probe, the function is set active and the usage count + * is incremented. If the driver supports runtime PM, + * it should call pm_runtime_put_noidle() in its probe routine and + * pm_runtime_get_noresume() in its remove routine. + * + * So, put a pm_runtime_put_noidle here ! + */ + pm_runtime_put_noidle(bdev->dev); + return 0; } @@ -933,6 +1005,9 @@ static void btmtksdio_remove(struct sdio_func *func) if (!bdev) return; + /* Be consistent the state in btmtksdio_probe */ + pm_runtime_get_noresume(bdev->dev); + hdev = bdev->hdev; sdio_set_drvdata(func, NULL); @@ -940,15 +1015,84 @@ static void btmtksdio_remove(struct sdio_func *func) hci_free_dev(hdev); } +#ifdef CONFIG_PM +static int btmtksdio_runtime_suspend(struct device *dev) +{ + struct sdio_func *func = dev_to_sdio_func(dev); + struct btmtksdio_dev *bdev; + u32 status; + int err; + + bdev = sdio_get_drvdata(func); + if (!bdev) + return 0; + + sdio_claim_host(bdev->func); + + sdio_writel(bdev->func, C_FW_OWN_REQ_SET, MTK_REG_CHLPCR, &err); + if (err < 0) + goto out; + + err = readx_poll_timeout(btmtksdio_drv_own_query, bdev, status, + !(status & C_COM_DRV_OWN), 2000, 1000000); +out: + bt_dev_info(bdev->hdev, "status (%d) return ownership to device", err); + + sdio_release_host(bdev->func); + + return err; +} + +static int btmtksdio_runtime_resume(struct device *dev) +{ + struct sdio_func *func = dev_to_sdio_func(dev); + struct btmtksdio_dev *bdev; + u32 status; + int err; + + bdev = sdio_get_drvdata(func); + if (!bdev) + return 0; + + sdio_claim_host(bdev->func); + + sdio_writel(bdev->func, C_FW_OWN_REQ_CLR, MTK_REG_CHLPCR, &err); + if (err < 0) + goto out; + + err = readx_poll_timeout(btmtksdio_drv_own_query, bdev, status, + status & C_COM_DRV_OWN, 2000, 1000000); +out: + bt_dev_info(bdev->hdev, "status (%d) get ownership from device", err); + + sdio_release_host(bdev->func); + + return err; +} + +static UNIVERSAL_DEV_PM_OPS(btmtksdio_pm_ops, btmtksdio_runtime_suspend, + btmtksdio_runtime_resume, NULL); +#define BTMTKSDIO_PM_OPS (&btmtksdio_pm_ops) +#else /* CONFIG_PM */ +#define BTMTKSDIO_PM_OPS NULL +#endif /* CONFIG_PM */ + static struct sdio_driver btmtksdio_driver = { .name = "btmtksdio", .probe = btmtksdio_probe, .remove = btmtksdio_remove, .id_table = btmtksdio_table, + .drv = { + .owner = THIS_MODULE, + .pm = BTMTKSDIO_PM_OPS, + } }; module_sdio_driver(btmtksdio_driver); +module_param(enable_autosuspend, bool, 0644); +MODULE_PARM_DESC(enable_autosuspend, "Enable autosuspend by default"); + MODULE_AUTHOR("Sean Wang <sean.wang@mediatek.com>"); MODULE_DESCRIPTION("MediaTek Bluetooth SDIO driver ver " VERSION); MODULE_VERSION(VERSION); |