1 files changed, 0 insertions, 70 deletions
diff --git a/Documentation/devicetree/bindings/arm/pmu.txt b/Documentation/devicetree/bindings/arm/pmu.txt
deleted file mode 100644
index 13611a8199bb..000000000000
--- a/Documentation/devicetree/bindings/arm/pmu.txt
+++ /dev/null
@@ -1,70 +0,0 @@
-* ARM Performance Monitor Units
-
-ARM cores often have a PMU for counting cpu and cache events like cache misses
-and hits. The interface to the PMU is part of the ARM ARM. The ARM PMU
-representation in the device tree should be done as under:-
-
-Required properties:
-
-- compatible : should be one of
-	"apm,potenza-pmu"
-	"arm,armv8-pmuv3"
-	"arm,cortex-a73-pmu"
-	"arm,cortex-a72-pmu"
-	"arm,cortex-a57-pmu"
-	"arm,cortex-a53-pmu"
-	"arm,cortex-a35-pmu"
-	"arm,cortex-a17-pmu"
-	"arm,cortex-a15-pmu"
-	"arm,cortex-a12-pmu"
-	"arm,cortex-a9-pmu"
-	"arm,cortex-a8-pmu"
-	"arm,cortex-a7-pmu"
-	"arm,cortex-a5-pmu"
-	"arm,arm11mpcore-pmu"
-	"arm,arm1176-pmu"
-	"arm,arm1136-pmu"
-	"brcm,vulcan-pmu"
-	"cavium,thunder-pmu"
-	"qcom,scorpion-pmu"
-	"qcom,scorpion-mp-pmu"
-	"qcom,krait-pmu"
-- interrupts : 1 combined interrupt or 1 per core. If the interrupt is a per-cpu
-               interrupt (PPI) then 1 interrupt should be specified.
-
-Optional properties:
-
-- interrupt-affinity : When using SPIs, specifies a list of phandles to CPU
-                       nodes corresponding directly to the affinity of
-		       the SPIs listed in the interrupts property.
-
-                       When using a PPI, specifies a list of phandles to CPU
-		       nodes corresponding to the set of CPUs which have
-		       a PMU of this type signalling the PPI listed in the
-		       interrupts property, unless this is already specified
-		       by the PPI interrupt specifier itself (in which case
-		       the interrupt-affinity property shouldn't be present).
-
-                       This property should be present when there is more than
-		       a single SPI.
-
-
-- qcom,no-pc-write : Indicates that this PMU doesn't support the 0xc and 0xd
-                     events.
-
-- secure-reg-access : Indicates that the ARMv7 Secure Debug Enable Register
-		      (SDER) is accessible. This will cause the driver to do
-		      any setup required that is only possible in ARMv7 secure
-		      state. If not present the ARMv7 SDER will not be touched,
-		      which means the PMU may fail to operate unless external
-		      code (bootloader or security monitor) has performed the
-		      appropriate initialisation. Note that this property is
-		      not valid for non-ARMv7 CPUs or ARMv7 CPUs booting Linux
-		      in Non-secure state.
-
-Example:
-
-pmu {
-        compatible = "arm,cortex-a9-pmu";
-        interrupts = <100 101>;
-};