1 files changed, 0 insertions, 64 deletions
diff --git a/Documentation/devicetree/bindings/dma/jz4780-dma.txt b/Documentation/devicetree/bindings/dma/jz4780-dma.txt
deleted file mode 100644
index 3459e77be294..000000000000
--- a/Documentation/devicetree/bindings/dma/jz4780-dma.txt
+++ /dev/null
@@ -1,64 +0,0 @@
-* Ingenic XBurst DMA Controller
-
-Required properties:
-
-- compatible: Should be one of:
-  * ingenic,jz4740-dma
-  * ingenic,jz4725b-dma
-  * ingenic,jz4770-dma
-  * ingenic,jz4780-dma
-  * ingenic,x1000-dma
-  * ingenic,x1830-dma
-- reg: Should contain the DMA channel registers location and length, followed
-  by the DMA controller registers location and length.
-- interrupts: Should contain the interrupt specifier of the DMA controller.
-- clocks: Should contain a clock specifier for the JZ4780/X1000/X1830 PDMA
-  clock.
-- #dma-cells: Must be <2>. Number of integer cells in the dmas property of
-  DMA clients (see below).
-
-Optional properties:
-
-- ingenic,reserved-channels: Bitmask of channels to reserve for devices that
-  need a specific channel. These channels will only be assigned when explicitly
-  requested by a client. The primary use for this is channels 0 and 1, which
-  can be configured to have special behaviour for NAND/BCH when using
-  programmable firmware.
-
-Example:
-
-dma: dma-controller@13420000 {
-	compatible = "ingenic,jz4780-dma";
-	reg = <0x13420000 0x400
-	       0x13421000 0x40>;
-
-	interrupt-parent = <&intc>;
-	interrupts = <10>;
-
-	clocks = <&cgu JZ4780_CLK_PDMA>;
-
-	#dma-cells = <2>;
-
-	ingenic,reserved-channels = <0x3>;
-};
-
-DMA clients must use the format described in dma.txt, giving a phandle to the
-DMA controller plus the following 2 integer cells:
-
-1. Request type: The DMA request type for transfers to/from the device on
-   the allocated channel, as defined in the SoC documentation.
-
-2. Channel: If set to 0xffffffff, any available channel will be allocated for
-   the client. Otherwise, the exact channel specified will be used. The channel
-   should be reserved on the DMA controller using the ingenic,reserved-channels
-   property.
-
-Example:
-
-uart0: serial@10030000 {
-	...
-	dmas = <&dma 0x14 0xffffffff
-		&dma 0x15 0xffffffff>;
-	dma-names = "tx", "rx";
-	...
-};