1 files changed, 0 insertions, 48 deletions
diff --git a/Documentation/devicetree/bindings/gpio/gpio-xilinx.txt b/Documentation/devicetree/bindings/gpio/gpio-xilinx.txt
deleted file mode 100644
index e506f30e1a95..000000000000
--- a/Documentation/devicetree/bindings/gpio/gpio-xilinx.txt
+++ /dev/null
@@ -1,48 +0,0 @@
-Xilinx plb/axi GPIO controller
-
-Dual channel GPIO controller with configurable number of pins
-(from 1 to 32 per channel). Every pin can be configured as
-input/output/tristate. Both channels share the same global IRQ but
-local interrupts can be enabled on channel basis.
-
-Required properties:
-- compatible : Should be "xlnx,xps-gpio-1.00.a"
-- reg : Address and length of the register set for the device
-- #gpio-cells : Should be two. The first cell is the pin number and the
-  second cell is used to specify optional parameters (currently unused).
-- gpio-controller : Marks the device node as a GPIO controller.
-
-Optional properties:
-- clocks : Input clock specifier. Refer to common clock bindings.
-- interrupts : Interrupt mapping for GPIO IRQ.
-- xlnx,all-inputs : if n-th bit is setup, GPIO-n is input
-- xlnx,dout-default : if n-th bit is 1, GPIO-n default value is 1
-- xlnx,gpio-width : gpio width
-- xlnx,tri-default : if n-th bit is 1, GPIO-n is in tristate mode
-- xlnx,is-dual : if 1, controller also uses the second channel
-- xlnx,all-inputs-2 : as above but for the second channel
-- xlnx,dout-default-2 : as above but the second channel
-- xlnx,gpio2-width : as above but for the second channel
-- xlnx,tri-default-2 : as above but for the second channel
-
-
-Example:
-gpio: gpio@40000000 {
-	#gpio-cells = <2>;
-	compatible = "xlnx,xps-gpio-1.00.a";
-	clocks = <&clkc25>;
-	gpio-controller ;
-	interrupt-parent = <&microblaze_0_intc>;
-	interrupts = < 6 2 >;
-	reg = < 0x40000000 0x10000 >;
-	xlnx,all-inputs = <0x0>;
-	xlnx,all-inputs-2 = <0x0>;
-	xlnx,dout-default = <0x0>;
-	xlnx,dout-default-2 = <0x0>;
-	xlnx,gpio-width = <0x2>;
-	xlnx,gpio2-width = <0x2>;
-	xlnx,interrupt-present = <0x1>;
-	xlnx,is-dual = <0x1>;
-	xlnx,tri-default = <0xffffffff>;
-	xlnx,tri-default-2 = <0xffffffff>;
-} ;