1 files changed, 0 insertions, 56 deletions
diff --git a/Documentation/devicetree/bindings/usb/dwc3-xilinx.txt b/Documentation/devicetree/bindings/usb/dwc3-xilinx.txt
deleted file mode 100644
index 04813a46e5d0..000000000000
--- a/Documentation/devicetree/bindings/usb/dwc3-xilinx.txt
+++ /dev/null
@@ -1,56 +0,0 @@
-Xilinx SuperSpeed DWC3 USB SoC controller
-
-Required properties:
-- compatible:	May contain "xlnx,zynqmp-dwc3" or "xlnx,versal-dwc3"
-- reg:		Base address and length of the register control block
-- clocks:	A list of phandles for the clocks listed in clock-names
-- clock-names:	Should contain the following:
-  "bus_clk"	 Master/Core clock, have to be >= 125 MHz for SS
-		 operation and >= 60MHz for HS operation
-
-  "ref_clk"	 Clock source to core during PHY power down
-- resets:	A list of phandles for resets listed in reset-names
-- reset-names:
-  "usb_crst"	 USB core reset
-  "usb_hibrst"	 USB hibernation reset
-  "usb_apbrst"	 USB APB reset
-
-Required child node:
-A child node must exist to represent the core DWC3 IP block. The name of
-the node is not important. The content of the node is defined in dwc3.txt.
-
-Optional properties for snps,dwc3:
-- dma-coherent:	Enable this flag if CCI is enabled in design. Adding this
-		flag configures Global SoC bus Configuration Register and
-		Xilinx USB 3.0 IP - USB coherency register to enable CCI.
-- interrupt-names: Should contain the following:
-  "dwc_usb3"	USB gadget mode interrupts
-  "otg"		USB OTG mode interrupts
-  "hiber"	USB hibernation interrupts
-
-Example device node:
-
-		usb@0 {
-			#address-cells = <0x2>;
-			#size-cells = <0x1>;
-			compatible = "xlnx,zynqmp-dwc3";
-			reg = <0x0 0xff9d0000 0x0 0x100>;
-			clock-names = "bus_clk", "ref_clk";
-			clocks = <&clk125>, <&clk125>;
-			resets = <&zynqmp_reset ZYNQMP_RESET_USB1_CORERESET>,
-				 <&zynqmp_reset ZYNQMP_RESET_USB1_HIBERRESET>,
-				 <&zynqmp_reset ZYNQMP_RESET_USB1_APB>;
-			reset-names = "usb_crst", "usb_hibrst", "usb_apbrst";
-			ranges;
-
-			dwc3@fe200000 {
-				compatible = "snps,dwc3";
-				reg = <0x0 0xfe200000 0x40000>;
-				interrupt-names = "dwc_usb3", "otg", "hiber";
-				interrupts = <0 65 4>, <0 69 4>, <0 75 4>;
-				phys = <&psgtr 2 PHY_TYPE_USB3 0 2>;
-				phy-names = "usb3-phy";
-				dr_mode = "host";
-				dma-coherent;
-			};
-		};