diff options
Diffstat (limited to 'Documentation/i2c')
| -rw-r--r-- | Documentation/i2c/chips/pca9539 | 58 |
1 files changed, 0 insertions, 58 deletions
diff --git a/Documentation/i2c/chips/pca9539 b/Documentation/i2c/chips/pca9539 deleted file mode 100644 index 6aff890088b1..000000000000 --- a/Documentation/i2c/chips/pca9539 +++ /dev/null @@ -1,58 +0,0 @@ -Kernel driver pca9539 -===================== - -NOTE: this driver is deprecated and will be dropped soon, use -drivers/gpio/pca9539.c instead. - -Supported chips: - * Philips PCA9539 - Prefix: 'pca9539' - Addresses scanned: none - Datasheet: - http://www.semiconductors.philips.com/acrobat/datasheets/PCA9539_2.pdf - -Author: Ben Gardner <bgardner@wabtec.com> - - -Description ------------ - -The Philips PCA9539 is a 16 bit low power I/O device. -All 16 lines can be individually configured as an input or output. -The input sense can also be inverted. -The 16 lines are split between two bytes. - - -Detection ---------- - -The PCA9539 is difficult to detect and not commonly found in PC machines, -so you have to pass the I2C bus and address of the installed PCA9539 -devices explicitly to the driver at load time via the force=... parameter. - - -Sysfs entries -------------- - -Each is a byte that maps to the 8 I/O bits. -A '0' suffix is for bits 0-7, while '1' is for bits 8-15. - -input[01] - read the current value -output[01] - sets the output value -direction[01] - direction of each bit: 1=input, 0=output -invert[01] - toggle the input bit sense - -input reads the actual state of the line and is always available. -The direction defaults to input for all channels. - - -General Remarks ---------------- - -Note that each output, direction, and invert entry controls 8 lines. -You should use the read, modify, write sequence. -For example. to set output bit 0 of 1. - val=$(cat output0) - val=$(( $val | 1 )) - echo $val > output0 - |