diff options
Diffstat (limited to 'Documentation/kernel-parameters.txt')
| -rw-r--r-- | Documentation/kernel-parameters.txt | 20 |
1 files changed, 16 insertions, 4 deletions
diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt index b56ea860da21..4ddb58df081e 100644 --- a/Documentation/kernel-parameters.txt +++ b/Documentation/kernel-parameters.txt @@ -145,11 +145,10 @@ and is between 256 and 4096 characters. It is defined in the file acpi= [HW,ACPI,X86] Advanced Configuration and Power Interface - Format: { force | off | ht | strict | noirq | rsdt } + Format: { force | off | strict | noirq | rsdt } force -- enable ACPI if default was off off -- disable ACPI if default was on noirq -- do not use ACPI for IRQ routing - ht -- run only enough ACPI to enable Hyper Threading strict -- Be less tolerant of platforms that are not strictly ACPI specification compliant. rsdt -- prefer RSDT over (default) XSDT @@ -758,6 +757,10 @@ and is between 256 and 4096 characters. It is defined in the file Default value is 0. Value can be changed at runtime via /selinux/enforce. + erst_disable [ACPI] + Disable Error Record Serialization Table (ERST) + support. + ether= [HW,NET] Ethernet cards parameters This option is obsoleted by the "netdev=" option, which has equivalent usage. See its documentation for details. @@ -852,6 +855,11 @@ and is between 256 and 4096 characters. It is defined in the file hd= [EIDE] (E)IDE hard drive subsystem geometry Format: <cyl>,<head>,<sect> + hest_disable [ACPI] + Disable Hardware Error Source Table (HEST) support; + corresponding firmware-first mode error processing + logic will be disabled. + highmem=nn[KMG] [KNL,BOOT] forces the highmem zone to have an exact size of <nn>. This works even on boxes that have no highmem otherwise. This also works to reduce highmem @@ -1252,10 +1260,12 @@ and is between 256 and 4096 characters. It is defined in the file * nohrst, nosrst, norst: suppress hard, soft and both resets. + * dump_id: dump IDENTIFY data. + If there are multiple matching configurations changing the same attribute, the last one is used. - lmb=debug [KNL] Enable lmb debug messages. + memblock=debug [KNL] Enable memblock debug messages. load_ramdisk= [RAM] List of ramdisks to load from floppy See Documentation/blockdev/ramdisk.txt. @@ -2038,7 +2048,9 @@ and is between 256 and 4096 characters. It is defined in the file WARNING: Forcing ASPM on may cause system lockups. pcie_pme= [PCIE,PM] Native PCIe PME signaling options: - off Do not use native PCIe PME signaling. + Format: {auto|force}[,nomsi] + auto Use native PCIe PME signaling if the BIOS allows the + kernel to control PCIe config registers of root ports. force Use native PCIe PME signaling even if the BIOS refuses to allow the kernel to control the relevant PCIe config registers. |