1 files changed, 0 insertions, 41 deletions
diff --git a/Documentation/sound/oss/PSS b/Documentation/sound/oss/PSS
deleted file mode 100644
index 187b9525e1f6..000000000000
--- a/Documentation/sound/oss/PSS
+++ /dev/null
@@ -1,41 +0,0 @@
-The PSS cards and other ECHO based cards provide an onboard DSP with 
-downloadable programs and also has an AD1848 "Microsoft Sound System" 
-device. The PSS driver enables MSS and MPU401 modes of the card. SB 
-is not enabled since it doesn't work concurrently with MSS. 
-
-If you build this driver as a module then the driver takes the following
-parameters
-
-pss_io. 	The I/O base the PSS card is configured at (normally 0x220
-		or 0x240)
-
-mss_io		The base address of the Microsoft Sound System interface.
-		This is normally 0x530, but may be 0x604 or other addresses.
-
-mss_irq		The interrupt assigned to the Microsoft Sound System
-		emulation. IRQ's 3,5,7,9,10,11 and 12 are available. If you
-		get IRQ errors be sure to check the interrupt is set to 
-		"ISA/Legacy" in the BIOS on modern machines.
-
-mss_dma		The DMA channel used by the Microsoft Sound System.
-		This can be 0, 1, or 3. DMA 0 is not available on older 
-		machines and will cause a crash on them.
-
-mpu_io		The MPU emulation base address. This sets the base of the
-		synthesizer. It is typically 0x330 but can be altered.
-
-mpu_irq		The interrupt to use for the synthesizer. It must differ
-		from the IRQ used by the Microsoft Sound System port.
-
-
-The mpu_io/mpu_irq fields are optional. If they are not specified the 
-synthesizer parts are not configured.
-
-When the module is loaded it looks for a file called 
-/etc/sound/pss_synth. This is the firmware file from the DOS install disks.
-This fil holds a general MIDI emulation. The file expected is called
-genmidi.ld on newer DOS driver install disks and synth.ld on older ones.
-
-You can also load alternative DSP algorithms into the card if you wish. One
-alternative driver can be found at http://www.mpg123.de/
-