2 files changed, 8 insertions, 3 deletions
diff --git a/Documentation/devicetree/bindings/display/panel/innolux,tv123wam.txt b/Documentation/devicetree/bindings/display/panel/innolux,p120zdg-bf1.txt
index a9b35265fa13..513f03466aba 100644
--- a/Documentation/devicetree/bindings/display/panel/innolux,tv123wam.txt
+++ b/Documentation/devicetree/bindings/display/panel/innolux,p120zdg-bf1.txt
@@ -1,20 +1,22 @@
-Innolux TV123WAM 12.3 inch eDP 2K display panel
+Innolux P120ZDG-BF1 12.02 inch eDP 2K display panel
 
 This binding is compatible with the simple-panel binding, which is specified
 in simple-panel.txt in this directory.
 
 Required properties:
-- compatible: should be "innolux,tv123wam"
+- compatible: should be "innolux,p120zdg-bf1"
 - power-supply: regulator to provide the supply voltage
 
 Optional properties:
 - enable-gpios: GPIO pin to enable or disable the panel
 - backlight: phandle of the backlight device attached to the panel
+- no-hpd: If HPD isn't hooked up; add this property.
 
 Example:
 	panel_edp: panel-edp {
-		compatible = "innolux,tv123wam";
+		compatible = "innolux,p120zdg-bf1";
 		enable-gpios = <&msmgpio 31 GPIO_ACTIVE_LOW>;
 		power-supply = <&pm8916_l2>;
 		backlight = <&backlight>;
+		no-hpd;
 	};
diff --git a/Documentation/devicetree/bindings/display/panel/simple-panel.txt b/Documentation/devicetree/bindings/display/panel/simple-panel.txt
index 45a457ad38f0..b2b872c710f2 100644
--- a/Documentation/devicetree/bindings/display/panel/simple-panel.txt
+++ b/Documentation/devicetree/bindings/display/panel/simple-panel.txt
@@ -11,6 +11,9 @@ Optional properties:
 - ddc-i2c-bus: phandle of an I2C controller used for DDC EDID probing
 - enable-gpios: GPIO pin to enable or disable the panel
 - backlight: phandle of the backlight device attached to the panel
+- no-hpd: This panel is supposed to communicate that it's ready via HPD
+  (hot plug detect) signal, but the signal isn't hooked up so we should
+  hardcode the max delay from the panel spec when powering up the panel.
 
 Example: