diff options
Diffstat (limited to 'arch/arm/boot/dts/armada-385-turris-omnia.dts')
| -rw-r--r-- | arch/arm/boot/dts/armada-385-turris-omnia.dts | 30 |
1 files changed, 29 insertions, 1 deletions
diff --git a/arch/arm/boot/dts/armada-385-turris-omnia.dts b/arch/arm/boot/dts/armada-385-turris-omnia.dts index 7ccebf7d1757..aea07b352d24 100644 --- a/arch/arm/boot/dts/armada-385-turris-omnia.dts +++ b/arch/arm/boot/dts/armada-385-turris-omnia.dts @@ -82,6 +82,24 @@ }; }; }; + + sfp: sfp { + compatible = "sff,sfp"; + i2c-bus = <&sfp_i2c>; + tx-fault-gpios = <&pcawan 0 GPIO_ACTIVE_HIGH>; + tx-disable-gpios = <&pcawan 1 GPIO_ACTIVE_HIGH>; + rate-select0-gpios = <&pcawan 2 GPIO_ACTIVE_HIGH>; + los-gpios = <&pcawan 3 GPIO_ACTIVE_HIGH>; + mod-def0-gpios = <&pcawan 4 GPIO_ACTIVE_LOW>; + maximum-power-milliwatt = <3000>; + + /* + * For now this has to be enabled at boot time by U-Boot when + * a SFP module is present. Read more in the comment in the + * eth2 node below. + */ + status = "disabled"; + }; }; &bm { @@ -126,10 +144,20 @@ /* WAN port */ ð2 { + /* + * eth2 is connected via a multiplexor to both the SFP cage and to + * ethernet-phy@1. The multiplexor switches the signal to SFP cage when + * a SFP module is present, as determined by the mode-def0 GPIO. + * + * Until kernel supports this configuration properly, in case SFP module + * is present, U-Boot has to enable the sfp node above, remove phy + * handle and add managed = "in-band-status" property. + */ status = "okay"; phy-mode = "sgmii"; phy = <&phy1>; phys = <&comphy5 2>; + sfp = <&sfp>; buffer-manager = <&bm>; bm,pool-long = <2>; bm,pool-short = <3>; @@ -195,7 +223,7 @@ /* routed to PCIe2 connector (CN62A) */ }; - i2c@4 { + sfp_i2c: i2c@4 { #address-cells = <1>; #size-cells = <0>; reg = <4>; |