diff options
Diffstat (limited to 'arch/blackfin/mach-bf609/include')
| -rw-r--r-- | arch/blackfin/mach-bf609/include/mach/anomaly.h | 141 | ||||
| -rw-r--r-- | arch/blackfin/mach-bf609/include/mach/defBF60x_base.h | 1 | ||||
| -rw-r--r-- | arch/blackfin/mach-bf609/include/mach/gpio.h | 2 | ||||
| -rw-r--r-- | arch/blackfin/mach-bf609/include/mach/irq.h | 4 | ||||
| -rw-r--r-- | arch/blackfin/mach-bf609/include/mach/pm.h | 9 |
5 files changed, 69 insertions, 88 deletions
diff --git a/arch/blackfin/mach-bf609/include/mach/anomaly.h b/arch/blackfin/mach-bf609/include/mach/anomaly.h index bdd39aefb565..7a07374308ac 100644 --- a/arch/blackfin/mach-bf609/include/mach/anomaly.h +++ b/arch/blackfin/mach-bf609/include/mach/anomaly.h @@ -5,126 +5,99 @@ * and can be replaced with that version at any time * DO NOT EDIT THIS FILE * - * Copyright 2004-2011 Analog Devices Inc. + * Copyright 2004-2012 Analog Devices Inc. * Licensed under the Clear BSD license. */ /* This file should be up to date with: + * - Revision A, 15/06/2012; ADSP-BF609 Blackfin Processor Anomaly List */ #if __SILICON_REVISION__ < 0 -# error will not work on BF506 silicon version +# error will not work on BF609 silicon version #endif #ifndef _MACH_ANOMALY_H_ #define _MACH_ANOMALY_H_ -/* Multi-Issue Instruction with dsp32shiftimm in slot1 and P-reg Store in slot2 Not Supported */ -#define ANOMALY_05000074 (1) -/* DMA_RUN Bit Is Not Valid after a Peripheral Receive Channel DMA Stops */ -#define ANOMALY_05000119 (1) -/* Rx.H Cannot Be Used to Access 16-bit System MMR Registers */ -#define ANOMALY_05000122 (1) -/* False Hardware Error from an Access in the Shadow of a Conditional Branch */ -#define ANOMALY_05000245 (1) -/* Incorrect Timer Pulse Width in Single-Shot PWM_OUT Mode with External Clock */ -#define ANOMALY_05000254 (1) -/* Sensitivity To Noise with Slow Input Edge Rates on External SPORT TX and RX Clocks */ -#define ANOMALY_05000265 (1) -/* False Hardware Errors Caused by Fetches at the Boundary of Reserved Memory */ -#define ANOMALY_05000310 (1) -/* PPI Underflow Error Goes Undetected in ITU-R 656 Mode */ -#define ANOMALY_05000366 (1) -/* Speculative Fetches Can Cause Undesired External FIFO Operations */ -#define ANOMALY_05000416 (1) -/* Speculative Fetches of Indirect-Pointer Instructions Can Cause False Hardware Errors */ -#define ANOMALY_05000426 (1) +/* TRU_STAT.ADDRERR and TRU_ERRADDR.ADDR May Not Reflect the Correct Status */ +#define ANOMALY_16000003 (1) +/* The EPPI Data Enable (DEN) Signal is Not Functional */ +#define ANOMALY_16000004 (1) +/* Using L1 Instruction Cache with Parity Enabled is Unreliable */ +#define ANOMALY_16000005 (1) +/* SEQSTAT.SYSNMI Clears Upon Entering the NMI ISR */ +#define ANOMALY_16000006 (1) +/* DDR2 Memory Reads May Fail Intermittently */ +#define ANOMALY_16000007 (1) +/* Instruction Memory Stalls Can Cause IFLUSH to Fail */ +#define ANOMALY_16000008 (1) +/* TestSET Instruction Cannot Be Interrupted */ +#define ANOMALY_16000009 (1) /* IFLUSH Instruction at End of Hardware Loop Causes Infinite Stall */ -#define ANOMALY_05000443 (1) -/* UART IrDA Receiver Fails on Extended Bit Pulses */ -#define ANOMALY_05000447 (1) +#define ANOMALY_16000010 (1) /* False Hardware Error when RETI Points to Invalid Memory */ -#define ANOMALY_05000461 (1) -/* PLL Latches Incorrect Settings During Reset */ -#define ANOMALY_05000469 (1) -/* Incorrect Default MSEL Value in PLL_CTL */ -#define ANOMALY_05000472 (1) -/* Interrupted SPORT Receive Data Register Read Results In Underflow when SLEN > 15 */ -#define ANOMALY_05000473 (1) -/* TESTSET Instruction Cannot Be Interrupted */ -#define ANOMALY_05000477 (1) -/* Reads of ITEST_COMMAND and ITEST_DATA Registers Cause Cache Corruption */ -#define ANOMALY_05000481 (1) -/* IFLUSH sucks at life */ -#define ANOMALY_05000491 (1) -/* Tempopary anomaly ID for data loss in MMR read operation if interrupted */ -#define ANOMALY_05001001 (__SILICON_REVISION__ < 1) +#define ANOMALY_16000011 (1) +/* Speculative Fetches of Indirect-Pointer Instructions Can Cause False Hardware Errors */ +#define ANOMALY_16000012 (1) +/* False Hardware Errors Caused by Fetches at the Boundary of Reserved Memory */ +#define ANOMALY_16000013 (1) +/* False Hardware Error from an Access in the Shadow of a Conditional Branch */ +#define ANOMALY_16000014 (1) +/* Multi-Issue Instruction with dsp32shiftimm in slot1 and P-reg Store in slot2 Not Supported */ +#define ANOMALY_16000015 (1) +/* Speculative Fetches Can Cause Undesired External FIFO Operations */ +#define ANOMALY_16000017 (1) +/* RSI Boot Cleanup Routine Does Not Clear Registers */ +#define ANOMALY_16000018 (1) +/* SPI Master Boot Device Auto-detection Frequency is Set Incorrectly */ +#define ANOMALY_16000019 (1) +/* rom_SysControl() Fails to Set DDR0_CTL.INIT for Wakeup From Hibernate */ +#define ANOMALY_16000020 (1) +/* rom_SysControl() Fails to Save and Restore DDR0_PHYCTL3 for Hibernate/Wakeup Sequence */ +#define ANOMALY_16000021 (1) +/* Boot Code Fails to Enable Parity Fault Detection */ +#define ANOMALY_16000022 (1) +/* USB DMA interrupt status do not show the DMA channel interrupt in the DMA ISR */ +#define ANOMALY_16000027 (1) +/* Interrupted Core Reads of MMRs May Cause Data Loss */ +#define ANOMALY_16000030 (1) /* Anomalies that don't exist on this proc */ -#define ANOMALY_05000099 (0) -#define ANOMALY_05000120 (0) -#define ANOMALY_05000125 (0) -#define ANOMALY_05000149 (0) #define ANOMALY_05000158 (0) -#define ANOMALY_05000171 (0) -#define ANOMALY_05000179 (0) -#define ANOMALY_05000182 (0) -#define ANOMALY_05000183 (0) #define ANOMALY_05000189 (0) #define ANOMALY_05000198 (0) -#define ANOMALY_05000202 (0) -#define ANOMALY_05000215 (0) -#define ANOMALY_05000219 (0) #define ANOMALY_05000220 (0) -#define ANOMALY_05000227 (0) #define ANOMALY_05000230 (0) #define ANOMALY_05000231 (0) -#define ANOMALY_05000233 (0) -#define ANOMALY_05000234 (0) -#define ANOMALY_05000242 (0) #define ANOMALY_05000244 (0) -#define ANOMALY_05000248 (0) -#define ANOMALY_05000250 (0) -#define ANOMALY_05000257 (0) -#define ANOMALY_05000261 (0) #define ANOMALY_05000263 (0) -#define ANOMALY_05000266 (0) #define ANOMALY_05000273 (0) #define ANOMALY_05000274 (0) #define ANOMALY_05000278 (0) #define ANOMALY_05000281 (0) -#define ANOMALY_05000283 (0) -#define ANOMALY_05000285 (0) #define ANOMALY_05000287 (0) -#define ANOMALY_05000301 (0) -#define ANOMALY_05000305 (0) -#define ANOMALY_05000307 (0) #define ANOMALY_05000311 (0) #define ANOMALY_05000312 (0) -#define ANOMALY_05000315 (0) #define ANOMALY_05000323 (0) -#define ANOMALY_05000353 (1) -#define ANOMALY_05000357 (0) -#define ANOMALY_05000362 (1) #define ANOMALY_05000363 (0) -#define ANOMALY_05000364 (0) -#define ANOMALY_05000371 (0) #define ANOMALY_05000380 (0) -#define ANOMALY_05000386 (0) -#define ANOMALY_05000389 (0) -#define ANOMALY_05000400 (0) -#define ANOMALY_05000402 (0) -#define ANOMALY_05000412 (0) -#define ANOMALY_05000432 (0) -#define ANOMALY_05000440 (0) #define ANOMALY_05000448 (0) -#define ANOMALY_05000456 (0) #define ANOMALY_05000450 (0) -#define ANOMALY_05000465 (0) -#define ANOMALY_05000467 (0) -#define ANOMALY_05000474 (0) -#define ANOMALY_05000475 (0) +#define ANOMALY_05000456 (0) #define ANOMALY_05000480 (0) -#define ANOMALY_05000485 (0) +#define ANOMALY_05000481 (1) + +/* Reuse BF5xx anomalies IDs for the same anomaly in BF60x */ +#define ANOMALY_05000491 ANOMALY_16000008 +#define ANOMALY_05000477 ANOMALY_16000009 +#define ANOMALY_05000443 ANOMALY_16000010 +#define ANOMALY_05000461 ANOMALY_16000011 +#define ANOMALY_05000426 ANOMALY_16000012 +#define ANOMALY_05000310 ANOMALY_16000013 +#define ANOMALY_05000245 ANOMALY_16000014 +#define ANOMALY_05000074 ANOMALY_16000015 +#define ANOMALY_05000416 ANOMALY_16000017 + #endif diff --git a/arch/blackfin/mach-bf609/include/mach/defBF60x_base.h b/arch/blackfin/mach-bf609/include/mach/defBF60x_base.h index 6aac38544cc9..f1a6afae1a71 100644 --- a/arch/blackfin/mach-bf609/include/mach/defBF60x_base.h +++ b/arch/blackfin/mach-bf609/include/mach/defBF60x_base.h @@ -2665,7 +2665,6 @@ #define DEVSZ_1G 0x400 /* DMC External Bank Size = 1Gbit */ #define DEVSZ_2G 0x500 /* DMC External Bank Size = 2Gbit */ - /* ========================= L2CTL Registers ========================= */ diff --git a/arch/blackfin/mach-bf609/include/mach/gpio.h b/arch/blackfin/mach-bf609/include/mach/gpio.h index 127586b1e04a..c32c8cc8db2e 100644 --- a/arch/blackfin/mach-bf609/include/mach/gpio.h +++ b/arch/blackfin/mach-bf609/include/mach/gpio.h @@ -123,6 +123,8 @@ #define BFIN_GPIO_PINT 1 +#define NR_PINT_SYS_IRQS 6 +#define NR_PINTS 112 #ifndef __ASSEMBLY__ diff --git a/arch/blackfin/mach-bf609/include/mach/irq.h b/arch/blackfin/mach-bf609/include/mach/irq.h index 0004552433b2..23e74cdeeee8 100644 --- a/arch/blackfin/mach-bf609/include/mach/irq.h +++ b/arch/blackfin/mach-bf609/include/mach/irq.h @@ -293,9 +293,13 @@ #define NR_MACH_IRQS (IRQ_PG15 + 1) +#define SEC_SCTL_PRIO_OFFSET 8 + #ifndef __ASSEMBLY__ #include <linux/types.h> +extern u8 sec_int_priority[]; + /* * bfin pint registers layout */ diff --git a/arch/blackfin/mach-bf609/include/mach/pm.h b/arch/blackfin/mach-bf609/include/mach/pm.h index 036d9bdc889e..3ca0fb965636 100644 --- a/arch/blackfin/mach-bf609/include/mach/pm.h +++ b/arch/blackfin/mach-bf609/include/mach/pm.h @@ -11,11 +11,14 @@ #include <linux/suspend.h> -int bfin609_pm_enter(suspend_state_t state); -int bf609_pm_prepare(void); -void bf609_pm_finish(void); +extern int bfin609_pm_enter(suspend_state_t state); +extern int bf609_pm_prepare(void); +extern void bf609_pm_finish(void); void bf609_hibernate(void); void bfin_sec_raise_irq(unsigned int sid); void coreb_enable(void); + +int bf609_nor_flash_init(void); +void bf609_nor_flash_exit(void); #endif |