diff options
Diffstat (limited to 'arch/mips/alchemy/devboards/db1200.c')
| -rw-r--r-- | arch/mips/alchemy/devboards/db1200.c | 61 |
1 files changed, 28 insertions, 33 deletions
diff --git a/arch/mips/alchemy/devboards/db1200.c b/arch/mips/alchemy/devboards/db1200.c index 9e46667f2597..776188908dfc 100644 --- a/arch/mips/alchemy/devboards/db1200.c +++ b/arch/mips/alchemy/devboards/db1200.c @@ -18,6 +18,7 @@ * Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA */ +#include <linux/clk.h> #include <linux/dma-mapping.h> #include <linux/gpio.h> #include <linux/i2c.h> @@ -129,7 +130,6 @@ static int __init db1200_detect_board(void) int __init db1200_board_setup(void) { - unsigned long freq0, clksrc, div, pfc; unsigned short whoami; if (db1200_detect_board()) @@ -149,34 +149,6 @@ int __init db1200_board_setup(void) " Board-ID %d Daughtercard ID %d\n", get_system_type(), (whoami >> 4) & 0xf, (whoami >> 8) & 0xf, whoami & 0xf); - /* SMBus/SPI on PSC0, Audio on PSC1 */ - pfc = __raw_readl((void __iomem *)SYS_PINFUNC); - pfc &= ~(SYS_PINFUNC_P0A | SYS_PINFUNC_P0B); - pfc &= ~(SYS_PINFUNC_P1A | SYS_PINFUNC_P1B | SYS_PINFUNC_FS3); - pfc |= SYS_PINFUNC_P1C; /* SPI is configured later */ - __raw_writel(pfc, (void __iomem *)SYS_PINFUNC); - wmb(); - - /* Clock configurations: PSC0: ~50MHz via Clkgen0, derived from - * CPU clock; all other clock generators off/unused. - */ - div = (get_au1x00_speed() + 25000000) / 50000000; - if (div & 1) - div++; - div = ((div >> 1) - 1) & 0xff; - - freq0 = div << SYS_FC_FRDIV0_BIT; - __raw_writel(freq0, (void __iomem *)SYS_FREQCTRL0); - wmb(); - freq0 |= SYS_FC_FE0; /* enable F0 */ - __raw_writel(freq0, (void __iomem *)SYS_FREQCTRL0); - wmb(); - - /* psc0_intclk comes 1:1 from F0 */ - clksrc = SYS_CS_MUX_FQ0 << SYS_CS_ME0_BIT; - __raw_writel(clksrc, (void __iomem *)SYS_CLKSRC); - wmb(); - return 0; } @@ -250,7 +222,7 @@ static void au1200_nand_cmd_ctrl(struct mtd_info *mtd, int cmd, static int au1200_nand_device_ready(struct mtd_info *mtd) { - return __raw_readl((void __iomem *)MEM_STSTAT) & 1; + return alchemy_rdsmem(AU1000_MEM_STSTAT) & 1; } static struct mtd_partition db1200_nand_parts[] = { @@ -847,6 +819,7 @@ int __init db1200_dev_setup(void) unsigned long pfc; unsigned short sw; int swapped, bid; + struct clk *c; bid = BCSR_WHOAMI_BOARD(bcsr_read(BCSR_WHOAMI)); if ((bid == BCSR_WHOAMI_PB1200_DDR1) || @@ -859,6 +832,24 @@ int __init db1200_dev_setup(void) irq_set_irq_type(AU1200_GPIO7_INT, IRQ_TYPE_LEVEL_LOW); bcsr_init_irq(DB1200_INT_BEGIN, DB1200_INT_END, AU1200_GPIO7_INT); + /* SMBus/SPI on PSC0, Audio on PSC1 */ + pfc = alchemy_rdsys(AU1000_SYS_PINFUNC); + pfc &= ~(SYS_PINFUNC_P0A | SYS_PINFUNC_P0B); + pfc &= ~(SYS_PINFUNC_P1A | SYS_PINFUNC_P1B | SYS_PINFUNC_FS3); + pfc |= SYS_PINFUNC_P1C; /* SPI is configured later */ + alchemy_wrsys(pfc, AU1000_SYS_PINFUNC); + + /* get 50MHz for I2C driver on PSC0 */ + c = clk_get(NULL, "psc0_intclk"); + if (!IS_ERR(c)) { + pfc = clk_round_rate(c, 50000000); + if ((pfc < 1) || (abs(50000000 - pfc) > 2500000)) + pr_warn("DB1200: cant get I2C close to 50MHz\n"); + else + clk_set_rate(c, pfc); + clk_put(c); + } + /* insert/eject pairs: one of both is always screaming. To avoid * issues they must not be automatically enabled when initially * requested. @@ -886,7 +877,7 @@ int __init db1200_dev_setup(void) * As a result, in SPI mode, OTG simply won't work (PSC0 uses * it as an input pin which is pulled high on the boards). */ - pfc = __raw_readl((void __iomem *)SYS_PINFUNC) & ~SYS_PINFUNC_P0A; + pfc = alchemy_rdsys(AU1000_SYS_PINFUNC) & ~SYS_PINFUNC_P0A; /* switch off OTG VBUS supply */ gpio_request(215, "otg-vbus"); @@ -912,8 +903,7 @@ int __init db1200_dev_setup(void) printk(KERN_INFO " S6.8 ON : PSC0 mode SPI\n"); printk(KERN_INFO " OTG port VBUS supply disabled\n"); } - __raw_writel(pfc, (void __iomem *)SYS_PINFUNC); - wmb(); + alchemy_wrsys(pfc, AU1000_SYS_PINFUNC); /* Audio: DIP7 selects I2S(0)/AC97(1), but need I2C for I2S! * so: DIP7=1 || DIP8=0 => AC97, DIP7=0 && DIP8=1 => I2S @@ -932,6 +922,11 @@ int __init db1200_dev_setup(void) } /* Audio PSC clock is supplied externally. (FIXME: platdata!!) */ + c = clk_get(NULL, "psc1_intclk"); + if (!IS_ERR(c)) { + clk_prepare_enable(c); + clk_put(c); + } __raw_writel(PSC_SEL_CLK_SERCLK, (void __iomem *)KSEG1ADDR(AU1550_PSC1_PHYS_ADDR) + PSC_SEL_OFFSET); wmb(); |