diff options
Diffstat (limited to 'arch/mips/pci/pcie-octeon.c')
| -rw-r--r-- | arch/mips/pci/pcie-octeon.c | 58 |
1 files changed, 29 insertions, 29 deletions
diff --git a/arch/mips/pci/pcie-octeon.c b/arch/mips/pci/pcie-octeon.c index fdb4d558c0cc..5e36c33e5543 100644 --- a/arch/mips/pci/pcie-octeon.c +++ b/arch/mips/pci/pcie-octeon.c @@ -43,7 +43,7 @@ union cvmx_pcie_address { uint64_t upper:2; /* Normally 2 for XKPHYS */ uint64_t reserved_49_61:13; /* Must be zero */ uint64_t io:1; /* 1 for IO space access */ - uint64_t did:5; /* PCIe DID = 3 */ + uint64_t did:5; /* PCIe DID = 3 */ uint64_t subdid:3; /* PCIe SubDID = 1 */ uint64_t reserved_36_39:4; /* Must be zero */ uint64_t es:2; /* Endian swap = 1 */ @@ -74,7 +74,7 @@ union cvmx_pcie_address { uint64_t upper:2; /* Normally 2 for XKPHYS */ uint64_t reserved_49_61:13; /* Must be zero */ uint64_t io:1; /* 1 for IO space access */ - uint64_t did:5; /* PCIe DID = 3 */ + uint64_t did:5; /* PCIe DID = 3 */ uint64_t subdid:3; /* PCIe SubDID = 2 */ uint64_t reserved_36_39:4; /* Must be zero */ uint64_t es:2; /* Endian swap = 1 */ @@ -85,7 +85,7 @@ union cvmx_pcie_address { uint64_t upper:2; /* Normally 2 for XKPHYS */ uint64_t reserved_49_61:13; /* Must be zero */ uint64_t io:1; /* 1 for IO space access */ - uint64_t did:5; /* PCIe DID = 3 */ + uint64_t did:5; /* PCIe DID = 3 */ uint64_t subdid:3; /* PCIe SubDID = 3-6 */ uint64_t reserved_36_39:4; /* Must be zero */ uint64_t address:36; /* PCIe Mem address */ @@ -166,7 +166,7 @@ static inline uint64_t cvmx_pcie_get_mem_size(int pcie_port) * Read a PCIe config space register indirectly. This is used for * registers of the form PCIEEP_CFG??? and PCIERC?_CFG???. * - * @pcie_port: PCIe port to read from + * @pcie_port: PCIe port to read from * @cfg_offset: Address to read * * Returns Value read @@ -194,9 +194,9 @@ static uint32_t cvmx_pcie_cfgx_read(int pcie_port, uint32_t cfg_offset) * Write a PCIe config space register indirectly. This is used for * registers of the form PCIEEP_CFG??? and PCIERC?_CFG???. * - * @pcie_port: PCIe port to write to + * @pcie_port: PCIe port to write to * @cfg_offset: Address to write - * @val: Value to write + * @val: Value to write */ static void cvmx_pcie_cfgx_write(int pcie_port, uint32_t cfg_offset, uint32_t val) @@ -222,7 +222,7 @@ static void cvmx_pcie_cfgx_write(int pcie_port, uint32_t cfg_offset, * @pcie_port: PCIe port to access * @bus: Sub bus * @dev: Device ID - * @fn: Device sub function + * @fn: Device sub function * @reg: Register to access * * Returns 64bit Octeon IO address @@ -259,7 +259,7 @@ static inline uint64_t __cvmx_pcie_build_config_addr(int pcie_port, int bus, * @pcie_port: PCIe port the device is on * @bus: Sub bus * @dev: Device ID - * @fn: Device sub function + * @fn: Device sub function * @reg: Register to access * * Returns Result of the read @@ -281,7 +281,7 @@ static uint8_t cvmx_pcie_config_read8(int pcie_port, int bus, int dev, * @pcie_port: PCIe port the device is on * @bus: Sub bus * @dev: Device ID - * @fn: Device sub function + * @fn: Device sub function * @reg: Register to access * * Returns Result of the read @@ -303,7 +303,7 @@ static uint16_t cvmx_pcie_config_read16(int pcie_port, int bus, int dev, * @pcie_port: PCIe port the device is on * @bus: Sub bus * @dev: Device ID - * @fn: Device sub function + * @fn: Device sub function * @reg: Register to access * * Returns Result of the read @@ -325,7 +325,7 @@ static uint32_t cvmx_pcie_config_read32(int pcie_port, int bus, int dev, * @pcie_port: PCIe port the device is on * @bus: Sub bus * @dev: Device ID - * @fn: Device sub function + * @fn: Device sub function * @reg: Register to access * @val: Value to write */ @@ -344,7 +344,7 @@ static void cvmx_pcie_config_write8(int pcie_port, int bus, int dev, int fn, * @pcie_port: PCIe port the device is on * @bus: Sub bus * @dev: Device ID - * @fn: Device sub function + * @fn: Device sub function * @reg: Register to access * @val: Value to write */ @@ -363,7 +363,7 @@ static void cvmx_pcie_config_write16(int pcie_port, int bus, int dev, int fn, * @pcie_port: PCIe port the device is on * @bus: Sub bus * @dev: Device ID - * @fn: Device sub function + * @fn: Device sub function * @reg: Register to access * @val: Value to write */ @@ -883,14 +883,14 @@ retry: /* Store merge control (NPEI_MEM_ACCESS_CTL[TIMER,MAX_WORD]) */ npei_mem_access_ctl.u64 = cvmx_read_csr(CVMX_PEXP_NPEI_MEM_ACCESS_CTL); - npei_mem_access_ctl.s.max_word = 0; /* Allow 16 words to combine */ - npei_mem_access_ctl.s.timer = 127; /* Wait up to 127 cycles for more data */ + npei_mem_access_ctl.s.max_word = 0; /* Allow 16 words to combine */ + npei_mem_access_ctl.s.timer = 127; /* Wait up to 127 cycles for more data */ cvmx_write_csr(CVMX_PEXP_NPEI_MEM_ACCESS_CTL, npei_mem_access_ctl.u64); /* Setup Mem access SubDIDs */ mem_access_subid.u64 = 0; mem_access_subid.s.port = pcie_port; /* Port the request is sent to. */ - mem_access_subid.s.nmerge = 1; /* Due to an errata on pass 1 chips, no merging is allowed. */ + mem_access_subid.s.nmerge = 1; /* Due to an errata on pass 1 chips, no merging is allowed. */ mem_access_subid.s.esr = 1; /* Endian-swap for Reads. */ mem_access_subid.s.esw = 1; /* Endian-swap for Writes. */ mem_access_subid.s.nsr = 0; /* Enable Snooping for Reads. Octeon doesn't care, but devices might want this more conservative setting */ @@ -926,7 +926,7 @@ retry: bar1_index.u32 = 0; bar1_index.s.addr_idx = (CVMX_PCIE_BAR1_PHYS_BASE >> 22); - bar1_index.s.ca = 1; /* Not Cached */ + bar1_index.s.ca = 1; /* Not Cached */ bar1_index.s.end_swp = 1; /* Endian Swap mode */ bar1_index.s.addr_v = 1; /* Valid entry */ @@ -1342,11 +1342,11 @@ static int __cvmx_pcie_rc_initialize_gen2(int pcie_port) /* Setup Mem access SubDIDs */ mem_access_subid.u64 = 0; mem_access_subid.s.port = pcie_port; /* Port the request is sent to. */ - mem_access_subid.s.nmerge = 0; /* Allow merging as it works on CN6XXX. */ - mem_access_subid.s.esr = 1; /* Endian-swap for Reads. */ - mem_access_subid.s.esw = 1; /* Endian-swap for Writes. */ - mem_access_subid.s.wtype = 0; /* "No snoop" and "Relaxed ordering" are not set */ - mem_access_subid.s.rtype = 0; /* "No snoop" and "Relaxed ordering" are not set */ + mem_access_subid.s.nmerge = 0; /* Allow merging as it works on CN6XXX. */ + mem_access_subid.s.esr = 1; /* Endian-swap for Reads. */ + mem_access_subid.s.esw = 1; /* Endian-swap for Writes. */ + mem_access_subid.s.wtype = 0; /* "No snoop" and "Relaxed ordering" are not set */ + mem_access_subid.s.rtype = 0; /* "No snoop" and "Relaxed ordering" are not set */ /* PCIe Adddress Bits <63:34>. */ if (OCTEON_IS_MODEL(OCTEON_CN68XX)) mem_access_subid.cn68xx.ba = 0; @@ -1409,7 +1409,7 @@ static int __cvmx_pcie_rc_initialize_gen2(int pcie_port) bar1_index.u64 = 0; bar1_index.s.addr_idx = (CVMX_PCIE_BAR1_PHYS_BASE >> 22); - bar1_index.s.ca = 1; /* Not Cached */ + bar1_index.s.ca = 1; /* Not Cached */ bar1_index.s.end_swp = 1; /* Endian Swap mode */ bar1_index.s.addr_v = 1; /* Valid entry */ @@ -1458,10 +1458,10 @@ static int cvmx_pcie_rc_initialize(int pcie_port) * * @dev: The Linux PCI device structure for the device to map * @slot: The slot number for this device on __BUS 0__. Linux - * enumerates through all the bridges and figures out the - * slot on Bus 0 where this device eventually hooks to. + * enumerates through all the bridges and figures out the + * slot on Bus 0 where this device eventually hooks to. * @pin: The PCI interrupt pin read from the device, then swizzled - * as it goes through each bridge. + * as it goes through each bridge. * Returns Interrupt number for the device */ int __init octeon_pcie_pcibios_map_irq(const struct pci_dev *dev, @@ -1503,7 +1503,7 @@ int __init octeon_pcie_pcibios_map_irq(const struct pci_dev *dev, return pin - 1 + OCTEON_IRQ_PCI_INT0; } -static void set_cfg_read_retry(u32 retry_cnt) +static void set_cfg_read_retry(u32 retry_cnt) { union cvmx_pemx_ctl_status pemx_ctl; pemx_ctl.u64 = cvmx_read_csr(CVMX_PEMX_CTL_STATUS(1)); @@ -1931,7 +1931,7 @@ static int __init octeon_pcie_setup(void) OCTEON_IS_MODEL(OCTEON_CN63XX_PASS2_0)) { sriox_status_reg.u64 = cvmx_read_csr(CVMX_SRIOX_STATUS_REG(0)); if (sriox_status_reg.s.srio) { - srio_war15205 += 1; /* Port is SRIO */ + srio_war15205 += 1; /* Port is SRIO */ port = 0; } } @@ -2004,7 +2004,7 @@ static int __init octeon_pcie_setup(void) OCTEON_IS_MODEL(OCTEON_CN63XX_PASS2_0)) { sriox_status_reg.u64 = cvmx_read_csr(CVMX_SRIOX_STATUS_REG(1)); if (sriox_status_reg.s.srio) { - srio_war15205 += 1; /* Port is SRIO */ + srio_war15205 += 1; /* Port is SRIO */ port = 1; } } |