diff options
Diffstat (limited to 'drivers/bluetooth/hci_qca.c')
| -rw-r--r-- | drivers/bluetooth/hci_qca.c | 118 |
1 files changed, 115 insertions, 3 deletions
diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c index 05ec530b8a3a..51790dd02afb 100644 --- a/drivers/bluetooth/hci_qca.c +++ b/drivers/bluetooth/hci_qca.c @@ -29,7 +29,12 @@ */ #include <linux/kernel.h> +#include <linux/clk.h> #include <linux/debugfs.h> +#include <linux/gpio/consumer.h> +#include <linux/mod_devicetable.h> +#include <linux/module.h> +#include <linux/serdev.h> #include <net/bluetooth/bluetooth.h> #include <net/bluetooth/hci_core.h> @@ -50,6 +55,9 @@ #define IBS_TX_IDLE_TIMEOUT_MS 2000 #define BAUDRATE_SETTLE_TIMEOUT_MS 300 +/* susclk rate */ +#define SUSCLK_RATE_32KHZ 32768 + /* HCI_IBS transmit side sleep protocol states */ enum tx_ibs_states { HCI_IBS_TX_ASLEEP, @@ -111,6 +119,12 @@ struct qca_data { u64 votes_off; }; +struct qca_serdev { + struct hci_uart serdev_hu; + struct gpio_desc *bt_en; + struct clk *susclk; +}; + static void __serial_clock_on(struct tty_struct *tty) { /* TODO: Some chipset requires to enable UART clock on client @@ -386,6 +400,7 @@ static void hci_ibs_wake_retrans_timeout(struct timer_list *t) /* Initialize protocol */ static int qca_open(struct hci_uart *hu) { + struct qca_serdev *qcadev; struct qca_data *qca; BT_DBG("hu %p qca_open", hu); @@ -444,6 +459,13 @@ static int qca_open(struct hci_uart *hu) timer_setup(&qca->tx_idle_timer, hci_ibs_tx_idle_timeout, 0); qca->tx_idle_delay = IBS_TX_IDLE_TIMEOUT_MS; + if (hu->serdev) { + serdev_device_open(hu->serdev); + + qcadev = serdev_device_get_drvdata(hu->serdev); + gpiod_set_value_cansleep(qcadev->bt_en, 1); + } + BT_DBG("HCI_UART_QCA open, tx_idle_delay=%u, wake_retrans=%u", qca->tx_idle_delay, qca->wake_retrans); @@ -512,6 +534,7 @@ static int qca_flush(struct hci_uart *hu) /* Close protocol */ static int qca_close(struct hci_uart *hu) { + struct qca_serdev *qcadev; struct qca_data *qca = hu->priv; BT_DBG("hu %p qca close", hu); @@ -525,6 +548,13 @@ static int qca_close(struct hci_uart *hu) destroy_workqueue(qca->workqueue); qca->hu = NULL; + if (hu->serdev) { + serdev_device_close(hu->serdev); + + qcadev = serdev_device_get_drvdata(hu->serdev); + gpiod_set_value_cansleep(qcadev->bt_en, 0); + } + kfree_skb(qca->rx_skb); hu->priv = NULL; @@ -880,11 +910,19 @@ static int qca_set_baudrate(struct hci_dev *hdev, uint8_t baudrate) */ set_current_state(TASK_UNINTERRUPTIBLE); schedule_timeout(msecs_to_jiffies(BAUDRATE_SETTLE_TIMEOUT_MS)); - set_current_state(TASK_INTERRUPTIBLE); + set_current_state(TASK_RUNNING); return 0; } +static inline void host_set_baudrate(struct hci_uart *hu, unsigned int speed) +{ + if (hu->serdev) + serdev_device_set_baudrate(hu->serdev, speed); + else + hci_uart_set_baudrate(hu, speed); +} + static int qca_setup(struct hci_uart *hu) { struct hci_dev *hdev = hu->hdev; @@ -905,7 +943,7 @@ static int qca_setup(struct hci_uart *hu) speed = hu->proto->init_speed; if (speed) - hci_uart_set_baudrate(hu, speed); + host_set_baudrate(hu, speed); /* Setup user speed if needed */ speed = 0; @@ -924,7 +962,7 @@ static int qca_setup(struct hci_uart *hu) ret); return ret; } - hci_uart_set_baudrate(hu, speed); + host_set_baudrate(hu, speed); } /* Setup patch / NVM configurations */ @@ -935,6 +973,12 @@ static int qca_setup(struct hci_uart *hu) } else if (ret == -ENOENT) { /* No patch/nvm-config found, run with original fw/config */ ret = 0; + } else if (ret == -EAGAIN) { + /* + * Userspace firmware loader will return -EAGAIN in case no + * patch/nvm-config is found, so run with original fw/config. + */ + ret = 0; } /* Setup bdaddr */ @@ -958,12 +1002,80 @@ static struct hci_uart_proto qca_proto = { .dequeue = qca_dequeue, }; +static int qca_serdev_probe(struct serdev_device *serdev) +{ + struct qca_serdev *qcadev; + int err; + + qcadev = devm_kzalloc(&serdev->dev, sizeof(*qcadev), GFP_KERNEL); + if (!qcadev) + return -ENOMEM; + + qcadev->serdev_hu.serdev = serdev; + serdev_device_set_drvdata(serdev, qcadev); + + qcadev->bt_en = devm_gpiod_get(&serdev->dev, "enable", + GPIOD_OUT_LOW); + if (IS_ERR(qcadev->bt_en)) { + dev_err(&serdev->dev, "failed to acquire enable gpio\n"); + return PTR_ERR(qcadev->bt_en); + } + + qcadev->susclk = devm_clk_get(&serdev->dev, NULL); + if (IS_ERR(qcadev->susclk)) { + dev_err(&serdev->dev, "failed to acquire clk\n"); + return PTR_ERR(qcadev->susclk); + } + + err = clk_set_rate(qcadev->susclk, SUSCLK_RATE_32KHZ); + if (err) + return err; + + err = clk_prepare_enable(qcadev->susclk); + if (err) + return err; + + err = hci_uart_register_device(&qcadev->serdev_hu, &qca_proto); + if (err) + clk_disable_unprepare(qcadev->susclk); + + return err; +} + +static void qca_serdev_remove(struct serdev_device *serdev) +{ + struct qca_serdev *qcadev = serdev_device_get_drvdata(serdev); + + hci_uart_unregister_device(&qcadev->serdev_hu); + + clk_disable_unprepare(qcadev->susclk); +} + +static const struct of_device_id qca_bluetooth_of_match[] = { + { .compatible = "qcom,qca6174-bt" }, + { /* sentinel */ } +}; +MODULE_DEVICE_TABLE(of, qca_bluetooth_of_match); + +static struct serdev_device_driver qca_serdev_driver = { + .probe = qca_serdev_probe, + .remove = qca_serdev_remove, + .driver = { + .name = "hci_uart_qca", + .of_match_table = qca_bluetooth_of_match, + }, +}; + int __init qca_init(void) { + serdev_device_driver_register(&qca_serdev_driver); + return hci_uart_register_proto(&qca_proto); } int __exit qca_deinit(void) { + serdev_device_driver_unregister(&qca_serdev_driver); + return hci_uart_unregister_proto(&qca_proto); } |