diff options
Diffstat (limited to 'drivers/char/rio')
| -rw-r--r-- | drivers/char/rio/riocmd.c | 2 | ||||
| -rw-r--r-- | drivers/char/rio/rioinit.c | 2 | ||||
| -rw-r--r-- | drivers/char/rio/rioparam.c | 6 |
3 files changed, 5 insertions, 5 deletions
diff --git a/drivers/char/rio/riocmd.c b/drivers/char/rio/riocmd.c index 4df6ab2206a1..167ebc84e8d7 100644 --- a/drivers/char/rio/riocmd.c +++ b/drivers/char/rio/riocmd.c @@ -922,7 +922,7 @@ int RIOUnUse(unsigned long iPortP, struct CmdBlk *CmdBlkP) ** ** Packet is an actual packet structure to be filled in with the packet ** information associated with the command. You need to fill in everything, -** as the command processore doesn't process the command packet in any way. +** as the command processor doesn't process the command packet in any way. ** ** The PreFuncP is called before the packet is enqueued on the host rup. ** PreFuncP is called as (*PreFuncP)(PreArg, CmdBlkP);. PreFuncP must diff --git a/drivers/char/rio/rioinit.c b/drivers/char/rio/rioinit.c index 99f3df02b61c..0794844369d6 100644 --- a/drivers/char/rio/rioinit.c +++ b/drivers/char/rio/rioinit.c @@ -222,7 +222,7 @@ int RIOBoardTest(unsigned long paddr, void __iomem *caddr, unsigned char type, i ** which value will be written into memory. ** Call with op set to zero means that the RAM will not be read and checked ** before it is written. -** Call with op not zero, and the RAM will be read and compated with val[op-1] +** Call with op not zero and the RAM will be read and compared with val[op-1] ** to check that the data from the previous phase was retained. */ diff --git a/drivers/char/rio/rioparam.c b/drivers/char/rio/rioparam.c index 1066d9760704..bb498d24adcc 100644 --- a/drivers/char/rio/rioparam.c +++ b/drivers/char/rio/rioparam.c @@ -87,8 +87,8 @@ static char *_rioparam_c_sccs_ = "@(#)rioparam.c 1.3"; ** command bit set onto the port. The command bit is in the len field, ** and gets ORed in with the actual byte count. ** -** When you send a packet with the command bit set, then the first -** data byte ( data[0] ) is interpretted as the command to execute. +** When you send a packet with the command bit set the first +** data byte (data[0]) is interpreted as the command to execute. ** It also governs what data structure overlay should accompany the packet. ** Commands are defined in cirrus/cirrus.h ** @@ -103,7 +103,7 @@ static char *_rioparam_c_sccs_ = "@(#)rioparam.c 1.3"; ** ** Most commands do not use the remaining bytes in the data array. The ** exceptions are OPEN MOPEN and CONFIG. (NB. As with the SI CONFIG and -** OPEN are currently analagous). With these three commands the following +** OPEN are currently analogous). With these three commands the following ** 11 data bytes are all used to pass config information such as baud rate etc. ** The fields are also defined in cirrus.h. Some contain straightforward ** information such as the transmit XON character. Two contain the transmit and |