diff options
Diffstat (limited to 'drivers/gpu/drm/i915/i915_reg.h')
| -rw-r--r-- | drivers/gpu/drm/i915/i915_reg.h | 121 |
1 files changed, 93 insertions, 28 deletions
diff --git a/drivers/gpu/drm/i915/i915_reg.h b/drivers/gpu/drm/i915/i915_reg.h index 150400f40534..281db6e5403a 100644 --- a/drivers/gpu/drm/i915/i915_reg.h +++ b/drivers/gpu/drm/i915/i915_reg.h @@ -359,6 +359,70 @@ #define LM_BURST_LENGTH 0x00000700 #define LM_FIFO_WATERMARK 0x0000001F #define MI_ARB_STATE 0x020e4 /* 915+ only */ +#define MI_ARB_MASK_SHIFT 16 /* shift for enable bits */ + +/* Make render/texture TLB fetches lower priorty than associated data + * fetches. This is not turned on by default + */ +#define MI_ARB_RENDER_TLB_LOW_PRIORITY (1 << 15) + +/* Isoch request wait on GTT enable (Display A/B/C streams). + * Make isoch requests stall on the TLB update. May cause + * display underruns (test mode only) + */ +#define MI_ARB_ISOCH_WAIT_GTT (1 << 14) + +/* Block grant count for isoch requests when block count is + * set to a finite value. + */ +#define MI_ARB_BLOCK_GRANT_MASK (3 << 12) +#define MI_ARB_BLOCK_GRANT_8 (0 << 12) /* for 3 display planes */ +#define MI_ARB_BLOCK_GRANT_4 (1 << 12) /* for 2 display planes */ +#define MI_ARB_BLOCK_GRANT_2 (2 << 12) /* for 1 display plane */ +#define MI_ARB_BLOCK_GRANT_0 (3 << 12) /* don't use */ + +/* Enable render writes to complete in C2/C3/C4 power states. + * If this isn't enabled, render writes are prevented in low + * power states. That seems bad to me. + */ +#define MI_ARB_C3_LP_WRITE_ENABLE (1 << 11) + +/* This acknowledges an async flip immediately instead + * of waiting for 2TLB fetches. + */ +#define MI_ARB_ASYNC_FLIP_ACK_IMMEDIATE (1 << 10) + +/* Enables non-sequential data reads through arbiter + */ +#define MI_ARB_DUAL_DATA_PHASE_DISABLE (1 << 9) + +/* Disable FSB snooping of cacheable write cycles from binner/render + * command stream + */ +#define MI_ARB_CACHE_SNOOP_DISABLE (1 << 8) + +/* Arbiter time slice for non-isoch streams */ +#define MI_ARB_TIME_SLICE_MASK (7 << 5) +#define MI_ARB_TIME_SLICE_1 (0 << 5) +#define MI_ARB_TIME_SLICE_2 (1 << 5) +#define MI_ARB_TIME_SLICE_4 (2 << 5) +#define MI_ARB_TIME_SLICE_6 (3 << 5) +#define MI_ARB_TIME_SLICE_8 (4 << 5) +#define MI_ARB_TIME_SLICE_10 (5 << 5) +#define MI_ARB_TIME_SLICE_14 (6 << 5) +#define MI_ARB_TIME_SLICE_16 (7 << 5) + +/* Low priority grace period page size */ +#define MI_ARB_LOW_PRIORITY_GRACE_4KB (0 << 4) /* default */ +#define MI_ARB_LOW_PRIORITY_GRACE_8KB (1 << 4) + +/* Disable display A/B trickle feed */ +#define MI_ARB_DISPLAY_TRICKLE_FEED_DISABLE (1 << 2) + +/* Set display plane priority */ +#define MI_ARB_DISPLAY_PRIORITY_A_B (0 << 0) /* display A > display B */ +#define MI_ARB_DISPLAY_PRIORITY_B_A (1 << 0) /* display B > display A */ + #define CACHE_MODE_0 0x02120 /* 915+ only */ #define CM0_MASK_SHIFT 16 #define CM0_IZ_OPT_DISABLE (1<<6) @@ -378,7 +442,7 @@ #define GEN6_RENDER_IMR 0x20a8 #define GEN6_RENDER_CONTEXT_SWITCH_INTERRUPT (1 << 8) #define GEN6_RENDER_PPGTT_PAGE_FAULT (1 << 7) -#define GEN6_RENDER TIMEOUT_COUNTER_EXPIRED (1 << 6) +#define GEN6_RENDER_TIMEOUT_COUNTER_EXPIRED (1 << 6) #define GEN6_RENDER_L3_PARITY_ERROR (1 << 5) #define GEN6_RENDER_PIPE_CONTROL_NOTIFY_INTERRUPT (1 << 4) #define GEN6_RENDER_COMMAND_PARSER_MASTER_ERROR (1 << 3) @@ -466,6 +530,21 @@ #define DPFC_CHICKEN 0x3224 #define DPFC_HT_MODIFY (1<<31) +/* Framebuffer compression for Ironlake */ +#define ILK_DPFC_CB_BASE 0x43200 +#define ILK_DPFC_CONTROL 0x43208 +/* The bit 28-8 is reserved */ +#define DPFC_RESERVED (0x1FFFFF00) +#define ILK_DPFC_RECOMP_CTL 0x4320c +#define ILK_DPFC_STATUS 0x43210 +#define ILK_DPFC_FENCE_YOFF 0x43218 +#define ILK_DPFC_CHICKEN 0x43224 +#define ILK_FBC_RT_BASE 0x2128 +#define ILK_FBC_RT_VALID (1<<0) + +#define ILK_DISPLAY_CHICKEN1 0x42000 +#define ILK_FBCQ_DIS (1<<22) + /* * GPIO regs */ @@ -531,32 +610,6 @@ #define DPLL_FPA01_P1_POST_DIV_MASK 0x00ff0000 /* i915 */ #define DPLL_FPA01_P1_POST_DIV_MASK_PINEVIEW 0x00ff8000 /* Pineview */ -#define I915_FIFO_UNDERRUN_STATUS (1UL<<31) -#define I915_CRC_ERROR_ENABLE (1UL<<29) -#define I915_CRC_DONE_ENABLE (1UL<<28) -#define I915_GMBUS_EVENT_ENABLE (1UL<<27) -#define I915_VSYNC_INTERRUPT_ENABLE (1UL<<25) -#define I915_DISPLAY_LINE_COMPARE_ENABLE (1UL<<24) -#define I915_DPST_EVENT_ENABLE (1UL<<23) -#define I915_LEGACY_BLC_EVENT_ENABLE (1UL<<22) -#define I915_ODD_FIELD_INTERRUPT_ENABLE (1UL<<21) -#define I915_EVEN_FIELD_INTERRUPT_ENABLE (1UL<<20) -#define I915_START_VBLANK_INTERRUPT_ENABLE (1UL<<18) /* 965 or later */ -#define I915_VBLANK_INTERRUPT_ENABLE (1UL<<17) -#define I915_OVERLAY_UPDATED_ENABLE (1UL<<16) -#define I915_CRC_ERROR_INTERRUPT_STATUS (1UL<<13) -#define I915_CRC_DONE_INTERRUPT_STATUS (1UL<<12) -#define I915_GMBUS_INTERRUPT_STATUS (1UL<<11) -#define I915_VSYNC_INTERRUPT_STATUS (1UL<<9) -#define I915_DISPLAY_LINE_COMPARE_STATUS (1UL<<8) -#define I915_DPST_EVENT_STATUS (1UL<<7) -#define I915_LEGACY_BLC_EVENT_STATUS (1UL<<6) -#define I915_ODD_FIELD_INTERRUPT_STATUS (1UL<<5) -#define I915_EVEN_FIELD_INTERRUPT_STATUS (1UL<<4) -#define I915_START_VBLANK_INTERRUPT_STATUS (1UL<<2) /* 965 or later */ -#define I915_VBLANK_INTERRUPT_STATUS (1UL<<1) -#define I915_OVERLAY_UPDATED_STATUS (1UL<<0) - #define SRX_INDEX 0x3c4 #define SRX_DATA 0x3c5 #define SR01 1 @@ -2102,7 +2155,8 @@ #define I830_FIFO_LINE_SIZE 32 #define G4X_FIFO_SIZE 127 -#define I945_FIFO_SIZE 127 /* 945 & 965 */ +#define I965_FIFO_SIZE 512 +#define I945_FIFO_SIZE 127 #define I915_FIFO_SIZE 95 #define I855GM_FIFO_SIZE 127 /* In cachelines */ #define I830_FIFO_SIZE 95 @@ -2121,6 +2175,9 @@ #define PINEVIEW_CURSOR_DFT_WM 0 #define PINEVIEW_CURSOR_GUARD_WM 5 +#define I965_CURSOR_FIFO 64 +#define I965_CURSOR_MAX_WM 32 +#define I965_CURSOR_DFT_WM 8 /* define the Watermark register on Ironlake */ #define WM0_PIPEA_ILK 0x45100 @@ -2148,6 +2205,9 @@ #define ILK_DISPLAY_FIFO 128 #define ILK_DISPLAY_MAXWM 64 #define ILK_DISPLAY_DFTWM 8 +#define ILK_CURSOR_FIFO 32 +#define ILK_CURSOR_MAXWM 16 +#define ILK_CURSOR_DFTWM 8 #define ILK_DISPLAY_SR_FIFO 512 #define ILK_DISPLAY_MAX_SRWM 0x1ff @@ -2446,6 +2506,10 @@ #define ILK_VSDPFD_FULL (1<<21) #define ILK_DSPCLK_GATE 0x42020 #define ILK_DPARB_CLK_GATE (1<<5) +/* According to spec this bit 7/8/9 of 0x42020 should be set to enable FBC */ +#define ILK_CLK_FBC (1<<7) +#define ILK_DPFC_DIS1 (1<<8) +#define ILK_DPFC_DIS2 (1<<9) #define DISP_ARB_CTL 0x45000 #define DISP_TILE_SURFACE_SWIZZLING (1<<13) @@ -2805,6 +2869,7 @@ #define PCH_PP_STATUS 0xc7200 #define PCH_PP_CONTROL 0xc7204 +#define PANEL_UNLOCK_REGS (0xabcd << 16) #define EDP_FORCE_VDD (1 << 3) #define EDP_BLC_ENABLE (1 << 2) #define PANEL_POWER_RESET (1 << 1) |