diff options
Diffstat (limited to 'drivers/i2c/busses/i2c-savage4.c')
| -rw-r--r-- | drivers/i2c/busses/i2c-savage4.c | 185 |
1 files changed, 0 insertions, 185 deletions
diff --git a/drivers/i2c/busses/i2c-savage4.c b/drivers/i2c/busses/i2c-savage4.c deleted file mode 100644 index 8adf4abaa035..000000000000 --- a/drivers/i2c/busses/i2c-savage4.c +++ /dev/null @@ -1,185 +0,0 @@ -/* - i2c-savage4.c - Part of lm_sensors, Linux kernel modules for hardware - monitoring - Copyright (C) 1998-2003 The LM Sensors Team - Alexander Wold <awold@bigfoot.com> - Mark D. Studebaker <mdsxyz123@yahoo.com> - - Based on i2c-voodoo3.c. - - This program is free software; you can redistribute it and/or modify - it under the terms of the GNU General Public License as published by - the Free Software Foundation; either version 2 of the License, or - (at your option) any later version. - - This program is distributed in the hope that it will be useful, - but WITHOUT ANY WARRANTY; without even the implied warranty of - MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the - GNU General Public License for more details. - - You should have received a copy of the GNU General Public License - along with this program; if not, write to the Free Software - Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA. -*/ - -/* This interfaces to the I2C bus of the Savage4 to gain access to - the BT869 and possibly other I2C devices. The DDC bus is not - yet supported because its register is not memory-mapped. -*/ - -#include <linux/kernel.h> -#include <linux/module.h> -#include <linux/init.h> -#include <linux/pci.h> -#include <linux/i2c.h> -#include <linux/i2c-algo-bit.h> -#include <asm/io.h> - -/* device IDs */ -#define PCI_CHIP_SAVAGE4 0x8A22 -#define PCI_CHIP_SAVAGE2000 0x9102 - -#define REG 0xff20 /* Serial Port 1 Register */ - -/* bit locations in the register */ -#define I2C_ENAB 0x00000020 -#define I2C_SCL_OUT 0x00000001 -#define I2C_SDA_OUT 0x00000002 -#define I2C_SCL_IN 0x00000008 -#define I2C_SDA_IN 0x00000010 - -/* delays */ -#define CYCLE_DELAY 10 -#define TIMEOUT (HZ / 2) - - -static void __iomem *ioaddr; - -/* The sav GPIO registers don't have individual masks for each bit - so we always have to read before writing. */ - -static void bit_savi2c_setscl(void *data, int val) -{ - unsigned int r; - r = readl(ioaddr + REG); - if(val) - r |= I2C_SCL_OUT; - else - r &= ~I2C_SCL_OUT; - writel(r, ioaddr + REG); - readl(ioaddr + REG); /* flush posted write */ -} - -static void bit_savi2c_setsda(void *data, int val) -{ - unsigned int r; - r = readl(ioaddr + REG); - if(val) - r |= I2C_SDA_OUT; - else - r &= ~I2C_SDA_OUT; - writel(r, ioaddr + REG); - readl(ioaddr + REG); /* flush posted write */ -} - -/* The GPIO pins are open drain, so the pins always remain outputs. - We rely on the i2c-algo-bit routines to set the pins high before - reading the input from other chips. */ - -static int bit_savi2c_getscl(void *data) -{ - return (0 != (readl(ioaddr + REG) & I2C_SCL_IN)); -} - -static int bit_savi2c_getsda(void *data) -{ - return (0 != (readl(ioaddr + REG) & I2C_SDA_IN)); -} - -/* Configures the chip */ - -static int config_s4(struct pci_dev *dev) -{ - unsigned long cadr; - - /* map memory */ - cadr = dev->resource[0].start; - cadr &= PCI_BASE_ADDRESS_MEM_MASK; - ioaddr = ioremap_nocache(cadr, 0x0080000); - if (ioaddr) { - /* writel(0x8160, ioaddr + REG2); */ - writel(0x00000020, ioaddr + REG); - dev_info(&dev->dev, "Using Savage4 at %p\n", ioaddr); - return 0; - } - return -ENODEV; -} - -static struct i2c_algo_bit_data sav_i2c_bit_data = { - .setsda = bit_savi2c_setsda, - .setscl = bit_savi2c_setscl, - .getsda = bit_savi2c_getsda, - .getscl = bit_savi2c_getscl, - .udelay = CYCLE_DELAY, - .timeout = TIMEOUT -}; - -static struct i2c_adapter savage4_i2c_adapter = { - .owner = THIS_MODULE, - .id = I2C_HW_B_SAVAGE, - .name = "I2C Savage4 adapter", - .algo_data = &sav_i2c_bit_data, -}; - -static struct pci_device_id savage4_ids[] __devinitdata = { - { PCI_DEVICE(PCI_VENDOR_ID_S3, PCI_CHIP_SAVAGE4) }, - { PCI_DEVICE(PCI_VENDOR_ID_S3, PCI_CHIP_SAVAGE2000) }, - { 0, } -}; - -MODULE_DEVICE_TABLE (pci, savage4_ids); - -static int __devinit savage4_probe(struct pci_dev *dev, const struct pci_device_id *id) -{ - int retval; - - retval = config_s4(dev); - if (retval) - return retval; - - /* set up the sysfs linkage to our parent device */ - savage4_i2c_adapter.dev.parent = &dev->dev; - - return i2c_bit_add_bus(&savage4_i2c_adapter); -} - -static void __devexit savage4_remove(struct pci_dev *dev) -{ - i2c_del_adapter(&savage4_i2c_adapter); - iounmap(ioaddr); -} - -static struct pci_driver savage4_driver = { - .name = "savage4_smbus", - .id_table = savage4_ids, - .probe = savage4_probe, - .remove = __devexit_p(savage4_remove), -}; - -static int __init i2c_savage4_init(void) -{ - return pci_register_driver(&savage4_driver); -} - -static void __exit i2c_savage4_exit(void) -{ - pci_unregister_driver(&savage4_driver); -} - -MODULE_AUTHOR("Alexander Wold <awold@bigfoot.com> " - "and Mark D. Studebaker <mdsxyz123@yahoo.com>"); -MODULE_DESCRIPTION("Savage4 I2C/SMBus driver"); -MODULE_LICENSE("GPL"); - -module_init(i2c_savage4_init); -module_exit(i2c_savage4_exit); |