diff options
Diffstat (limited to 'drivers/mfd/Kconfig')
| -rw-r--r-- | drivers/mfd/Kconfig | 52 |
1 files changed, 50 insertions, 2 deletions
diff --git a/drivers/mfd/Kconfig b/drivers/mfd/Kconfig index 33df0837ab41..8b99a13669bf 100644 --- a/drivers/mfd/Kconfig +++ b/drivers/mfd/Kconfig @@ -290,7 +290,8 @@ config MFD_CS47L92 config MFD_ASIC3 bool "Compaq ASIC3" - depends on GPIOLIB && ARM + depends on GPIOLIB + depends on ARM || COMPILE_TEST select MFD_CORE help This driver supports the ASIC3 multifunction chip found on many @@ -398,6 +399,17 @@ config MFD_DLN2 etc. must be enabled in order to use the functionality of the device. +config MFD_ENE_KB3930 + tristate "ENE KB3930 Embedded Controller support" + depends on I2C + depends on MACH_MMP3_DT || COMPILE_TEST + select MFD_CORE + help + This adds support for the power-off functionality and access to + the registers that control LEDS and USB port power on ENE KB3930 + Embedded Controller. To use the LED functionality LEDS_ARIEL must + be enabled. + config MFD_EXYNOS_LPASS tristate "Samsung Exynos SoC Low Power Audio Subsystem" depends on ARCH_EXYNOS || COMPILE_TEST @@ -493,7 +505,7 @@ config MFD_HI6421_PMIC Add support for HiSilicon Hi6421 PMIC. Hi6421 includes multi- functions, such as regulators, RTC, codec, Coulomb counter, etc. This driver includes core APIs _only_. You have to select - individul components like voltage regulators under corresponding + individual components like voltage regulators under corresponding menus in order to enable them. We communicate with the Hi6421 via memory-mapped I/O. @@ -1162,6 +1174,29 @@ config MFD_SI476X_CORE To compile this driver as a module, choose M here: the module will be called si476x-core. +config MFD_SIMPLE_MFD_I2C + tristate + depends on I2C + select REGMAP_I2C + help + This driver creates a single register map with the intention for it + to be shared by all sub-devices. + + Once the register map has been successfully initialised, any + sub-devices represented by child nodes in Device Tree will be + subsequently registered. + +config MFD_SL28CPLD + tristate "Kontron sl28cpld Board Management Controller" + depends on I2C + select MFD_SIMPLE_MFD_I2C + help + Say yes here to enable support for the Kontron sl28cpld board + management controller. + + It can be found on the following boards: + * SMARC-sAL28 + config MFD_SM501 tristate "Silicon Motion SM501" depends on HAS_DMA @@ -2118,5 +2153,18 @@ config SGI_MFD_IOC3 If you have an SGI Origin, Octane, or a PCI IOC3 card, then say Y. Otherwise say N. +config MFD_INTEL_M10_BMC + tristate "Intel MAX 10 Board Management Controller" + depends on SPI_MASTER + select REGMAP_SPI_AVMM + select MFD_CORE + help + Support for the Intel MAX 10 board management controller using the + SPI interface. + + This driver provides common support for accessing the device, + additional drivers must be enabled in order to use the functionality + of the device. + endmenu endif |