diff options
Diffstat (limited to 'drivers/net/dsa/qca8k.c')
| -rw-r--r-- | drivers/net/dsa/qca8k.c | 174 |
1 files changed, 155 insertions, 19 deletions
diff --git a/drivers/net/dsa/qca8k.c b/drivers/net/dsa/qca8k.c index 576b37d12a63..c4fa400efdcc 100644 --- a/drivers/net/dsa/qca8k.c +++ b/drivers/net/dsa/qca8k.c @@ -481,6 +481,155 @@ qca8k_port_set_status(struct qca8k_priv *priv, int port, int enable) qca8k_reg_clear(priv, QCA8K_REG_PORT_STATUS(port), mask); } +static u32 +qca8k_port_to_phy(int port) +{ + /* From Andrew Lunn: + * Port 0 has no internal phy. + * Port 1 has an internal PHY at MDIO address 0. + * Port 2 has an internal PHY at MDIO address 1. + * ... + * Port 5 has an internal PHY at MDIO address 4. + * Port 6 has no internal PHY. + */ + + return port - 1; +} + +static int +qca8k_mdio_write(struct qca8k_priv *priv, int port, u32 regnum, u16 data) +{ + u32 phy, val; + + if (regnum >= QCA8K_MDIO_MASTER_MAX_REG) + return -EINVAL; + + /* callee is responsible for not passing bad ports, + * but we still would like to make spills impossible. + */ + phy = qca8k_port_to_phy(port) % PHY_MAX_ADDR; + val = QCA8K_MDIO_MASTER_BUSY | QCA8K_MDIO_MASTER_EN | + QCA8K_MDIO_MASTER_WRITE | QCA8K_MDIO_MASTER_PHY_ADDR(phy) | + QCA8K_MDIO_MASTER_REG_ADDR(regnum) | + QCA8K_MDIO_MASTER_DATA(data); + + qca8k_write(priv, QCA8K_MDIO_MASTER_CTRL, val); + + return qca8k_busy_wait(priv, QCA8K_MDIO_MASTER_CTRL, + QCA8K_MDIO_MASTER_BUSY); +} + +static int +qca8k_mdio_read(struct qca8k_priv *priv, int port, u32 regnum) +{ + u32 phy, val; + + if (regnum >= QCA8K_MDIO_MASTER_MAX_REG) + return -EINVAL; + + /* callee is responsible for not passing bad ports, + * but we still would like to make spills impossible. + */ + phy = qca8k_port_to_phy(port) % PHY_MAX_ADDR; + val = QCA8K_MDIO_MASTER_BUSY | QCA8K_MDIO_MASTER_EN | + QCA8K_MDIO_MASTER_READ | QCA8K_MDIO_MASTER_PHY_ADDR(phy) | + QCA8K_MDIO_MASTER_REG_ADDR(regnum); + + qca8k_write(priv, QCA8K_MDIO_MASTER_CTRL, val); + + if (qca8k_busy_wait(priv, QCA8K_MDIO_MASTER_CTRL, + QCA8K_MDIO_MASTER_BUSY)) + return -ETIMEDOUT; + + val = (qca8k_read(priv, QCA8K_MDIO_MASTER_CTRL) & + QCA8K_MDIO_MASTER_DATA_MASK); + + return val; +} + +static int +qca8k_phy_write(struct dsa_switch *ds, int port, int regnum, u16 data) +{ + struct qca8k_priv *priv = ds->priv; + + return qca8k_mdio_write(priv, port, regnum, data); +} + +static int +qca8k_phy_read(struct dsa_switch *ds, int port, int regnum) +{ + struct qca8k_priv *priv = ds->priv; + int ret; + + ret = qca8k_mdio_read(priv, port, regnum); + + if (ret < 0) + return 0xffff; + + return ret; +} + +static int +qca8k_setup_mdio_bus(struct qca8k_priv *priv) +{ + u32 internal_mdio_mask = 0, external_mdio_mask = 0, reg; + struct device_node *ports, *port; + int err; + + ports = of_get_child_by_name(priv->dev->of_node, "ports"); + if (!ports) + return -EINVAL; + + for_each_available_child_of_node(ports, port) { + err = of_property_read_u32(port, "reg", ®); + if (err) + return err; + + if (!dsa_is_user_port(priv->ds, reg)) + continue; + + if (of_property_read_bool(port, "phy-handle")) + external_mdio_mask |= BIT(reg); + else + internal_mdio_mask |= BIT(reg); + } + + if (!external_mdio_mask && !internal_mdio_mask) { + dev_err(priv->dev, "no PHYs are defined.\n"); + return -EINVAL; + } + + /* The QCA8K_MDIO_MASTER_EN Bit, which grants access to PHYs through + * the MDIO_MASTER register also _disconnects_ the external MDC + * passthrough to the internal PHYs. It's not possible to use both + * configurations at the same time! + * + * Because this came up during the review process: + * If the external mdio-bus driver is capable magically disabling + * the QCA8K_MDIO_MASTER_EN and mutex/spin-locking out the qca8k's + * accessors for the time being, it would be possible to pull this + * off. + */ + if (!!external_mdio_mask && !!internal_mdio_mask) { + dev_err(priv->dev, "either internal or external mdio bus configuration is supported.\n"); + return -EINVAL; + } + + if (external_mdio_mask) { + /* Make sure to disable the internal mdio bus in cases + * a dt-overlay and driver reload changed the configuration + */ + + qca8k_reg_clear(priv, QCA8K_MDIO_MASTER_CTRL, + QCA8K_MDIO_MASTER_EN); + return 0; + } + + priv->ops.phy_read = qca8k_phy_read; + priv->ops.phy_write = qca8k_phy_write; + return 0; +} + static int qca8k_setup(struct dsa_switch *ds) { @@ -502,6 +651,10 @@ qca8k_setup(struct dsa_switch *ds) if (IS_ERR(priv->regmap)) pr_warn("regmap initialization failed"); + ret = qca8k_setup_mdio_bus(priv); + if (ret) + return ret; + /* Initialize CPU port pad mode (xMII type, delays...) */ phy_mode = of_get_phy_mode(ds->ports[QCA8K_CPU_PORT].dn); if (phy_mode < 0) { @@ -624,22 +777,6 @@ qca8k_adjust_link(struct dsa_switch *ds, int port, struct phy_device *phy) qca8k_port_set_status(priv, port, 1); } -static int -qca8k_phy_read(struct dsa_switch *ds, int phy, int regnum) -{ - struct qca8k_priv *priv = (struct qca8k_priv *)ds->priv; - - return mdiobus_read(priv->bus, phy, regnum); -} - -static int -qca8k_phy_write(struct dsa_switch *ds, int phy, int regnum, u16 val) -{ - struct qca8k_priv *priv = (struct qca8k_priv *)ds->priv; - - return mdiobus_write(priv->bus, phy, regnum, val); -} - static void qca8k_get_strings(struct dsa_switch *ds, int port, u32 stringset, uint8_t *data) { @@ -879,8 +1016,6 @@ static const struct dsa_switch_ops qca8k_switch_ops = { .setup = qca8k_setup, .adjust_link = qca8k_adjust_link, .get_strings = qca8k_get_strings, - .phy_read = qca8k_phy_read, - .phy_write = qca8k_phy_write, .get_ethtool_stats = qca8k_get_ethtool_stats, .get_sset_count = qca8k_get_sset_count, .get_mac_eee = qca8k_get_mac_eee, @@ -923,7 +1058,8 @@ qca8k_sw_probe(struct mdio_device *mdiodev) return -ENOMEM; priv->ds->priv = priv; - priv->ds->ops = &qca8k_switch_ops; + priv->ops = qca8k_switch_ops; + priv->ds->ops = &priv->ops; mutex_init(&priv->reg_mutex); dev_set_drvdata(&mdiodev->dev, priv); |