diff options
Diffstat (limited to 'drivers/net/igb/e1000_defines.h')
| -rw-r--r-- | drivers/net/igb/e1000_defines.h | 38 |
1 files changed, 18 insertions, 20 deletions
diff --git a/drivers/net/igb/e1000_defines.h b/drivers/net/igb/e1000_defines.h index 8da9ffedc425..afdba3c9073c 100644 --- a/drivers/net/igb/e1000_defines.h +++ b/drivers/net/igb/e1000_defines.h @@ -1,7 +1,7 @@ /******************************************************************************* Intel(R) Gigabit Ethernet Linux driver - Copyright(c) 2007 Intel Corporation. + Copyright(c) 2007 - 2008 Intel Corporation. This program is free software; you can redistribute it and/or modify it under the terms and conditions of the GNU General Public License, @@ -90,13 +90,18 @@ #define E1000_I2CCMD_ERROR 0x80000000 #define E1000_MAX_SGMII_PHY_REG_ADDR 255 #define E1000_I2CCMD_PHY_TIMEOUT 200 +#define E1000_IVAR_VALID 0x80 +#define E1000_GPIE_NSICR 0x00000001 +#define E1000_GPIE_MSIX_MODE 0x00000010 +#define E1000_GPIE_EIAME 0x40000000 +#define E1000_GPIE_PBA 0x80000000 -/* Receive Decriptor bit definitions */ +/* Receive Descriptor bit definitions */ #define E1000_RXD_STAT_DD 0x01 /* Descriptor Done */ #define E1000_RXD_STAT_EOP 0x02 /* End of Packet */ #define E1000_RXD_STAT_IXSM 0x04 /* Ignore checksum */ #define E1000_RXD_STAT_VP 0x08 /* IEEE VLAN Packet */ -#define E1000_RXD_STAT_UDPCS 0x10 /* UDP xsum caculated */ +#define E1000_RXD_STAT_UDPCS 0x10 /* UDP xsum calculated */ #define E1000_RXD_STAT_TCPCS 0x20 /* TCP xsum calculated */ #define E1000_RXD_STAT_DYNINT 0x800 /* Pkt caused INT via DYNINT */ #define E1000_RXD_ERR_CE 0x01 /* CRC Error */ @@ -213,6 +218,7 @@ /* Device Control */ #define E1000_CTRL_FD 0x00000001 /* Full duplex.0=half; 1=full */ #define E1000_CTRL_GIO_MASTER_DISABLE 0x00000004 /*Blocks new Master requests */ +#define E1000_CTRL_LRST 0x00000008 /* Link reset. 0=normal,1=reset */ #define E1000_CTRL_ASDE 0x00000020 /* Auto-speed detect enable */ #define E1000_CTRL_SLU 0x00000040 /* Set link up (Force Link) */ #define E1000_CTRL_ILOS 0x00000080 /* Invert Loss-Of Signal */ @@ -244,6 +250,7 @@ */ #define E1000_CONNSW_ENRGSRC 0x4 +#define E1000_PCS_CFG_PCS_EN 8 #define E1000_PCS_LCTL_FLV_LINK_UP 1 #define E1000_PCS_LCTL_FSV_100 2 #define E1000_PCS_LCTL_FSV_1000 4 @@ -253,6 +260,7 @@ #define E1000_PCS_LCTL_AN_ENABLE 0x10000 #define E1000_PCS_LCTL_AN_RESTART 0x20000 #define E1000_PCS_LCTL_AN_TIMEOUT 0x40000 +#define E1000_ENABLE_SERDES_LOOPBACK 0x0410 #define E1000_PCS_LSTS_LINK_OK 1 #define E1000_PCS_LSTS_SPEED_100 2 @@ -340,6 +348,7 @@ #define E1000_RXCSUM_PCSD 0x00002000 /* packet checksum disabled */ /* Header split receive */ +#define E1000_RFCTL_LEF 0x00040000 /* Collision related configuration parameters */ #define E1000_COLLISION_THRESHOLD 15 @@ -359,6 +368,7 @@ #define E1000_PBA_16K 0x0010 /* 16KB, default TX allocation */ #define E1000_PBA_24K 0x0018 #define E1000_PBA_34K 0x0022 +#define E1000_PBA_64K 0x0040 /* 64KB */ #define IFS_MAX 80 #define IFS_MIN 40 @@ -379,7 +389,7 @@ #define E1000_ICR_RXO 0x00000040 /* rx overrun */ #define E1000_ICR_RXT0 0x00000080 /* rx timer intr (ring 0) */ #define E1000_ICR_MDAC 0x00000200 /* MDIO access complete */ -#define E1000_ICR_RXCFG 0x00000400 /* RX /c/ ordered set */ +#define E1000_ICR_RXCFG 0x00000400 /* Rx /c/ ordered set */ #define E1000_ICR_GPI_EN0 0x00000800 /* GP Int 0 */ #define E1000_ICR_GPI_EN1 0x00001000 /* GP Int 1 */ #define E1000_ICR_GPI_EN2 0x00002000 /* GP Int 2 */ @@ -443,12 +453,6 @@ #define E1000_IMS_RXSEQ E1000_ICR_RXSEQ /* rx sequence error */ #define E1000_IMS_RXDMT0 E1000_ICR_RXDMT0 /* rx desc min. threshold */ #define E1000_IMS_RXT0 E1000_ICR_RXT0 /* rx timer intr */ -/* queue 0 Rx descriptor FIFO parity error */ -/* queue 0 Tx descriptor FIFO parity error */ -/* host arb read buffer parity error */ -/* packet buffer parity error */ -/* queue 1 Rx descriptor FIFO parity error */ -/* queue 1 Tx descriptor FIFO parity error */ /* Extended Interrupt Mask Set */ #define E1000_EIMS_TCP_TIMER E1000_EICR_TCP_TIMER /* TCP Timer */ @@ -457,12 +461,6 @@ /* Interrupt Cause Set */ #define E1000_ICS_LSC E1000_ICR_LSC /* Link Status Change */ #define E1000_ICS_RXDMT0 E1000_ICR_RXDMT0 /* rx desc min. threshold */ -/* queue 0 Rx descriptor FIFO parity error */ -/* queue 0 Tx descriptor FIFO parity error */ -/* host arb read buffer parity error */ -/* packet buffer parity error */ -/* queue 1 Rx descriptor FIFO parity error */ -/* queue 1 Tx descriptor FIFO parity error */ /* Extended Interrupt Cause Set */ @@ -539,6 +537,7 @@ /* PHY Control Register */ #define MII_CR_FULL_DUPLEX 0x0100 /* FDX =1, half duplex =0 */ #define MII_CR_RESTART_AUTO_NEG 0x0200 /* Restart auto negotiation */ +#define MII_CR_POWER_DOWN 0x0800 /* Power down */ #define MII_CR_AUTO_NEG_EN 0x1000 /* Auto Neg Enable */ #define MII_CR_LOOPBACK 0x4000 /* 0 = normal, 1 = loopback */ #define MII_CR_RESET 0x8000 /* 0 = normal, 1 = PHY reset */ @@ -567,7 +566,6 @@ /* 1000BASE-T Control Register */ #define CR_1000T_HD_CAPS 0x0100 /* Advertise 1000T HD capability */ #define CR_1000T_FD_CAPS 0x0200 /* Advertise 1000T FD capability */ - /* 0=DTE device */ #define CR_1000T_MS_VALUE 0x0800 /* 1=Configure PHY as Master */ /* 0=Configure PHY as Slave */ #define CR_1000T_MS_ENABLE 0x1000 /* 1=Master/Slave manual config value */ @@ -581,7 +579,7 @@ /* PHY 1000 MII Register/Bit Definitions */ /* PHY Registers defined by IEEE */ #define PHY_CONTROL 0x00 /* Control Register */ -#define PHY_STATUS 0x01 /* Status Regiser */ +#define PHY_STATUS 0x01 /* Status Register */ #define PHY_ID1 0x02 /* Phy Id Reg (word 1) */ #define PHY_ID2 0x03 /* Phy Id Reg (word 2) */ #define PHY_AUTONEG_ADV 0x04 /* Autoneg Advertisement */ @@ -708,8 +706,8 @@ /* Auto crossover enabled all speeds */ #define M88E1000_PSCR_AUTO_X_MODE 0x0060 /* - * 1=Enable Extended 10BASE-T distance (Lower 10BASE-T RX Threshold - * 0=Normal 10BASE-T RX Threshold + * 1=Enable Extended 10BASE-T distance (Lower 10BASE-T Rx Threshold + * 0=Normal 10BASE-T Rx Threshold */ /* 1=5-bit interface in 100BASE-TX, 0=MII interface in 100BASE-TX */ #define M88E1000_PSCR_ASSERT_CRS_ON_TX 0x0800 /* 1=Assert CRS on Transmit */ |