diff options
Diffstat (limited to 'drivers/net/sfc/spi.h')
| -rw-r--r-- | drivers/net/sfc/spi.h | 17 |
1 files changed, 15 insertions, 2 deletions
diff --git a/drivers/net/sfc/spi.h b/drivers/net/sfc/spi.h index b73f86cf5fa2..c4aca132348a 100644 --- a/drivers/net/sfc/spi.h +++ b/drivers/net/sfc/spi.h @@ -25,6 +25,7 @@ #define SPI_WRDI 0x04 /* Reset write enable latch */ #define SPI_RDSR 0x05 /* Read status register */ #define SPI_WREN 0x06 /* Set write enable latch */ +#define SPI_SST_EWSR 0x50 /* SST: Enable write to status register */ #define SPI_STATUS_WPEN 0x80 /* Write-protect pin enabled */ #define SPI_STATUS_BP2 0x10 /* Block protection bit 2 */ @@ -36,6 +37,7 @@ /** * struct efx_spi_device - an Efx SPI (Serial Peripheral Interface) device * @efx: The Efx controller that owns this device + * @mtd: MTD state * @device_id: Controller's id for the device * @size: Size (in bytes) * @addr_len: Number of address bytes in read/write commands @@ -44,20 +46,30 @@ * use bit 3 of the command byte as address bit A8, rather * than having a two-byte address. If this flag is set, then * commands should be munged in this way. + * @erase_command: Erase command (or 0 if sector erase not needed). + * @erase_size: Erase sector size (in bytes) + * Erase commands affect sectors with this size and alignment. + * This must be a power of two. * @block_size: Write block size (in bytes). * Write commands are limited to blocks with this size and alignment. - * @read: Read function for the device - * @write: Write function for the device */ struct efx_spi_device { struct efx_nic *efx; +#ifdef CONFIG_SFC_MTD + void *mtd; +#endif int device_id; unsigned int size; unsigned int addr_len; unsigned int munge_address:1; + u8 erase_command; + unsigned int erase_size; unsigned int block_size; }; +int falcon_spi_cmd(const struct efx_spi_device *spi, unsigned int command, + int address, const void* in, void *out, unsigned int len); +int falcon_spi_fast_wait(const struct efx_spi_device *spi); int falcon_spi_read(const struct efx_spi_device *spi, loff_t start, size_t len, size_t *retlen, u8 *buffer); int falcon_spi_write(const struct efx_spi_device *spi, loff_t start, @@ -77,6 +89,7 @@ int falcon_spi_write(const struct efx_spi_device *spi, loff_t start, * be absent or truncated depending on the devices used. */ #define FALCON_NVCONFIG_END 0x400U +#define FALCON_FLASH_BOOTCODE_START 0x8000U #define EFX_EEPROM_BOOTCONFIG_START 0x800U #define EFX_EEPROM_BOOTCONFIG_END 0x1800U |