diff options
Diffstat (limited to 'drivers/net/sky2.c')
-rw-r--r-- | drivers/net/sky2.c | 116 |
1 files changed, 16 insertions, 100 deletions
diff --git a/drivers/net/sky2.c b/drivers/net/sky2.c index 711e4a8948e0..e24b25ca1c69 100644 --- a/drivers/net/sky2.c +++ b/drivers/net/sky2.c @@ -24,7 +24,6 @@ #include <linux/crc32.h> #include <linux/kernel.h> -#include <linux/version.h> #include <linux/module.h> #include <linux/netdevice.h> #include <linux/dma-mapping.h> @@ -275,86 +274,6 @@ static void sky2_power_aux(struct sky2_hw *hw) PC_VAUX_ON | PC_VCC_OFF)); } -static void sky2_power_state(struct sky2_hw *hw, pci_power_t state) -{ - u16 power_control = sky2_pci_read16(hw, hw->pm_cap + PCI_PM_CTRL); - int pex = pci_find_capability(hw->pdev, PCI_CAP_ID_EXP); - u32 reg; - - sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_ON); - - switch (state) { - case PCI_D0: - break; - - case PCI_D1: - power_control |= 1; - break; - - case PCI_D2: - power_control |= 2; - break; - - case PCI_D3hot: - case PCI_D3cold: - power_control |= 3; - if (hw->flags & SKY2_HW_ADV_POWER_CTL) { - /* additional power saving measurements */ - reg = sky2_pci_read32(hw, PCI_DEV_REG4); - - /* set gating core clock for LTSSM in L1 state */ - reg |= P_PEX_LTSSM_STAT(P_PEX_LTSSM_L1_STAT) | - /* auto clock gated scheme controlled by CLKREQ */ - P_ASPM_A1_MODE_SELECT | - /* enable Gate Root Core Clock */ - P_CLK_GATE_ROOT_COR_ENA; - - if (pex && (hw->flags & SKY2_HW_CLK_POWER)) { - /* enable Clock Power Management (CLKREQ) */ - u16 ctrl = sky2_pci_read16(hw, pex + PCI_EXP_DEVCTL); - - ctrl |= PCI_EXP_DEVCTL_AUX_PME; - sky2_pci_write16(hw, pex + PCI_EXP_DEVCTL, ctrl); - } else - /* force CLKREQ Enable in Our4 (A1b only) */ - reg |= P_ASPM_FORCE_CLKREQ_ENA; - - /* set Mask Register for Release/Gate Clock */ - sky2_pci_write32(hw, PCI_DEV_REG5, - P_REL_PCIE_EXIT_L1_ST | P_GAT_PCIE_ENTER_L1_ST | - P_REL_PCIE_RX_EX_IDLE | P_GAT_PCIE_RX_EL_IDLE | - P_REL_GPHY_LINK_UP | P_GAT_GPHY_LINK_DOWN); - } else - sky2_write8(hw, B28_Y2_ASF_STAT_CMD, Y2_ASF_CLK_HALT); - - /* put CPU into reset state */ - sky2_write8(hw, B28_Y2_ASF_STAT_CMD, HCU_CCSR_ASF_RESET); - if (hw->chip_id == CHIP_ID_YUKON_SUPR && hw->chip_rev == CHIP_REV_YU_SU_A0) - /* put CPU into halt state */ - sky2_write8(hw, B28_Y2_ASF_STAT_CMD, HCU_CCSR_ASF_HALTED); - - if (pex && !(hw->flags & SKY2_HW_RAM_BUFFER)) { - reg = sky2_pci_read32(hw, PCI_DEV_REG1); - /* force to PCIe L1 */ - reg |= PCI_FORCE_PEX_L1; - sky2_pci_write32(hw, PCI_DEV_REG1, reg); - } - break; - - default: - dev_warn(&hw->pdev->dev, PFX "Invalid power state (%d) ", - state); - return; - } - - power_control |= PCI_PM_CTRL_PME_ENABLE; - /* Finally, set the new power state. */ - sky2_pci_write32(hw, hw->pm_cap + PCI_PM_CTRL, power_control); - - sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_OFF); - sky2_pci_read32(hw, B0_CTST); -} - static void sky2_gmac_reset(struct sky2_hw *hw, unsigned port) { u16 reg; @@ -709,6 +628,11 @@ static void sky2_phy_power_up(struct sky2_hw *hw, unsigned port) sky2_pci_write32(hw, PCI_DEV_REG1, reg1); sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_OFF); sky2_pci_read32(hw, PCI_DEV_REG1); + + if (hw->chip_id == CHIP_ID_YUKON_FE) + gm_phy_write(hw, port, PHY_MARV_CTRL, PHY_CT_ANE); + else if (hw->flags & SKY2_HW_ADV_POWER_CTL) + sky2_write8(hw, SK_REG(port, GPHY_CTRL), GPC_RST_CLR); } static void sky2_phy_power_down(struct sky2_hw *hw, unsigned port) @@ -741,11 +665,16 @@ static void sky2_phy_power_down(struct sky2_hw *hw, unsigned port) if (hw->chip_id != CHIP_ID_YUKON_EC) { if (hw->chip_id == CHIP_ID_YUKON_EC_U) { - ctrl = gm_phy_read(hw, port, PHY_MARV_PHY_CTRL); + /* select page 2 to access MAC control register */ + gm_phy_write(hw, port, PHY_MARV_EXT_ADR, 2); + ctrl = gm_phy_read(hw, port, PHY_MARV_PHY_CTRL); /* enable Power Down */ ctrl |= PHY_M_PC_POW_D_ENA; gm_phy_write(hw, port, PHY_MARV_PHY_CTRL, ctrl); + + /* set page register back to 0 */ + gm_phy_write(hw, port, PHY_MARV_EXT_ADR, 0); } /* set IEEE compatible Power Down Mode (dev. #4.99) */ @@ -1829,9 +1758,6 @@ static int sky2_down(struct net_device *dev) if (netif_msg_ifdown(sky2)) printk(KERN_INFO PFX "%s: disabling interface\n", dev->name); - /* Stop more packets from being queued */ - netif_stop_queue(dev); - /* Disable port IRQ */ imask = sky2_read32(hw, B0_IMSK); imask &= ~portirq_msk[port]; @@ -1887,8 +1813,6 @@ static int sky2_down(struct net_device *dev) sky2_phy_power_down(hw, port); - netif_carrier_off(dev); - /* turn off LED's */ sky2_write16(hw, B0_Y2LED, LED_STAT_OFF); @@ -2860,10 +2784,6 @@ static int __devinit sky2_init(struct sky2_hw *hw) hw->flags = SKY2_HW_GIGABIT | SKY2_HW_NEWER_PHY | SKY2_HW_ADV_POWER_CTL; - - /* check for Rev. A1 dev 4200 */ - if (sky2_read16(hw, Q_ADDR(Q_XA1, Q_WM)) == 0) - hw->flags |= SKY2_HW_CLK_POWER; break; case CHIP_ID_YUKON_EX: @@ -2919,12 +2839,6 @@ static int __devinit sky2_init(struct sky2_hw *hw) if (hw->pmd_type == 'L' || hw->pmd_type == 'S' || hw->pmd_type == 'P') hw->flags |= SKY2_HW_FIBRE_PHY; - hw->pm_cap = pci_find_capability(hw->pdev, PCI_CAP_ID_PM); - if (hw->pm_cap == 0) { - dev_err(&hw->pdev->dev, "cannot find PowerManagement capability\n"); - return -EIO; - } - hw->ports = 1; t8 = sky2_read8(hw, B2_Y2_HW_RES); if ((t8 & CFG_DUAL_MAC_MSK) == CFG_DUAL_MAC_MSK) { @@ -4517,7 +4431,7 @@ static int sky2_suspend(struct pci_dev *pdev, pm_message_t state) pci_save_state(pdev); pci_enable_wake(pdev, pci_choose_state(pdev, state), wol); - sky2_power_state(hw, pci_choose_state(pdev, state)); + pci_set_power_state(pdev, pci_choose_state(pdev, state)); return 0; } @@ -4530,7 +4444,9 @@ static int sky2_resume(struct pci_dev *pdev) if (!hw) return 0; - sky2_power_state(hw, PCI_D0); + err = pci_set_power_state(pdev, PCI_D0); + if (err) + goto out; err = pci_restore_state(pdev); if (err) @@ -4600,7 +4516,7 @@ static void sky2_shutdown(struct pci_dev *pdev) pci_enable_wake(pdev, PCI_D3cold, wol); pci_disable_device(pdev); - sky2_power_state(hw, PCI_D3hot); + pci_set_power_state(pdev, PCI_D3hot); } static struct pci_driver sky2_driver = { |