diff options
Diffstat (limited to 'drivers/net/wireless/ath9k/pci.c')
| -rw-r--r-- | drivers/net/wireless/ath9k/pci.c | 295 |
1 files changed, 295 insertions, 0 deletions
diff --git a/drivers/net/wireless/ath9k/pci.c b/drivers/net/wireless/ath9k/pci.c new file mode 100644 index 000000000000..6dbc58580abb --- /dev/null +++ b/drivers/net/wireless/ath9k/pci.c @@ -0,0 +1,295 @@ +/* + * Copyright (c) 2008-2009 Atheros Communications Inc. + * + * Permission to use, copy, modify, and/or distribute this software for any + * purpose with or without fee is hereby granted, provided that the above + * copyright notice and this permission notice appear in all copies. + * + * THE SOFTWARE IS PROVIDED "AS IS" AND THE AUTHOR DISCLAIMS ALL WARRANTIES + * WITH REGARD TO THIS SOFTWARE INCLUDING ALL IMPLIED WARRANTIES OF + * MERCHANTABILITY AND FITNESS. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR + * ANY SPECIAL, DIRECT, INDIRECT, OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES + * WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS, WHETHER IN AN + * ACTION OF CONTRACT, NEGLIGENCE OR OTHER TORTIOUS ACTION, ARISING OUT OF + * OR IN CONNECTION WITH THE USE OR PERFORMANCE OF THIS SOFTWARE. + */ + +#include <linux/nl80211.h> +#include <linux/pci.h> +#include "ath9k.h" + +static struct pci_device_id ath_pci_id_table[] __devinitdata = { + { PCI_VDEVICE(ATHEROS, 0x0023) }, /* PCI */ + { PCI_VDEVICE(ATHEROS, 0x0024) }, /* PCI-E */ + { PCI_VDEVICE(ATHEROS, 0x0027) }, /* PCI */ + { PCI_VDEVICE(ATHEROS, 0x0029) }, /* PCI */ + { PCI_VDEVICE(ATHEROS, 0x002A) }, /* PCI-E */ + { PCI_VDEVICE(ATHEROS, 0x002B) }, /* PCI-E */ + { 0 } +}; + +/* return bus cachesize in 4B word units */ +static void ath_pci_read_cachesize(struct ath_softc *sc, int *csz) +{ + u8 u8tmp; + + pci_read_config_byte(to_pci_dev(sc->dev), PCI_CACHE_LINE_SIZE, + (u8 *)&u8tmp); + *csz = (int)u8tmp; + + /* + * This check was put in to avoid "unplesant" consequences if + * the bootrom has not fully initialized all PCI devices. + * Sometimes the cache line size register is not set + */ + + if (*csz == 0) + *csz = DEFAULT_CACHELINE >> 2; /* Use the default size */ +} + +static void ath_pci_cleanup(struct ath_softc *sc) +{ + struct pci_dev *pdev = to_pci_dev(sc->dev); + + pci_iounmap(pdev, sc->mem); + pci_disable_device(pdev); + pci_release_region(pdev, 0); +} + +static bool ath_pci_eeprom_read(struct ath_hw *ah, u32 off, u16 *data) +{ + (void)REG_READ(ah, AR5416_EEPROM_OFFSET + (off << AR5416_EEPROM_S)); + + if (!ath9k_hw_wait(ah, + AR_EEPROM_STATUS_DATA, + AR_EEPROM_STATUS_DATA_BUSY | + AR_EEPROM_STATUS_DATA_PROT_ACCESS, 0, + AH_WAIT_TIMEOUT)) { + return false; + } + + *data = MS(REG_READ(ah, AR_EEPROM_STATUS_DATA), + AR_EEPROM_STATUS_DATA_VAL); + + return true; +} + +static struct ath_bus_ops ath_pci_bus_ops = { + .read_cachesize = ath_pci_read_cachesize, + .cleanup = ath_pci_cleanup, + .eeprom_read = ath_pci_eeprom_read, +}; + +static int ath_pci_probe(struct pci_dev *pdev, const struct pci_device_id *id) +{ + void __iomem *mem; + struct ath_wiphy *aphy; + struct ath_softc *sc; + struct ieee80211_hw *hw; + u8 csz; + int ret = 0; + struct ath_hw *ah; + + if (pci_enable_device(pdev)) + return -EIO; + + ret = pci_set_dma_mask(pdev, DMA_32BIT_MASK); + + if (ret) { + printk(KERN_ERR "ath9k: 32-bit DMA not available\n"); + goto bad; + } + + ret = pci_set_consistent_dma_mask(pdev, DMA_32BIT_MASK); + + if (ret) { + printk(KERN_ERR "ath9k: 32-bit DMA consistent " + "DMA enable failed\n"); + goto bad; + } + + /* + * Cache line size is used to size and align various + * structures used to communicate with the hardware. + */ + pci_read_config_byte(pdev, PCI_CACHE_LINE_SIZE, &csz); + if (csz == 0) { + /* + * Linux 2.4.18 (at least) writes the cache line size + * register as a 16-bit wide register which is wrong. + * We must have this setup properly for rx buffer + * DMA to work so force a reasonable value here if it + * comes up zero. + */ + csz = L1_CACHE_BYTES / sizeof(u32); + pci_write_config_byte(pdev, PCI_CACHE_LINE_SIZE, csz); + } + /* + * The default setting of latency timer yields poor results, + * set it to the value used by other systems. It may be worth + * tweaking this setting more. + */ + pci_write_config_byte(pdev, PCI_LATENCY_TIMER, 0xa8); + + pci_set_master(pdev); + + ret = pci_request_region(pdev, 0, "ath9k"); + if (ret) { + dev_err(&pdev->dev, "PCI memory region reserve error\n"); + ret = -ENODEV; + goto bad; + } + + mem = pci_iomap(pdev, 0, 0); + if (!mem) { + printk(KERN_ERR "PCI memory map error\n") ; + ret = -EIO; + goto bad1; + } + + hw = ieee80211_alloc_hw(sizeof(struct ath_wiphy) + + sizeof(struct ath_softc), &ath9k_ops); + if (hw == NULL) { + printk(KERN_ERR "ath_pci: no memory for ieee80211_hw\n"); + goto bad2; + } + + SET_IEEE80211_DEV(hw, &pdev->dev); + pci_set_drvdata(pdev, hw); + + aphy = hw->priv; + sc = (struct ath_softc *) (aphy + 1); + aphy->sc = sc; + aphy->hw = hw; + sc->pri_wiphy = aphy; + sc->hw = hw; + sc->dev = &pdev->dev; + sc->mem = mem; + sc->bus_ops = &ath_pci_bus_ops; + + if (ath_attach(id->device, sc) != 0) { + ret = -ENODEV; + goto bad3; + } + + /* setup interrupt service routine */ + + if (request_irq(pdev->irq, ath_isr, IRQF_SHARED, "ath", sc)) { + printk(KERN_ERR "%s: request_irq failed\n", + wiphy_name(hw->wiphy)); + ret = -EIO; + goto bad4; + } + + sc->irq = pdev->irq; + + ah = sc->sc_ah; + printk(KERN_INFO + "%s: Atheros AR%s MAC/BB Rev:%x " + "AR%s RF Rev:%x: mem=0x%lx, irq=%d\n", + wiphy_name(hw->wiphy), + ath_mac_bb_name(ah->hw_version.macVersion), + ah->hw_version.macRev, + ath_rf_name((ah->hw_version.analog5GhzRev & AR_RADIO_SREV_MAJOR)), + ah->hw_version.phyRev, + (unsigned long)mem, pdev->irq); + + return 0; +bad4: + ath_detach(sc); +bad3: + ieee80211_free_hw(hw); +bad2: + pci_iounmap(pdev, mem); +bad1: + pci_release_region(pdev, 0); +bad: + pci_disable_device(pdev); + return ret; +} + +static void ath_pci_remove(struct pci_dev *pdev) +{ + struct ieee80211_hw *hw = pci_get_drvdata(pdev); + struct ath_wiphy *aphy = hw->priv; + struct ath_softc *sc = aphy->sc; + + ath_cleanup(sc); +} + +#ifdef CONFIG_PM + +static int ath_pci_suspend(struct pci_dev *pdev, pm_message_t state) +{ + struct ieee80211_hw *hw = pci_get_drvdata(pdev); + struct ath_wiphy *aphy = hw->priv; + struct ath_softc *sc = aphy->sc; + + ath9k_hw_set_gpio(sc->sc_ah, ATH_LED_PIN, 1); + +#if defined(CONFIG_RFKILL) || defined(CONFIG_RFKILL_MODULE) + if (sc->sc_ah->caps.hw_caps & ATH9K_HW_CAP_RFSILENT) + cancel_delayed_work_sync(&sc->rf_kill.rfkill_poll); +#endif + + pci_save_state(pdev); + pci_disable_device(pdev); + pci_set_power_state(pdev, PCI_D3hot); + + return 0; +} + +static int ath_pci_resume(struct pci_dev *pdev) +{ + struct ieee80211_hw *hw = pci_get_drvdata(pdev); + struct ath_wiphy *aphy = hw->priv; + struct ath_softc *sc = aphy->sc; + int err; + + err = pci_enable_device(pdev); + if (err) + return err; + pci_restore_state(pdev); + + /* Enable LED */ + ath9k_hw_cfg_output(sc->sc_ah, ATH_LED_PIN, + AR_GPIO_OUTPUT_MUX_AS_OUTPUT); + ath9k_hw_set_gpio(sc->sc_ah, ATH_LED_PIN, 1); + +#if defined(CONFIG_RFKILL) || defined(CONFIG_RFKILL_MODULE) + /* + * check the h/w rfkill state on resume + * and start the rfkill poll timer + */ + if (sc->sc_ah->caps.hw_caps & ATH9K_HW_CAP_RFSILENT) + queue_delayed_work(sc->hw->workqueue, + &sc->rf_kill.rfkill_poll, 0); +#endif + + return 0; +} + +#endif /* CONFIG_PM */ + +MODULE_DEVICE_TABLE(pci, ath_pci_id_table); + +static struct pci_driver ath_pci_driver = { + .name = "ath9k", + .id_table = ath_pci_id_table, + .probe = ath_pci_probe, + .remove = ath_pci_remove, +#ifdef CONFIG_PM + .suspend = ath_pci_suspend, + .resume = ath_pci_resume, +#endif /* CONFIG_PM */ +}; + +int ath_pci_init(void) +{ + return pci_register_driver(&ath_pci_driver); +} + +void ath_pci_exit(void) +{ + pci_unregister_driver(&ath_pci_driver); +} |