diff options
Diffstat (limited to 'drivers/scsi/aic7xxx_old.c')
| -rw-r--r-- | drivers/scsi/aic7xxx_old.c | 12 |
1 files changed, 6 insertions, 6 deletions
diff --git a/drivers/scsi/aic7xxx_old.c b/drivers/scsi/aic7xxx_old.c index 4ff60a08df0f..5b212f0df898 100644 --- a/drivers/scsi/aic7xxx_old.c +++ b/drivers/scsi/aic7xxx_old.c @@ -905,7 +905,7 @@ struct aic_dev_data { * problems with architectures I can't test on (because I don't have one, * such as the Alpha based systems) which happen to give faults for * non-aligned memory accesses, care was taken to align this structure - * in a way that gauranteed all accesses larger than 8 bits were aligned + * in a way that guaranteed all accesses larger than 8 bits were aligned * on the appropriate boundary. It's also organized to try and be more * cache line efficient. Be careful when changing this lest you might hurt * overall performance and bring down the wrath of the masses. @@ -1180,7 +1180,7 @@ static int aic7xxx_pci_parity = 0; * the card's registers in a hex dump format tailored to each model of * controller. * - * NOTE: THE CONTROLLER IS LEFT IN AN UNUSEABLE STATE BY THIS OPTION. + * NOTE: THE CONTROLLER IS LEFT IN AN UNUSABLE STATE BY THIS OPTION. * YOU CANNOT BOOT UP WITH THIS OPTION, IT IS FOR DEBUGGING PURPOSES * ONLY */ @@ -3467,7 +3467,7 @@ aic7xxx_reset_current_bus(struct aic7xxx_host *p) /* Turn off the bus' current operations, after all, we shouldn't have any * valid commands left to cause a RSELI and SELO once we've tossed the * bus away with this reset, so we might as well shut down the sequencer - * until the bus is restarted as oppossed to saving the current settings + * until the bus is restarted as opposed to saving the current settings * and restoring them (which makes no sense to me). */ /* Turn on the bus reset. */ @@ -4070,7 +4070,7 @@ aic7xxx_handle_seqint(struct aic7xxx_host *p, unsigned char intstat) aic_dev->max_q_depth = aic_dev->temp_q_depth = 1; /* * We set this command up as a bus device reset. However, we have - * to clear the tag type as it's causing us problems. We shouldnt + * to clear the tag type as it's causing us problems. We shouldn't * have to worry about any other commands being active, since if * the device is refusing tagged commands, this should be the * first tagged command sent to the device, however, we do have @@ -9748,7 +9748,7 @@ skip_pci_controller: } /* - * We are commited now, everything has been checked and this card + * We are committed now, everything has been checked and this card * has been found, now we just set it up */ @@ -9906,7 +9906,7 @@ skip_pci_controller: * 2: All PCI controllers with BIOS_ENABLED next, according to BIOS * address, going from lowest to highest. * 3: Remaining VLB/EISA controllers going in slot order. - * 4: Remaining PCI controllers, going in PCI device order (reversable) + * 4: Remaining PCI controllers, going in PCI device order (reversible) */ { |