diff options
Diffstat (limited to 'drivers/spi/Kconfig')
| -rw-r--r-- | drivers/spi/Kconfig | 38 |
1 files changed, 31 insertions, 7 deletions
diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig index d895a1adb428..9052f4c3493b 100644 --- a/drivers/spi/Kconfig +++ b/drivers/spi/Kconfig @@ -75,6 +75,13 @@ config SPI_BUTTERFLY inexpensive battery powered microcontroller evaluation board. This same cable can be used to flash new firmware. +config SPI_IMX + tristate "Freescale iMX SPI controller" + depends on SPI_MASTER && ARCH_IMX && EXPERIMENTAL + help + This enables using the Freescale iMX SPI controller in master + mode. + config SPI_MPC83xx tristate "Freescale MPC83xx SPI controller" depends on SPI_MASTER && PPC_83xx && EXPERIMENTAL @@ -87,6 +94,14 @@ config SPI_MPC83xx family of PowerPC processors. The MPC83xx uses a simple set of shift registers for data (opposed to the CPM based descriptor model). +config SPI_OMAP_UWIRE + tristate "OMAP1 MicroWire" + depends on SPI_MASTER && ARCH_OMAP1 + select SPI_BITBANG + help + This hooks up to the MicroWire controller on OMAP1 chips. + + config SPI_PXA2XX tristate "PXA2xx SSP SPI master" depends on SPI_MASTER && ARCH_PXA && EXPERIMENTAL @@ -95,6 +110,12 @@ config SPI_PXA2XX The driver can be configured to use any SSP port and additional documentation can be found a Documentation/spi/pxa2xx. +config SPI_S3C24XX + tristate "Samsung S3C24XX series SPI" + depends on SPI_MASTER && ARCH_S3C2410 && EXPERIMENTAL + help + SPI driver for Samsung S3C24XX series ARM SoCs + config SPI_S3C24XX_GPIO tristate "Samsung S3C24XX series SPI by GPIO" depends on SPI_MASTER && ARCH_S3C2410 && SPI_BITBANG && EXPERIMENTAL @@ -107,13 +128,6 @@ config SPI_S3C24XX_GPIO # Add new SPI master controllers in alphabetical order above this line # - -config SPI_S3C24XX - tristate "Samsung S3C24XX series SPI" - depends on SPI_MASTER && ARCH_S3C2410 && EXPERIMENTAL - help - SPI driver for Samsung S3C24XX series ARM SoCs - # # There are lots of SPI device types, with sensors and memory # being probably the most widely used ones. @@ -121,6 +135,16 @@ config SPI_S3C24XX comment "SPI Protocol Masters" depends on SPI_MASTER +config SPI_AT25 + tristate "SPI EEPROMs from most vendors" + depends on SPI_MASTER && SYSFS + help + Enable this driver to get read/write support to most SPI EEPROMs, + after you configure the board init code to know about each eeprom + on your target board. + + This driver can also be built as a module. If so, the module + will be called at25. # # Add new SPI protocol masters in alphabetical order above this line |