diff options
Diffstat (limited to 'drivers/spi')
| -rw-r--r-- | drivers/spi/spi-pci1xxxx.c | 145 |
1 files changed, 145 insertions, 0 deletions
diff --git a/drivers/spi/spi-pci1xxxx.c b/drivers/spi/spi-pci1xxxx.c index 5b2d3e4e21b7..85a6068b244d 100644 --- a/drivers/spi/spi-pci1xxxx.c +++ b/drivers/spi/spi-pci1xxxx.c @@ -5,7 +5,12 @@ // Kumaravel Thiagarajan <Kumaravel.Thiagarajan@microchip.com> +#include <linux/dma-mapping.h> +#include <linux/iopoll.h> +#include <linux/irq.h> #include <linux/module.h> +#include <linux/msi.h> +#include <linux/pci_regs.h> #include <linux/pci.h> #include <linux/spi/spi.h> #include <linux/delay.h> @@ -32,8 +37,33 @@ #define SPI_MST_CTL_MODE_SEL (BIT(2)) #define SPI_MST_CTL_GO (BIT(0)) +#define SPI_SYSTEM_ADDR_BASE (0x2000) #define SPI_MST1_ADDR_BASE (0x800) +#define DEV_REV_REG (SPI_SYSTEM_ADDR_BASE + 0x00) +#define SPI_SYSLOCK_REG (SPI_SYSTEM_ADDR_BASE + 0xA0) +#define SPI_CONFIG_PERI_ENABLE_REG (SPI_SYSTEM_ADDR_BASE + 0x108) + +#define SPI_PERI_ENBLE_PF_MASK (GENMASK(17, 16)) +#define DEV_REV_MASK (GENMASK(7, 0)) + +#define SPI_SYSLOCK BIT(4) + +/* DMA Related Registers */ +#define SPI_DMA_ADDR_BASE (0x1000) +#define SPI_DMA_GLOBAL_WR_ENGINE_EN (SPI_DMA_ADDR_BASE + 0x0C) +#define SPI_DMA_GLOBAL_RD_ENGINE_EN (SPI_DMA_ADDR_BASE + 0x2C) +#define SPI_DMA_INTR_IMWR_WDONE_LOW (SPI_DMA_ADDR_BASE + 0x60) +#define SPI_DMA_INTR_IMWR_WDONE_HIGH (SPI_DMA_ADDR_BASE + 0x64) +#define SPI_DMA_INTR_IMWR_WABORT_LOW (SPI_DMA_ADDR_BASE + 0x68) +#define SPI_DMA_INTR_IMWR_WABORT_HIGH (SPI_DMA_ADDR_BASE + 0x6C) +#define SPI_DMA_INTR_WR_IMWR_DATA (SPI_DMA_ADDR_BASE + 0x70) +#define SPI_DMA_INTR_IMWR_RDONE_LOW (SPI_DMA_ADDR_BASE + 0xCC) +#define SPI_DMA_INTR_IMWR_RDONE_HIGH (SPI_DMA_ADDR_BASE + 0xD0) +#define SPI_DMA_INTR_IMWR_RABORT_LOW (SPI_DMA_ADDR_BASE + 0xD4) +#define SPI_DMA_INTR_IMWR_RABORT_HIGH (SPI_DMA_ADDR_BASE + 0xD8) +#define SPI_DMA_INTR_RD_IMWR_DATA (SPI_DMA_ADDR_BASE + 0xDC) + /* x refers to SPI Host Controller HW instance id in the below macros - 0 or 1 */ #define SPI_MST_CMD_BUF_OFFSET(x) (((x) * SPI_MST1_ADDR_BASE) + 0x00) @@ -50,6 +80,8 @@ #define SPI_MAX_DATA_LEN 320 #define PCI1XXXX_SPI_TIMEOUT (msecs_to_jiffies(100)) +#define SYSLOCK_RETRY_CNT (1000) +#define SPI_DMA_ENGINE_EN (0x1) #define SPI_INTR BIT(8) #define SPI_FORCE_CE BIT(4) @@ -76,7 +108,10 @@ struct pci1xxxx_spi_internal { struct pci1xxxx_spi { struct pci_dev *dev; u8 total_hw_instances; + u8 dev_rev; void __iomem *reg_base; + void __iomem *dma_offset_bar; + bool can_dma; struct pci1xxxx_spi_internal *spi_int[] __counted_by(total_hw_instances); }; @@ -106,6 +141,112 @@ static const struct pci_device_id pci1xxxx_spi_pci_id_table[] = { MODULE_DEVICE_TABLE(pci, pci1xxxx_spi_pci_id_table); +static int pci1xxxx_set_sys_lock(struct pci1xxxx_spi *par) +{ + writel(SPI_SYSLOCK, par->reg_base + SPI_SYSLOCK_REG); + return readl(par->reg_base + SPI_SYSLOCK_REG); +} + +static int pci1xxxx_acquire_sys_lock(struct pci1xxxx_spi *par) +{ + u32 regval; + + return readx_poll_timeout(pci1xxxx_set_sys_lock, par, regval, + (regval & SPI_SYSLOCK), 100, + SYSLOCK_RETRY_CNT * 100); +} + +static void pci1xxxx_release_sys_lock(struct pci1xxxx_spi *par) +{ + writel(0x0, par->reg_base + SPI_SYSLOCK_REG); +} + +static int pci1xxxx_check_spi_can_dma(struct pci1xxxx_spi *spi_bus, int irq) +{ + struct pci_dev *pdev = spi_bus->dev; + u32 pf_num; + u32 regval; + int ret; + + /* + * DEV REV Registers is a system register, HW Syslock bit + * should be acquired before accessing the register + */ + ret = pci1xxxx_acquire_sys_lock(spi_bus); + if (ret) { + dev_err(&pdev->dev, "Error failed to acquire syslock\n"); + return ret; + } + + regval = readl(spi_bus->reg_base + DEV_REV_REG); + spi_bus->dev_rev = regval & DEV_REV_MASK; + if (spi_bus->dev_rev >= 0xC0) { + regval = readl(spi_bus->reg_base + + SPI_CONFIG_PERI_ENABLE_REG); + pf_num = regval & SPI_PERI_ENBLE_PF_MASK; + } + + pci1xxxx_release_sys_lock(spi_bus); + + /* + * DMA is supported only from C0 and SPI can use DMA only if + * it is mapped to PF0 + */ + if (spi_bus->dev_rev < 0xC0 || pf_num) + return -EOPNOTSUPP; + + /* + * DMA Supported only with MSI Interrupts + * One of the SPI instance's MSI vector address and data + * is used for DMA Interrupt + */ + if (!irq_get_msi_desc(irq)) { + dev_warn(&pdev->dev, "Error MSI Interrupt not supported, will operate in PIO mode\n"); + return -EOPNOTSUPP; + } + + spi_bus->dma_offset_bar = pcim_iomap(pdev, 2, pci_resource_len(pdev, 2)); + if (!spi_bus->dma_offset_bar) { + dev_warn(&pdev->dev, "Error failed to map dma bar, will operate in PIO mode\n"); + return -EOPNOTSUPP; + } + + if (dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(64))) { + dev_warn(&pdev->dev, "Error failed to set DMA mask, will operate in PIO mode\n"); + pcim_iounmap(pdev, spi_bus->dma_offset_bar); + spi_bus->dma_offset_bar = NULL; + return -EOPNOTSUPP; + } + + return 0; +} + +static int pci1xxxx_spi_dma_init(struct pci1xxxx_spi *spi_bus, int irq) +{ + struct msi_msg msi; + int ret; + + ret = pci1xxxx_check_spi_can_dma(spi_bus, irq); + if (ret) + return ret; + + get_cached_msi_msg(irq, &msi); + writel(SPI_DMA_ENGINE_EN, spi_bus->dma_offset_bar + SPI_DMA_GLOBAL_WR_ENGINE_EN); + writel(SPI_DMA_ENGINE_EN, spi_bus->dma_offset_bar + SPI_DMA_GLOBAL_RD_ENGINE_EN); + writel(msi.address_hi, spi_bus->dma_offset_bar + SPI_DMA_INTR_IMWR_WDONE_HIGH); + writel(msi.address_hi, spi_bus->dma_offset_bar + SPI_DMA_INTR_IMWR_WABORT_HIGH); + writel(msi.address_hi, spi_bus->dma_offset_bar + SPI_DMA_INTR_IMWR_RDONE_HIGH); + writel(msi.address_hi, spi_bus->dma_offset_bar + SPI_DMA_INTR_IMWR_RABORT_HIGH); + writel(msi.address_lo, spi_bus->dma_offset_bar + SPI_DMA_INTR_IMWR_WDONE_LOW); + writel(msi.address_lo, spi_bus->dma_offset_bar + SPI_DMA_INTR_IMWR_WABORT_LOW); + writel(msi.address_lo, spi_bus->dma_offset_bar + SPI_DMA_INTR_IMWR_RDONE_LOW); + writel(msi.address_lo, spi_bus->dma_offset_bar + SPI_DMA_INTR_IMWR_RABORT_LOW); + writel(msi.data, spi_bus->dma_offset_bar + SPI_DMA_INTR_WR_IMWR_DATA); + writel(msi.data, spi_bus->dma_offset_bar + SPI_DMA_INTR_RD_IMWR_DATA); + spi_bus->can_dma = true; + return 0; +} + static void pci1xxxx_spi_set_cs(struct spi_device *spi, bool enable) { struct pci1xxxx_spi_internal *p = spi_controller_get_devdata(spi->controller); @@ -324,6 +465,10 @@ static int pci1xxxx_spi_probe(struct pci_dev *pdev, const struct pci_device_id * goto error; } + ret = pci1xxxx_spi_dma_init(spi_bus, spi_sub_ptr->irq); + if (ret && ret != -EOPNOTSUPP) + return ret; + /* This register is only applicable for 1st instance */ regval = readl(spi_bus->reg_base + SPI_PCI_CTRL_REG_OFFSET(0)); if (!only_sec_inst) |