summaryrefslogtreecommitdiffstats
path: root/drivers
diff options
context:
space:
mode:
Diffstat (limited to 'drivers')
-rw-r--r--drivers/usb/musb/tusb6010.c13
-rw-r--r--drivers/usb/musb/tusb6010_omap.c22
2 files changed, 27 insertions, 8 deletions
diff --git a/drivers/usb/musb/tusb6010.c b/drivers/usb/musb/tusb6010.c
index ab776a8d98ca..60d3938cafcf 100644
--- a/drivers/usb/musb/tusb6010.c
+++ b/drivers/usb/musb/tusb6010.c
@@ -29,6 +29,19 @@ static void tusb_source_power(struct musb *musb, int is_on);
#define TUSB_REV_MAJOR(reg_val) ((reg_val >> 4) & 0xf)
#define TUSB_REV_MINOR(reg_val) (reg_val & 0xf)
+#ifdef CONFIG_PM
+/* REVISIT: These should be only needed if somebody implements off idle */
+void musb_platform_save_context(struct musb *musb,
+ struct musb_context_registers *musb_context)
+{
+}
+
+void musb_platform_restore_context(struct musb *musb,
+ struct musb_context_registers *musb_context)
+{
+}
+#endif
+
/*
* Checks the revision. We need to use the DMA register as 3.0 does not
* have correct versions for TUSB_PRCM_REV or TUSB_INT_CTRL_REV.
diff --git a/drivers/usb/musb/tusb6010_omap.c b/drivers/usb/musb/tusb6010_omap.c
index 5afa070d7dc9..c061a88f2b0f 100644
--- a/drivers/usb/musb/tusb6010_omap.c
+++ b/drivers/usb/musb/tusb6010_omap.c
@@ -39,7 +39,7 @@ struct tusb_omap_dma_ch {
struct tusb_omap_dma *tusb_dma;
- void __iomem *dma_addr;
+ dma_addr_t dma_addr;
u32 len;
u16 packet_sz;
@@ -126,6 +126,7 @@ static void tusb_omap_dma_cb(int lch, u16 ch_status, void *data)
struct tusb_omap_dma_ch *chdat = to_chdat(channel);
struct tusb_omap_dma *tusb_dma = chdat->tusb_dma;
struct musb *musb = chdat->musb;
+ struct device *dev = musb->controller;
struct musb_hw_ep *hw_ep = chdat->hw_ep;
void __iomem *ep_conf = hw_ep->conf;
void __iomem *mbase = musb->mregs;
@@ -173,13 +174,15 @@ static void tusb_omap_dma_cb(int lch, u16 ch_status, void *data)
DBG(3, "Using PIO for remaining %lu bytes\n", pio);
buf = phys_to_virt((u32)chdat->dma_addr) + chdat->transfer_len;
if (chdat->tx) {
- dma_cache_maint(phys_to_virt((u32)chdat->dma_addr),
- chdat->transfer_len, DMA_TO_DEVICE);
+ dma_unmap_single(dev, chdat->dma_addr,
+ chdat->transfer_len,
+ DMA_TO_DEVICE);
musb_write_fifo(hw_ep, pio, buf);
} else {
+ dma_unmap_single(dev, chdat->dma_addr,
+ chdat->transfer_len,
+ DMA_FROM_DEVICE);
musb_read_fifo(hw_ep, pio, buf);
- dma_cache_maint(phys_to_virt((u32)chdat->dma_addr),
- chdat->transfer_len, DMA_FROM_DEVICE);
}
channel->actual_len += pio;
}
@@ -224,6 +227,7 @@ static int tusb_omap_dma_program(struct dma_channel *channel, u16 packet_sz,
struct tusb_omap_dma_ch *chdat = to_chdat(channel);
struct tusb_omap_dma *tusb_dma = chdat->tusb_dma;
struct musb *musb = chdat->musb;
+ struct device *dev = musb->controller;
struct musb_hw_ep *hw_ep = chdat->hw_ep;
void __iomem *mbase = musb->mregs;
void __iomem *ep_conf = hw_ep->conf;
@@ -299,14 +303,16 @@ static int tusb_omap_dma_program(struct dma_channel *channel, u16 packet_sz,
chdat->packet_sz = packet_sz;
chdat->len = len;
channel->actual_len = 0;
- chdat->dma_addr = (void __iomem *)dma_addr;
+ chdat->dma_addr = dma_addr;
channel->status = MUSB_DMA_STATUS_BUSY;
/* Since we're recycling dma areas, we need to clean or invalidate */
if (chdat->tx)
- dma_cache_maint(phys_to_virt(dma_addr), len, DMA_TO_DEVICE);
+ dma_map_single(dev, phys_to_virt(dma_addr), len,
+ DMA_TO_DEVICE);
else
- dma_cache_maint(phys_to_virt(dma_addr), len, DMA_FROM_DEVICE);
+ dma_map_single(dev, phys_to_virt(dma_addr), len,
+ DMA_FROM_DEVICE);
/* Use 16-bit transfer if dma_addr is not 32-bit aligned */
if ((dma_addr & 0x3) == 0) {