diff options
Diffstat (limited to 'include/acpi/acrestyp.h')
| -rw-r--r-- | include/acpi/acrestyp.h | 207 |
1 files changed, 203 insertions, 4 deletions
diff --git a/include/acpi/acrestyp.h b/include/acpi/acrestyp.h index 0a66cc45dd6b..3506e39a66b1 100644 --- a/include/acpi/acrestyp.h +++ b/include/acpi/acrestyp.h @@ -61,11 +61,14 @@ typedef u32 acpi_rsdesc_size; /* Max Resource Descriptor size is (Length+3) = (6 #define ACPI_WRITE_COMBINING_MEMORY (u8) 0x02 #define ACPI_PREFETCHABLE_MEMORY (u8) 0x03 +/*! [Begin] no source code translation */ /* * IO Attributes - * The ISA IO ranges are: n000-n0_fFh, n400-n4_fFh, n800-n8_fFh, n_c00-n_cFFh. - * The non-ISA IO ranges are: n100-n3_fFh, n500-n7_fFh, n900-n_bFFh, n_cd0-n_fFFh. + * The ISA IO ranges are: n000-n0FFh, n400-n4FFh, n800-n8FFh, nC00-nCFFh. + * The non-ISA IO ranges are: n100-n3FFh, n500-n7FFh, n900-nBFFh, nCD0-nFFFh. */ +/*! [End] no source code translation !*/ + #define ACPI_NON_ISA_ONLY_RANGES (u8) 0x01 #define ACPI_ISA_ONLY_RANGES (u8) 0x02 #define ACPI_ENTIRE_RANGE (ACPI_NON_ISA_ONLY_RANGES | ACPI_ISA_ONLY_RANGES) @@ -81,16 +84,26 @@ typedef u32 acpi_rsdesc_size; /* Max Resource Descriptor size is (Length+3) = (6 #define ACPI_DECODE_16 (u8) 0x01 /* 16-bit IO address decode */ /* - * IRQ Attributes + * Interrupt attributes - used in multiple descriptors */ + +/* Triggering */ + #define ACPI_LEVEL_SENSITIVE (u8) 0x00 #define ACPI_EDGE_SENSITIVE (u8) 0x01 +/* Polarity */ + #define ACPI_ACTIVE_HIGH (u8) 0x00 #define ACPI_ACTIVE_LOW (u8) 0x01 +#define ACPI_ACTIVE_BOTH (u8) 0x02 + +/* Sharing */ #define ACPI_EXCLUSIVE (u8) 0x00 #define ACPI_SHARED (u8) 0x01 +#define ACPI_EXCLUSIVE_AND_WAKE (u8) 0x02 +#define ACPI_SHARED_AND_WAKE (u8) 0x03 /* * DMA Attributes @@ -127,6 +140,8 @@ typedef u32 acpi_rsdesc_size; /* Max Resource Descriptor size is (Length+3) = (6 #define ACPI_POS_DECODE (u8) 0x00 #define ACPI_SUB_DECODE (u8) 0x01 +/* Producer/Consumer */ + #define ACPI_PRODUCER (u8) 0x00 #define ACPI_CONSUMER (u8) 0x01 @@ -192,6 +207,21 @@ struct acpi_resource_fixed_io { u8 address_length; }; +struct acpi_resource_fixed_dma { + u16 request_lines; + u16 channels; + u8 width; +}; + +/* Values for Width field above */ + +#define ACPI_DMA_WIDTH8 0 +#define ACPI_DMA_WIDTH16 1 +#define ACPI_DMA_WIDTH32 2 +#define ACPI_DMA_WIDTH64 3 +#define ACPI_DMA_WIDTH128 4 +#define ACPI_DMA_WIDTH256 5 + struct acpi_resource_vendor { u16 byte_length; u8 byte_data[1]; @@ -329,6 +359,166 @@ struct acpi_resource_generic_register { u64 address; }; +struct acpi_resource_gpio { + u8 revision_id; + u8 connection_type; + u8 producer_consumer; /* For values, see Producer/Consumer above */ + u8 pin_config; + u8 sharable; /* For values, see Interrupt Attributes above */ + u8 io_restriction; + u8 triggering; /* For values, see Interrupt Attributes above */ + u8 polarity; /* For values, see Interrupt Attributes above */ + u16 drive_strength; + u16 debounce_timeout; + u16 pin_table_length; + u16 vendor_length; + struct acpi_resource_source resource_source; + u16 *pin_table; + u8 *vendor_data; +}; + +/* Values for GPIO connection_type field above */ + +#define ACPI_RESOURCE_GPIO_TYPE_INT 0 +#define ACPI_RESOURCE_GPIO_TYPE_IO 1 + +/* Values for pin_config field above */ + +#define ACPI_PIN_CONFIG_DEFAULT 0 +#define ACPI_PIN_CONFIG_PULLUP 1 +#define ACPI_PIN_CONFIG_PULLDOWN 2 +#define ACPI_PIN_CONFIG_NOPULL 3 + +/* Values for io_restriction field above */ + +#define ACPI_IO_RESTRICT_NONE 0 +#define ACPI_IO_RESTRICT_INPUT 1 +#define ACPI_IO_RESTRICT_OUTPUT 2 +#define ACPI_IO_RESTRICT_NONE_PRESERVE 3 + +/* Common structure for I2C, SPI, and UART serial descriptors */ + +#define ACPI_RESOURCE_SERIAL_COMMON \ + u8 revision_id; \ + u8 type; \ + u8 producer_consumer; /* For values, see Producer/Consumer above */\ + u8 slave_mode; \ + u8 type_revision_id; \ + u16 type_data_length; \ + u16 vendor_length; \ + struct acpi_resource_source resource_source; \ + u8 *vendor_data; + +struct acpi_resource_common_serialbus { +ACPI_RESOURCE_SERIAL_COMMON}; + +/* Values for the Type field above */ + +#define ACPI_RESOURCE_SERIAL_TYPE_I2C 1 +#define ACPI_RESOURCE_SERIAL_TYPE_SPI 2 +#define ACPI_RESOURCE_SERIAL_TYPE_UART 3 + +/* Values for slave_mode field above */ + +#define ACPI_CONTROLLER_INITIATED 0 +#define ACPI_DEVICE_INITIATED 1 + +struct acpi_resource_i2c_serialbus { + ACPI_RESOURCE_SERIAL_COMMON u8 access_mode; + u16 slave_address; + u32 connection_speed; +}; + +/* Values for access_mode field above */ + +#define ACPI_I2C_7BIT_MODE 0 +#define ACPI_I2C_10BIT_MODE 1 + +struct acpi_resource_spi_serialbus { + ACPI_RESOURCE_SERIAL_COMMON u8 wire_mode; + u8 device_polarity; + u8 data_bit_length; + u8 clock_phase; + u8 clock_polarity; + u16 device_selection; + u32 connection_speed; +}; + +/* Values for wire_mode field above */ + +#define ACPI_SPI_4WIRE_MODE 0 +#define ACPI_SPI_3WIRE_MODE 1 + +/* Values for device_polarity field above */ + +#define ACPI_SPI_ACTIVE_LOW 0 +#define ACPI_SPI_ACTIVE_HIGH 1 + +/* Values for clock_phase field above */ + +#define ACPI_SPI_FIRST_PHASE 0 +#define ACPI_SPI_SECOND_PHASE 1 + +/* Values for clock_polarity field above */ + +#define ACPI_SPI_START_LOW 0 +#define ACPI_SPI_START_HIGH 1 + +struct acpi_resource_uart_serialbus { + ACPI_RESOURCE_SERIAL_COMMON u8 endian; + u8 data_bits; + u8 stop_bits; + u8 flow_control; + u8 parity; + u8 lines_enabled; + u16 rx_fifo_size; + u16 tx_fifo_size; + u32 default_baud_rate; +}; + +/* Values for Endian field above */ + +#define ACPI_UART_LITTLE_ENDIAN 0 +#define ACPI_UART_BIG_ENDIAN 1 + +/* Values for data_bits field above */ + +#define ACPI_UART_5_DATA_BITS 0 +#define ACPI_UART_6_DATA_BITS 1 +#define ACPI_UART_7_DATA_BITS 2 +#define ACPI_UART_8_DATA_BITS 3 +#define ACPI_UART_9_DATA_BITS 4 + +/* Values for stop_bits field above */ + +#define ACPI_UART_NO_STOP_BITS 0 +#define ACPI_UART_1_STOP_BIT 1 +#define ACPI_UART_1P5_STOP_BITS 2 +#define ACPI_UART_2_STOP_BITS 3 + +/* Values for flow_control field above */ + +#define ACPI_UART_FLOW_CONTROL_NONE 0 +#define ACPI_UART_FLOW_CONTROL_HW 1 +#define ACPI_UART_FLOW_CONTROL_XON_XOFF 2 + +/* Values for Parity field above */ + +#define ACPI_UART_PARITY_NONE 0 +#define ACPI_UART_PARITY_EVEN 1 +#define ACPI_UART_PARITY_ODD 2 +#define ACPI_UART_PARITY_MARK 3 +#define ACPI_UART_PARITY_SPACE 4 + +/* Values for lines_enabled bitfield above */ + +#define ACPI_UART_CARRIER_DETECT (1<<2) +#define ACPI_UART_RING_INDICATOR (1<<3) +#define ACPI_UART_DATA_SET_READY (1<<4) +#define ACPI_UART_DATA_TERMINAL_READY (1<<5) +#define ACPI_UART_CLEAR_TO_SEND (1<<6) +#define ACPI_UART_REQUEST_TO_SEND (1<<7) + /* ACPI_RESOURCE_TYPEs */ #define ACPI_RESOURCE_TYPE_IRQ 0 @@ -348,7 +538,10 @@ struct acpi_resource_generic_register { #define ACPI_RESOURCE_TYPE_EXTENDED_ADDRESS64 14 /* ACPI 3.0 */ #define ACPI_RESOURCE_TYPE_EXTENDED_IRQ 15 #define ACPI_RESOURCE_TYPE_GENERIC_REGISTER 16 -#define ACPI_RESOURCE_TYPE_MAX 16 +#define ACPI_RESOURCE_TYPE_GPIO 17 /* ACPI 5.0 */ +#define ACPI_RESOURCE_TYPE_FIXED_DMA 18 /* ACPI 5.0 */ +#define ACPI_RESOURCE_TYPE_SERIAL_BUS 19 /* ACPI 5.0 */ +#define ACPI_RESOURCE_TYPE_MAX 19 /* Master union for resource descriptors */ @@ -358,6 +551,7 @@ union acpi_resource_data { struct acpi_resource_start_dependent start_dpf; struct acpi_resource_io io; struct acpi_resource_fixed_io fixed_io; + struct acpi_resource_fixed_dma fixed_dma; struct acpi_resource_vendor vendor; struct acpi_resource_vendor_typed vendor_typed; struct acpi_resource_end_tag end_tag; @@ -370,6 +564,11 @@ union acpi_resource_data { struct acpi_resource_extended_address64 ext_address64; struct acpi_resource_extended_irq extended_irq; struct acpi_resource_generic_register generic_reg; + struct acpi_resource_gpio gpio; + struct acpi_resource_i2c_serialbus i2c_serial_bus; + struct acpi_resource_spi_serialbus spi_serial_bus; + struct acpi_resource_uart_serialbus uart_serial_bus; + struct acpi_resource_common_serialbus common_serial_bus; /* Common fields */ |