diff options
Diffstat (limited to 'net/mac80211/rc80211_simple.c')
| -rw-r--r-- | net/mac80211/rc80211_simple.c | 20 |
1 files changed, 13 insertions, 7 deletions
diff --git a/net/mac80211/rc80211_simple.c b/net/mac80211/rc80211_simple.c index 2048cfd1ca70..f6780d63b342 100644 --- a/net/mac80211/rc80211_simple.c +++ b/net/mac80211/rc80211_simple.c @@ -187,9 +187,13 @@ static void rate_control_simple_tx_status(void *priv, struct net_device *dev, } #endif - if (per_failed > local->rate_ctrl_num_down) { + /* + * XXX: Make these configurable once we have an + * interface to the rate control algorithms + */ + if (per_failed > RATE_CONTROL_NUM_DOWN) { rate_control_rate_dec(local, sta); - } else if (per_failed < local->rate_ctrl_num_up) { + } else if (per_failed < RATE_CONTROL_NUM_UP) { rate_control_rate_inc(local, sta); } srctrl->tx_avg_rate_sum += status->control.rate->rate; @@ -283,14 +287,16 @@ static void rate_control_simple_rate_init(void *priv, void *priv_sta, int i; sta->txrate = 0; mode = local->oper_hw_mode; - /* TODO: what is a good starting rate for STA? About middle? Maybe not - * the lowest or the highest rate.. Could consider using RSSI from - * previous packets? Need to have IEEE 802.1X auth succeed immediately - * after assoc.. */ + /* TODO: This routine should consider using RSSI from previous packets + * as we need to have IEEE 802.1X auth succeed immediately after assoc.. + * Until that method is implemented, we will use the lowest supported rate + * as a workaround, */ for (i = 0; i < mode->num_rates; i++) { if ((sta->supp_rates & BIT(i)) && - (mode->rates[i].flags & IEEE80211_RATE_SUPPORTED)) + (mode->rates[i].flags & IEEE80211_RATE_SUPPORTED)) { sta->txrate = i; + break; + } } } |