From 275e4e2dc0411508506acb591a45daf01d22f8eb Mon Sep 17 00:00:00 2001 From: Sean Anderson Date: Mon, 9 Aug 2021 18:38:11 -0400 Subject: dt-bindings: clk: vc5: Add properties for configuring the SD/OE pin These properties allow configuring the SD/OE pin as described in the datasheet. Signed-off-by: Sean Anderson Reviewed-by: Rob Herring Reviewed-by: Luca Ceresoli Link: https://lore.kernel.org/r/20210809223813.3766204-1-sean.anderson@seco.com Signed-off-by: Stephen Boyd --- .../devicetree/bindings/clock/idt,versaclock5.yaml | 40 ++++++++++++++++++++++ 1 file changed, 40 insertions(+) (limited to 'Documentation/devicetree/bindings/clock/idt,versaclock5.yaml') diff --git a/Documentation/devicetree/bindings/clock/idt,versaclock5.yaml b/Documentation/devicetree/bindings/clock/idt,versaclock5.yaml index 26ed040bc717..ffd6ae0eed64 100644 --- a/Documentation/devicetree/bindings/clock/idt,versaclock5.yaml +++ b/Documentation/devicetree/bindings/clock/idt,versaclock5.yaml @@ -30,6 +30,20 @@ description: | 3 -- OUT3 4 -- OUT4 + The idt,shutdown and idt,output-enable-active properties control the + SH (en_global_shutdown) and SP bits of the Primary Source and Shutdown + Register, respectively. Their behavior is summarized by the following + table: + + SH SP Output when the SD/OE pin is Low/High + == == ===================================== + 0 0 Active/Inactive + 0 1 Inactive/Active + 1 0 Active/Shutdown + 1 1 Inactive/Shutdown + + The case where SH and SP are both 1 is likely not very interesting. + maintainers: - Luca Ceresoli @@ -64,6 +78,26 @@ properties: maximum: 22760 description: Optional load capacitor for XTAL1 and XTAL2 + idt,shutdown: + $ref: /schemas/types.yaml#/definitions/uint32 + enum: [0, 1] + description: | + If 1, this enables the shutdown functionality: the chip will be + shut down if the SD/OE pin is driven high. If 0, this disables the + shutdown functionality: the chip will never be shut down based on + the value of the SD/OE pin. This property corresponds to the SH + bit of the Primary Source and Shutdown Register. + + idt,output-enable-active: + $ref: /schemas/types.yaml#/definitions/uint32 + enum: [0, 1] + description: | + If 1, this enables output when the SD/OE pin is high, and disables + output when the SD/OE pin is low. If 0, this disables output when + the SD/OE pin is high, and enables output when the SD/OE pin is + low. This corresponds to the SP bit of the Primary Source and + Shutdown Register. + patternProperties: "^OUT[1-4]$": type: object @@ -90,6 +124,8 @@ required: - compatible - reg - '#clock-cells' + - idt,shutdown + - idt,output-enable-active allOf: - if: @@ -139,6 +175,10 @@ examples: clocks = <&ref25m>; clock-names = "xin"; + /* Set the SD/OE pin's settings */ + idt,shutdown = <0>; + idt,output-enable-active = <0>; + OUT1 { idt,mode = ; idt,voltage-microvolt = <1800000>; -- cgit v1.2.3