From 44e42ae3a398b559c768b9b3c324d72b0b0b4479 Mon Sep 17 00:00:00 2001 From: "Ivan T. Ivanov" Date: Thu, 9 Apr 2015 11:34:33 +0300 Subject: usb: phy: msm: Manual PHY and LINK controller VBUS change notification VBUS is not routed to USB PHY on recent Qualcomm platforms. USB controller must see VBUS in order to pull-up DP when setting RS bit. Henc configure USB PHY and LINK registers sense VBUS and enable manual pullup on D+ line. Cc: Vamsi Krishna Cc: Mayank Rana Signed-off-by: Ivan T. Ivanov Signed-off-by: Felipe Balbi --- Documentation/devicetree/bindings/usb/msm-hsusb.txt | 4 ++++ 1 file changed, 4 insertions(+) (limited to 'Documentation/devicetree/bindings') diff --git a/Documentation/devicetree/bindings/usb/msm-hsusb.txt b/Documentation/devicetree/bindings/usb/msm-hsusb.txt index f26bcfac3d8f..bd8d9e753029 100644 --- a/Documentation/devicetree/bindings/usb/msm-hsusb.txt +++ b/Documentation/devicetree/bindings/usb/msm-hsusb.txt @@ -69,6 +69,10 @@ Optional properties: (no, min, max) where each value represents either a voltage in microvolts or a value corresponding to voltage corner. +- qcom,manual-pullup: If present, vbus is not routed to USB controller/phy + and controller driver therefore enables pull-up explicitly + before starting controller using usbcmd run/stop bit. + - extcon: phandles to external connector devices. First phandle should point to external connector, which provide "USB" cable events, the second should point to external connector -- cgit v1.2.3