From 2ef9481e666b4654159ac9f847e6963809e3c470 Mon Sep 17 00:00:00 2001 From: Jon Mason Date: Mon, 23 Jan 2006 10:58:20 -0600 Subject: [PATCH] powerpc: trivial: modify comments to refer to new location of files This patch removes all self references and fixes references to files in the now defunct arch/ppc64 tree. I think this accomplises everything wanted, though there might be a few references I missed. Signed-off-by: Jon Mason Signed-off-by: Paul Mackerras --- Documentation/powerpc/eeh-pci-error-recovery.txt | 15 ++++++++------- 1 file changed, 8 insertions(+), 7 deletions(-) (limited to 'Documentation/powerpc') diff --git a/Documentation/powerpc/eeh-pci-error-recovery.txt b/Documentation/powerpc/eeh-pci-error-recovery.txt index 67a11a36270c..3764dd4b12cb 100644 --- a/Documentation/powerpc/eeh-pci-error-recovery.txt +++ b/Documentation/powerpc/eeh-pci-error-recovery.txt @@ -121,7 +121,7 @@ accomplished. EEH must be enabled in the PHB's very early during the boot process, and if a PCI slot is hot-plugged. The former is performed by -eeh_init() in arch/ppc64/kernel/eeh.c, and the later by +eeh_init() in arch/powerpc/platforms/pseries/eeh.c, and the later by drivers/pci/hotplug/pSeries_pci.c calling in to the eeh.c code. EEH must be enabled before a PCI scan of the device can proceed. Current Power5 hardware will not work unless EEH is enabled; @@ -133,7 +133,7 @@ error. Given an arbitrary address, the routine pci_get_device_by_addr() will find the pci device associated with that address (if any). -The default include/asm-ppc64/io.h macros readb(), inb(), insb(), +The default include/asm-powerpc/io.h macros readb(), inb(), insb(), etc. include a check to see if the i/o read returned all-0xff's. If so, these make a call to eeh_dn_check_failure(), which in turn asks the firmware if the all-ff's value is the sign of a true EEH @@ -143,11 +143,12 @@ seen in /proc/ppc64/eeh (subject to change). Normally, almost all of these occur during boot, when the PCI bus is scanned, where a large number of 0xff reads are part of the bus scan procedure. -If a frozen slot is detected, code in arch/ppc64/kernel/eeh.c will -print a stack trace to syslog (/var/log/messages). This stack trace -has proven to be very useful to device-driver authors for finding -out at what point the EEH error was detected, as the error itself -usually occurs slightly beforehand. +If a frozen slot is detected, code in +arch/powerpc/platforms/pseries/eeh.c will print a stack trace to +syslog (/var/log/messages). This stack trace has proven to be very +useful to device-driver authors for finding out at what point the EEH +error was detected, as the error itself usually occurs slightly +beforehand. Next, it uses the Linux kernel notifier chain/work queue mechanism to allow any interested parties to find out about the failure. Device -- cgit v1.2.3