From 487e4e08221debb1ccf9cb2c249fac379b74cbb2 Mon Sep 17 00:00:00 2001 From: Rasmus Villemoes Date: Wed, 5 Jun 2019 14:06:43 +0000 Subject: watchdog: introduce CONFIG_WATCHDOG_OPEN_TIMEOUT This allows setting a default value for the watchdog.open_timeout commandline parameter via Kconfig. Some BSPs allow remote updating of the kernel image and root file system, but updating the bootloader requires physical access. Hence, if one has a firmware update that requires relaxing the watchdog.open_timeout a little, the value used must be baked into the kernel image itself and cannot come from the u-boot environment via the kernel command line. Being able to set the initial value in .config doesn't change the fact that the value on the command line, if present, takes precedence, and is of course immensely useful for development purposes while one has console acccess, as well as usable in the cases where one can make a permanent update of the kernel command line. Signed-off-by: Rasmus Villemoes Reviewed-by: Guenter Roeck Signed-off-by: Guenter Roeck Signed-off-by: Wim Van Sebroeck --- Documentation/watchdog/watchdog-parameters.txt | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) (limited to 'Documentation/watchdog') diff --git a/Documentation/watchdog/watchdog-parameters.txt b/Documentation/watchdog/watchdog-parameters.txt index 32d3606caa65..ec919dc895ff 100644 --- a/Documentation/watchdog/watchdog-parameters.txt +++ b/Documentation/watchdog/watchdog-parameters.txt @@ -11,10 +11,10 @@ modules. The watchdog core parameter watchdog.open_timeout is the maximum time, in seconds, for which the watchdog framework will take care of pinging a running hardware watchdog until userspace opens the corresponding -/dev/watchdogN device. A value of 0 (the default) means an infinite -timeout. Setting this to a non-zero value can be useful to ensure that -either userspace comes up properly, or the board gets reset and allows -fallback logic in the bootloader to try something else. +/dev/watchdogN device. A value of 0 means an infinite timeout. Setting +this to a non-zero value can be useful to ensure that either userspace +comes up properly, or the board gets reset and allows fallback logic +in the bootloader to try something else. ------------------------------------------------- -- cgit v1.2.3