From 1004a2977bdc7566bca87c565541c3232ed467c4 Mon Sep 17 00:00:00 2001 From: Boris Brezillon Date: Tue, 30 May 2017 11:20:53 +0200 Subject: ARM: dts: at91: Switch to the new NAND bindings Use the new EBI/NAND bindings to declare NAND chips and remove old NAND nodes along the way. Note that we keep using old bindings in at91rm9200.dtsi because this SoC is not supported by the EBI driver. Signed-off-by: Boris Brezillon Tested-by: Peter Rosin Signed-off-by: Alexandre Belloni --- arch/arm/boot/dts/at91sam9g45.dtsi | 29 +++++++---------------------- 1 file changed, 7 insertions(+), 22 deletions(-) (limited to 'arch/arm/boot/dts/at91sam9g45.dtsi') diff --git a/arch/arm/boot/dts/at91sam9g45.dtsi b/arch/arm/boot/dts/at91sam9g45.dtsi index 392dcfb79b57..a4808c4fbc05 100644 --- a/arch/arm/boot/dts/at91sam9g45.dtsi +++ b/arch/arm/boot/dts/at91sam9g45.dtsi @@ -611,10 +611,14 @@ }; nand { - pinctrl_nand: nand-0 { + pinctrl_nand_rb: nand-rb-0 { atmel,pins = - ; /* PC14 gpio enable pin pull_up */ + ; + }; + + pinctrl_nand_cs: nand-cs-0 { + atmel,pins = + ; }; }; @@ -1288,25 +1292,6 @@ status = "disabled"; }; - nand0: nand@40000000 { - compatible = "atmel,at91rm9200-nand"; - #address-cells = <1>; - #size-cells = <1>; - reg = <0x40000000 0x10000000 - 0xffffe200 0x200 - >; - atmel,nand-addr-offset = <21>; - atmel,nand-cmd-offset = <22>; - atmel,nand-has-dma; - pinctrl-names = "default"; - pinctrl-0 = <&pinctrl_nand>; - gpios = <&pioC 8 GPIO_ACTIVE_HIGH - &pioC 14 GPIO_ACTIVE_HIGH - 0 - >; - status = "disabled"; - }; - usb0: ohci@00700000 { compatible = "atmel,at91rm9200-ohci", "usb-ohci"; reg = <0x00700000 0x100000>; -- cgit v1.2.3