From e9071b0be5e7ce4903b7f7c370769d485774d3e3 Mon Sep 17 00:00:00 2001 From: Donald Dutile Date: Fri, 8 Jun 2012 17:13:11 -0400 Subject: iommu/dmar: Use pr_format() instead of PREFIX to tidy up pr_*() calls Joe Perches recommended getting rid of the redundant formatting of adding "PREFIX" to all the uses of pr_*() calls. The recommendation helps to reduce source and improve readibility. While cleaning up the PREFIX's, I saw that one of the pr_warn() was redundant in dmar_parse_one_dev_scope(), since the same message was printed after breaking out of the while loop for the same condition, !pdev. So, to avoid a duplicate message, I removed the one in the while loop. Reported-by: Joe Perches Signed-off-by: Donald Dutile Cc: iommu@lists.linux-foundation.org Cc: chrisw@redhat.com Cc: suresh.b.siddha@intel.com Cc: dwmw2@infradead.org Link: http://lkml.kernel.org/r/1339189991-13129-1-git-send-email-ddutile@redhat.com [ Small whitespace fixes. ] Signed-off-by: Ingo Molnar --- drivers/iommu/dmar.c | 54 +++++++++++++++++++++++----------------------------- 1 file changed, 24 insertions(+), 30 deletions(-) (limited to 'drivers/iommu') diff --git a/drivers/iommu/dmar.c b/drivers/iommu/dmar.c index 9ab6ebf46f7a..86e2f4a62b9a 100644 --- a/drivers/iommu/dmar.c +++ b/drivers/iommu/dmar.c @@ -26,6 +26,8 @@ * These routines are used by both DMA-remapping and Interrupt-remapping */ +#define pr_fmt(fmt) KBUILD_MODNAME ": " fmt /* has to precede printk.h */ + #include #include #include @@ -39,8 +41,6 @@ #include #include -#define PREFIX "DMAR: " - /* No locks are needed as DMA remapping hardware unit * list is constructed at boot time and hotplug of * these units are not supported by the architecture. @@ -83,15 +83,12 @@ static int __init dmar_parse_one_dev_scope(struct acpi_dmar_device_scope *scope, * ignore it */ if (!bus) { - pr_warn(PREFIX "Device scope bus [%d] not found\n", - scope->bus); + pr_warn("Device scope bus [%d] not found\n", scope->bus); break; } pdev = pci_get_slot(bus, PCI_DEVFN(path->dev, path->fn)); if (!pdev) { - pr_warn(PREFIX "Device scope device" - "[%04x:%02x:%02x.%02x] not found\n", - segment, bus->number, path->dev, path->fn); + /* warning will be printed below */ break; } path ++; @@ -99,8 +96,7 @@ static int __init dmar_parse_one_dev_scope(struct acpi_dmar_device_scope *scope, bus = pdev->subordinate; } if (!pdev) { - pr_warn(PREFIX - "Device scope device [%04x:%02x:%02x.%02x] not found\n", + pr_warn("Device scope device [%04x:%02x:%02x.%02x] not found\n", segment, scope->bus, path->dev, path->fn); *dev = NULL; return 0; @@ -109,8 +105,8 @@ static int __init dmar_parse_one_dev_scope(struct acpi_dmar_device_scope *scope, pdev->subordinate) || (scope->entry_type == \ ACPI_DMAR_SCOPE_TYPE_BRIDGE && !pdev->subordinate)) { pci_dev_put(pdev); - pr_warn(PREFIX "Device scope type does not match for %s\n", - pci_name(pdev)); + pr_warn("Device scope type does not match for %s\n", + pci_name(pdev)); return -EINVAL; } *dev = pdev; @@ -132,7 +128,7 @@ int __init dmar_parse_dev_scope(void *start, void *end, int *cnt, scope->entry_type == ACPI_DMAR_SCOPE_TYPE_BRIDGE) (*cnt)++; else if (scope->entry_type != ACPI_DMAR_SCOPE_TYPE_IOAPIC) { - pr_warn(PREFIX "Unsupported device scope\n"); + pr_warn("Unsupported device scope\n"); } start += scope->length; } @@ -258,23 +254,23 @@ dmar_table_print_dmar_entry(struct acpi_dmar_header *header) case ACPI_DMAR_TYPE_HARDWARE_UNIT: drhd = container_of(header, struct acpi_dmar_hardware_unit, header); - pr_info(PREFIX "DRHD base: %#016Lx flags: %#x\n", + pr_info("DRHD base: %#016Lx flags: %#x\n", (unsigned long long)drhd->address, drhd->flags); break; case ACPI_DMAR_TYPE_RESERVED_MEMORY: rmrr = container_of(header, struct acpi_dmar_reserved_memory, header); - pr_info(PREFIX "RMRR base: %#016Lx end: %#016Lx\n", + pr_info("RMRR base: %#016Lx end: %#016Lx\n", (unsigned long long)rmrr->base_address, (unsigned long long)rmrr->end_address); break; case ACPI_DMAR_TYPE_ATSR: atsr = container_of(header, struct acpi_dmar_atsr, header); - pr_info(PREFIX "ATSR flags: %#x\n", atsr->flags); + pr_info("ATSR flags: %#x\n", atsr->flags); break; case ACPI_DMAR_HARDWARE_AFFINITY: rhsa = container_of(header, struct acpi_dmar_rhsa, header); - pr_info(PREFIX "RHSA base: %#016Lx proximity domain: %#x\n", + pr_info("RHSA base: %#016Lx proximity domain: %#x\n", (unsigned long long)rhsa->base_address, rhsa->proximity_domain); break; @@ -294,7 +290,7 @@ static int __init dmar_table_detect(void) &dmar_tbl_size); if (ACPI_SUCCESS(status) && !dmar_tbl) { - pr_warn(PREFIX "Unable to map DMAR\n"); + pr_warn("Unable to map DMAR\n"); status = AE_NOT_FOUND; } @@ -328,18 +324,18 @@ parse_dmar_table(void) return -ENODEV; if (dmar->width < PAGE_SHIFT - 1) { - pr_warn(PREFIX "Invalid DMAR haw\n"); + pr_warn("Invalid DMAR haw\n"); return -EINVAL; } - pr_info(PREFIX "Host address width %d\n", dmar->width + 1); + pr_info("Host address width %d\n", dmar->width + 1); entry_header = (struct acpi_dmar_header *)(dmar + 1); while (((unsigned long)entry_header) < (((unsigned long)dmar) + dmar_tbl->length)) { /* Avoid looping forever on bad ACPI tables */ if (entry_header->length == 0) { - pr_warn(PREFIX "Invalid 0-length structure\n"); + pr_warn("Invalid 0-length structure\n"); ret = -EINVAL; break; } @@ -362,7 +358,7 @@ parse_dmar_table(void) #endif break; default: - pr_warn(PREFIX "Unknown DMAR structure type %d\n", + pr_warn("Unknown DMAR structure type %d\n", entry_header->type); ret = 0; /* for forward compatibility */ break; @@ -461,12 +457,12 @@ int __init dmar_table_init(void) ret = parse_dmar_table(); if (ret) { if (ret != -ENODEV) - pr_info(PREFIX "parse DMAR table failure.\n"); + pr_info("parse DMAR table failure.\n"); return ret; } if (list_empty(&dmar_drhd_units)) { - pr_info(PREFIX "No DMAR devices found\n"); + pr_info("No DMAR devices found\n"); return -ENODEV; } @@ -498,7 +494,7 @@ int __init check_zero_address(void) (((unsigned long)dmar) + dmar_tbl->length)) { /* Avoid looping forever on bad ACPI tables */ if (entry_header->length == 0) { - pr_warn(PREFIX "Invalid 0-length structure\n"); + pr_warn("Invalid 0-length structure\n"); return 0; } @@ -549,8 +545,7 @@ int __init detect_intel_iommu(void) if (ret && irq_remapping_enabled && cpu_has_x2apic && dmar->flags & 0x1) - pr_info("Queued invalidation will be enabled to " - "support x2apic and Intr-remapping.\n"); + pr_info("Queued invalidation will be enabled to support x2apic and Intr-remapping.\n"); if (ret && !no_iommu && !iommu_detected && !dmar_disabled) { iommu_detected = 1; @@ -580,9 +575,9 @@ static void unmap_iommu(struct intel_iommu *iommu) * map_iommu: map the iommu's registers * @iommu: the iommu to map * @phys_addr: the physical address of the base resgister - * + * * Memory map the iommu's registers. Start w/ a single page, and - * possibly expand if that turns out to be insufficent. + * possibly expand if that turns out to be insufficent. */ static int map_iommu(struct intel_iommu *iommu, u64 phys_addr) { @@ -1302,8 +1297,7 @@ int __init enable_drhd_fault_handling(void) ret = dmar_set_interrupt(iommu); if (ret) { - pr_err("DRHD %Lx: failed to enable fault, " - " interrupt, ret %d\n", + pr_err("DRHD %Lx: failed to enable fault, interrupt, ret %d\n", (unsigned long long)drhd->reg_base_addr, ret); return -1; } -- cgit v1.2.3