From ff75332b260cd33cc19000fdb5d256d9db4470d1 Mon Sep 17 00:00:00 2001 From: Jacopo Mondi Date: Wed, 16 Jun 2021 14:46:10 +0200 Subject: media: i2c: rdacm21: Fix OV10640 powerup The OV10640 image sensor powerdown signal is controlled by the first line of the OV490 GPIO pad #1, but the pad #0 identifier OV490_GPIO_OUTPUT_VALUE0 was erroneously used. As a result the image sensor powerdown signal was never asserted but was left floating and kept high by an internal pull-up resistor, causing sporadic failures during the image sensor startup phase. Fix this by using the correct GPIO pad identifier and wait the mandatory 1.5 millisecond delay after the powerup lane is asserted. The reset delay is not characterized in the chip manual if not as "255 XVCLK + initialization". Wait for at least 3 milliseconds to guarantee the SCCB bus is available. While at it also fix the reset sequence, as the reset line was released before the powerdown one, and the line was not cycled. This commit fixes a sporadic start-up error triggered by a failure to read the OV10640 chip ID: rdacm21 8-0054: OV10640 ID mismatch: (0x01) Fixes: a59f853b3b4b ("media: i2c: Add driver for RDACM21 camera module") Signed-off-by: Jacopo Mondi Reviewed-by: Kieran Bingham Reviewed-by: Laurent Pinchart Signed-off-by: Hans Verkuil Signed-off-by: Mauro Carvalho Chehab --- drivers/media/i2c/rdacm21.c | 10 ++++++++-- 1 file changed, 8 insertions(+), 2 deletions(-) (limited to 'drivers/media/i2c') diff --git a/drivers/media/i2c/rdacm21.c b/drivers/media/i2c/rdacm21.c index 336fd5d482b7..6ab8a894e94b 100644 --- a/drivers/media/i2c/rdacm21.c +++ b/drivers/media/i2c/rdacm21.c @@ -333,13 +333,19 @@ static int ov10640_initialize(struct rdacm21_device *dev) { u8 val; - /* Power-up OV10640 by setting RESETB and PWDNB pins high. */ + /* Enable GPIO0#0 (reset) and GPIO1#0 (pwdn) as output lines. */ ov490_write_reg(dev, OV490_GPIO_SEL0, OV490_GPIO0); ov490_write_reg(dev, OV490_GPIO_SEL1, OV490_SPWDN0); ov490_write_reg(dev, OV490_GPIO_DIRECTION0, OV490_GPIO0); ov490_write_reg(dev, OV490_GPIO_DIRECTION1, OV490_SPWDN0); + + /* Power up OV10640 and then reset it. */ + ov490_write_reg(dev, OV490_GPIO_OUTPUT_VALUE1, OV490_SPWDN0); + usleep_range(1500, 3000); + + ov490_write_reg(dev, OV490_GPIO_OUTPUT_VALUE0, 0x00); + usleep_range(1500, 3000); ov490_write_reg(dev, OV490_GPIO_OUTPUT_VALUE0, OV490_GPIO0); - ov490_write_reg(dev, OV490_GPIO_OUTPUT_VALUE0, OV490_SPWDN0); usleep_range(3000, 5000); /* Read OV10640 ID to test communications. */ -- cgit v1.2.3