From f0bc0c778fe12e43658193fae975fc5762e98773 Mon Sep 17 00:00:00 2001 From: Chuanxiao Dong Date: Wed, 11 Aug 2010 17:14:59 +0800 Subject: nand/denali: change read_status function method In mtd->write, Denali controller will use MODE_11 mode to read NAND flash status, then return back to MODE_1O mode to do page write. Here comes a bug for this kind of using, sometimes controller will not write data to NAND and just return a good interrupt to tell driver writing work is done. The data in this page is all 0xff and this page can not be written again. The reason is unknow. So read Denali controller register WRITE_PROTECT to get NAND status instead. Signed-off-by: Chuanxiao Dong Signed-off-by: David Woodhouse --- drivers/mtd/nand/denali.c | 12 +++++------- 1 file changed, 5 insertions(+), 7 deletions(-) (limited to 'drivers/mtd/nand/denali.c') diff --git a/drivers/mtd/nand/denali.c b/drivers/mtd/nand/denali.c index 3ba89525cf07..975a89351f97 100644 --- a/drivers/mtd/nand/denali.c +++ b/drivers/mtd/nand/denali.c @@ -169,13 +169,11 @@ static void read_status(struct denali_nand_info *denali) /* initialize the data buffer to store status */ reset_buf(denali); - /* initiate a device status read */ - cmd = MODE_11 | BANK(denali->flash_bank); - index_addr(denali, cmd | COMMAND_CYCLE, 0x70); - iowrite32(cmd | STATUS_CYCLE, denali->flash_mem); - - /* update buffer with status value */ - write_byte_to_buf(denali, ioread32(denali->flash_mem + 0x10)); + cmd = ioread32(denali->flash_reg + WRITE_PROTECT); + if (cmd) + write_byte_to_buf(denali, NAND_STATUS_WP); + else + write_byte_to_buf(denali, 0); } /* resets a specific device connected to the core */ -- cgit v1.2.3