From b4e27545224e263d271a9d9aa8763357a7e40eaa Mon Sep 17 00:00:00 2001 From: Guenter Roeck Date: Fri, 6 Feb 2015 12:27:54 -0800 Subject: spi: sc18is602: Support multiple devices on a single I2C bus if DT is configured The driver currently only supports a single device per I2C bus since it uses the I2C bus number to set the SPI bus number. This makes it impossible to connect more than one chip to a single I2C bus. We don't want to use dynamic bus numbers unconditionally since this would result in every instantiation getting a different bus number starting with 65,535 counting down unless devicetree is configured. If devicetree is configured, however, the SPI bus number is obtained from devicetree data. So we can use dynamic SPI bus numbers in this case. Reported-and-Tested-by: Marco Menchise Signed-off-by: Guenter Roeck Signed-off-by: Mark Brown --- drivers/spi/spi-sc18is602.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) (limited to 'drivers/spi/spi-sc18is602.c') diff --git a/drivers/spi/spi-sc18is602.c b/drivers/spi/spi-sc18is602.c index 237f2e7a7179..c04e601152f1 100644 --- a/drivers/spi/spi-sc18is602.c +++ b/drivers/spi/spi-sc18is602.c @@ -290,7 +290,7 @@ static int sc18is602_probe(struct i2c_client *client, hw->freq = SC18IS602_CLOCK; break; } - master->bus_num = client->adapter->nr; + master->bus_num = np ? -1 : client->adapter->nr; master->mode_bits = SPI_CPHA | SPI_CPOL | SPI_LSB_FIRST; master->bits_per_word_mask = SPI_BPW_MASK(8); master->setup = sc18is602_setup; -- cgit v1.2.3