From 8c0b888f6610d0ebbc4bdfb52d2fef9f4a11adfc Mon Sep 17 00:00:00 2001 From: Miquel Raynal Date: Fri, 22 Dec 2017 17:14:11 +0100 Subject: thermal: armada: Change sensors trim default value Errata #132698 highlights an error in the default value of Tc trim. Set this parameter to b'011. Suggested-by: David Sniatkiwicz Signed-off-by: Miquel Raynal Reviewed-by: Gregory CLEMENT Signed-off-by: Eduardo Valentin --- drivers/thermal/armada_thermal.c | 13 +++++++++++++ 1 file changed, 13 insertions(+) (limited to 'drivers/thermal/armada_thermal.c') diff --git a/drivers/thermal/armada_thermal.c b/drivers/thermal/armada_thermal.c index d426b230e1c5..e6025d215cb5 100644 --- a/drivers/thermal/armada_thermal.c +++ b/drivers/thermal/armada_thermal.c @@ -46,6 +46,10 @@ #define CONTROL0_OFFSET 0x0 #define CONTROL1_OFFSET 0x4 +/* Errata fields */ +#define CONTROL0_TSEN_TC_TRIM_MASK 0x7 +#define CONTROL0_TSEN_TC_TRIM_VAL 0x3 + /* TSEN refers to the temperature sensors within the AP */ #define CONTROL0_TSEN_START BIT(0) #define CONTROL0_TSEN_RESET BIT(1) @@ -161,6 +165,15 @@ static void armada380_init_sensor(struct platform_device *pdev, reg &= ~CONTROL1_EXT_TSEN_SW_RESET; writel(reg, priv->control1); msleep(10); + + /* Set Tsen Tc Trim to correct default value (errata #132698) */ + if (priv->control0) { + reg = readl_relaxed(priv->control0); + reg &= ~CONTROL0_TSEN_TC_TRIM_MASK; + reg |= CONTROL0_TSEN_TC_TRIM_VAL; + writel(reg, priv->control0); + msleep(10); + } } static void armada_ap806_init_sensor(struct platform_device *pdev, -- cgit v1.2.3